Selector. All components including selector drive tape, wire or cable, hoist way vanes, magnets, inductors and all other mechanical and electrical drive components. • Motor, and motor generators brush and brush holders. • Hoistway door interlocks or locks and contacts: hoistway door hangers and tracks, bottom door jibs, cams, rollers, and auxiliary door closing devices for power-operated doors. Chains, tracks, cams, interlocks, sheaves for vertical bi- parting doors. All thrust rollers, (Eccentrics) broken arm closer assembly, retiring arm assemblies complete. • Hoistway limit switches, slowdown switches, leveling switches and associated cams and vanes. • Guide shoes including rollers or jib type assemblies complete. • Automatic power operated door operators, door protective devices, car hangers, tracks and car door contacts for both side slide and vertical bi-parting doors, photo eyes. • Traveling cables. • Elevator control wiring in hoist way and machine room. • Governor including governor sheave and shaft assembly bearings, contact jaw and governor tension assemblies. • Car and counterweight safety mechanism and load weighting equipment. • Hoist cables, governor cables, compensating cables and compensating chains, including the adjustment and shorting of same as required by Code. • Buffers, oil or spring type. • Fixture contacts, push buttons, key switches and locks and lamps and sockets of button stations (car and hall), hall lanterns, position indicators (car and hall), direction indicators. • The Contractor shall keep the guide rails free of rust where roller guides are used and properly lubricated when sliding guides are used. Renew guide shoe rollers and jibs as required to insure smooth and satisfactory operation. • The Contractor shall also examine and make necessary adjustment or repair to the following accessory equipment including revamping of signal equipment: hall lanterns car and corridor position indicators, car stations, traffic direction station, electric door operators, intercom system, interlocks, door hangers, safety edges, LED. • All replacement parts shall be new and specifically designed for the elevator on which they are to be used. • The Contractor shall furnish and use lubricants as recommended by the manufacturer of the equipment or approved equal. • The Contractor shall be responsible for keeping the exterior of the elevator, machinery and other parts of the equipment subject to rust, painted with heat resistant enamel and presentable a...
Selector means the Age Group Selection Commission established by Tri NZ.
Selector shall have the meaning set forth in Section 2.1(a)(iv).
Examples of Selector in a sentence
Note: All indigenous tree species must be selected from Council’s Native Plant Selector available on Council’s website.
Street trees must be selected from the Native Plant Selector available on Council’s website.
Exerciser Transfer Selector Switch: Permits selection of exercise with and without load transfer.
The Native Plant Selector is a tool that recommends plants suitable for Sutherland Shire’s ecosystems based on the specific address of the site locality.
Push-Button Stations, Pilot Lights, and Selector Switches: NEMA ICS 2, heavy-duty type.
More Definitions of Selector
Selector means an applicant for, or occupier of, land under Part V., VI., VII., or VIII.
Selector means the person or persons appointed pursuant to By-Law 18(b).
Selector means two-way communication between subscribers, at which only one participant of the selector can transmit voice information at any time. Features of the selector is:
Selector means any selector of «land on deferred payments
Selector. All components including selector drive tape, wire or cable, hoist way vanes, magnets, inductors and all other mechanical and electrical drive components. Motor brushes and brush holders Contractor shall not be responsible for upgrading the equipment to meet changes in code requirements as may be recommended or directed by insurance companies, Federal, State, Municipal or other Governmental authorities. The Contractor shall be responsible for notifying the Agency representative or designated representative, in writing of the existence or development of any defects in or repairs required to, the elevator equipment which he does not consider to be his responsibility under the terms of the contract. The contractor shall furnish the Agency or designated representative with a written estimate of the cost to correct any such defects; and the agency shall make the final determination concerning the responsibility for such defects, corrections or repairs. Any repairs, that are not the Contractor’s responsibility, will be paid at the cost plus the percent mark-up as per “Exhibit B – Price Schedule”. The Contractor will be paid only for repairs actually required whether more or less. Contractor shall be responsible for giving immediate notice to the Agency representative or designated representative of any condition which he discovers that may present a hazard to either the equipment or passengers. Contractor shall not be required by this agreement, except as herein noted to make renewals or repairs necessitated by proven negligence or misuse of the equipment by persons other than the Contractor, his representatives and employees or by reason of any other proven cause except for normal wear and tear, beyond the control of the Contractor. Examples are; refinishing, repairing replacing car enclosures, hoist way, hoist way door panels, frames and xxxxx and all power supply panels and feeders. Cost of repairs, replacements or removal necessitated by any cause, other than ordinary wear and tear, which is occasioned by negligence or abuse shall be determined by the Agency. Any repairs that are not the Contractor’s responsibility will be paid at the labor rates and material costs indicated on “Exhibit B – Price Schedule” RFP Template RFP-22 Rev. 08/09 Prev. Rev. 02/08 Page 24 of 37 Equipment, Wiring and Circuit Changes The Contractor shall not make any changes or alterations to the existing mechanical equipment, circuit wiring or sequencing, nor alter the original circuit ...
Selector and its variations means an information card selector reference implementation that implements ISIPv1.0.
Selector has the meaning ascribed to it in Clause 4.8;