TERMS AND CONDITIONS OF WARRANTY. Eye exams must be performed by a Board Certified Veterinary Ophthalmologist and documents must be supplied to Breeder. Sub-aortic Stenosis must be confirmed by Echocardiography and Doppler and performed by a Board Certified Veterinary Cardiologist and documents must be supplied to Breeder. Hip and/or Elbow Radiographs must be submitted to and examined by the Orthopedic Foundation For Animals and results must be supplied to Breeder. Environmental factors, like high caloric diet during the rapid growth phase, may exacerbate changes in dysplastic hips or elbows. Therefore the Breeder refuses to take responsibility for dysplasia in an overweight puppy and thus Xxxxx will not qualify for a replacement puppy. Veterinarian records must be made available to prove good weight control. No replacement will be given if the puppy has not been examined by 24 months of age. Warranty is NULL AND VOID if the puppy has been bred or this contract has not been followed. Any breach of these contract terms are subject to a $5000 penalty and mandatory return of the puppy. This document represents the entire agreement between the Breeder and the Buyer. No other promises or guarantees are made. The conditions of this agreement may only be changed in writing by mutual consent of both parties. This document shall be enforced only in the State of Ohio, where the transaction has officially taken place. THE BUYER HAS READ AND UNDERSTANDS THE FULL REGISTRATION SALES AGREEMENT IN ITS ENTIRETY AND AGREES THAT ALL PARTS AND PORTIONS THEREOF CONSTITUTE A BINDING AGREEMENT. FURTHER, SIGNATURES BELOW ACKNOWLEDGE AGREEMENT AND RECEIPT OF THIS AGREEMENT BY BOTH PARTIES. BUYER: DATE: BREEDER: _
TERMS AND CONDITIONS OF WARRANTY. LIMITED TWO (2)
TERMS AND CONDITIONS OF WARRANTY. Warranty period is based on normal use for a typical high school or college facility for use over a 25-year period. Systems exceeding this usage fall outside the normal warranty period and will be covered at Qualite’s discretion or repaired based on current labor, equipment and mobilization cost.
TERMS AND CONDITIONS OF WARRANTY. <Company Name> (“Seller”) is providing this additional warranty to the original purchaser of artificial grass from Seller (the “Original Purchaser”) that such artificial grass (the “Material”) is guaranteed against manufacturing defects, ultra violet degradation and excessive fading for an additional eight (8) year period by Seller in addition to the manufacturer’s warranty of eight (8) years, for a total combined manufacturer and Seller Warranty period of sixteen (16) years from the date of shipment of Material to the Original Purchaser. This Limited 16 Year Residual Warranty (the “Warranty”) supplements the limited eight (8) year standard warranty provided by the manufacturer of the Material (the “Manufacturer’s Warranty”) and will only become effective on the first (1st) day of the ninth (9th) year after the date of shipment of Material to the Original Purchaser. This Warranty extends only to the Original Purchaser and does not extend to any contractor, retailer, installer or subsequent purchaser. This Warranty is to be prorated as follows:
TERMS AND CONDITIONS OF WARRANTY. XX Xxxxx (UK) Limited (the “Company”) warrants that all Goods sold in the United Kingdom shall be free from defects in materials and workmanship for a period of 12 months from the earlier of (i) the date of collection or delivery of the Goods or (ii) 1 week after the vehicle has been invoiced, where “
TERMS AND CONDITIONS OF WARRANTY. SEW EURODRIVE ARGENTINA SA guarantees the Buyer that the product to which this guarantee refers will be free of manufacturing and workmanship defects for 12 months, counting from the date of purchase of the product by the user. The warranty service covers only those defects that arise as a result of normal use of the product and not for those that result from:
TERMS AND CONDITIONS OF WARRANTY. Rollease Acmeda provides a Warranty for the Products and the Components purchased by the Customer for external applications intended to be acquired for the purpose of re-supply, or using or transforming them in trade or commerce in the course of production or manufacture or repairing or treating other goods or fixtures on land. PRODUCTS The products (components and hardware) subject to this Warranty are: S100 EXTREME WIRE GUIDE SYSTEM The Products and the Components are covered for defect in materials, workmanship or failure to operate. To make a claim under this Warranty, the Customer must notify Rollease Acmeda in writing of their claim and provide sufficient information to enable Rollease Acmeda to identify the issue, together with proof of purchase. The Customer must return the Products and/or Components to Rollease Acmeda for assessment. Subject to the Australian Consumer Law contained in the Competition and Consumer Act 2010 (“ACL”), Rollease Acmeda will, at its discretion, repair or replace any Products or Components assessed to be defective. The cost of removal and reinstallation shall be borne by the Customer. This Warranty does not cover: • Abuse to the Products or Components such as alterations, accidents, misuse. • Installation, use, maintenance or modifications outside of the Product or Components specifications. • Fair and reasonable wear and tear. • Damage resulting from accidents or the negligence of the Customer or any third party. • Damage resulting from the alteration of preset operating parameters caused by acts of nature, accidents, negligence, improper installation or otherwise. • Deterioration of finished surfaces due to exposure to ocean salt spray (except as set out below) or other corrosive atmosphere including hazardous industrial processes; • Labour, access, third party or electrical costs borne by the Customer to complete repairs, maintenance or replacement of components that make up the Product supplied by Rollease Acmeda; • Any component added to the Product that was not supplied by Rollease Acmeda including motorisation componentry or any damage to the Product caused thereby. This warranty covers the deterioration of finished surfaces due to exposure to ocean salt spray, only if: • the Product is installed in an area rated C1 (very low risk of corrosion), C2 (low risk of corrosion) or C3 (medium risk of corrosion) as defined in ISO 9223:2012 (“Corrosion of metals and alloys – Corrosivity of atmospheres – Classification, dete...
TERMS AND CONDITIONS OF WARRANTY. 1. The warranty is made to the original owner only and is non-transferrable. It is only effective with a valid proof of purchase consisting of the original purchase document or receipt indicating the date of purchase, the serial number, the dealer's name (if applicable), and the designation of the model. GenZe reserves the right to reject the coverage of this warranty if the accompanying documentation of GenZe components is not accurate or complete.
TERMS AND CONDITIONS OF WARRANTY. FURUNO guarantees that each new Furuno product is the result of excellent materials and workmanship. The warranty is valid for a period of 2 years (24 months) from the date of commissioning by an authorized Furuno dealer.
TERMS AND CONDITIONS OF WARRANTY. (a) The Seller warrants that the Products are free from defects and comply with the technical specifications testified by the same.
