Uninterruptible Power Supply Sample Clauses

Uninterruptible Power Supply. The Facility shall include one primary UPS system for the major plant control system. The UPS system shall be supplied with 30% spare capacity above calculated requirements. The output rating of the UPS system(s) shall be 120 V, single‑phase, 0.8 lagging PF to 1.0 PF, at 40°C ambient. UPS will be a true AC-DC-AC conversion type consisting of an inverter, with an alternate DC source supplied from the station service batteries, a rectifier and a static transfer switch. The static transfer switch will be connected to a second inverter as the alternate supply. Output of the UPS and the second inverter will connect to a manual maintenance bypass switch to the instrument AC panelboard.
Sample 1Sample 2
AutoNDA by SimpleDocs
Uninterruptible Power Supply. An online uninterruptible power supply (UPS) shall be required and it shall have adequate capacity to ensure that the protection, measurement and control operate without interruption for a minimum duration of at least 3 hours after loss of power supply. Facility Owner shall submit the calculations in the determination of the sizing of the UPS. In the event of loss of the secured auxiliary supply, all the Facility Owner’s 22 kV Circuit Breakers shall be tripped until remedial actions are taken. The UPS system shall be installed on the Facility Owner side of the Interconnection Boundary and be maintained accordingly by Facility Owner. The UPS shall be equipped with a bypass switch/system that shall allow continuous operation during maintenance on the UPS. A separate UPS, than the one stated in the previous paragraph, shall be installed for all equipment used for the transmission of signals and commands (PLC, modem, router, etc.) between the Facilty and the CEB’s Substation. All associated requirements mentioned in the previous paragraph of this section shall be applicable to this separate UPS.
Sample 1
Uninterruptible Power Supply. Customer shall provide a form of uninterruptible power for the fiber termination hardware and any Hunter facilities or equipment at the Customers location. If the Customer does not provide a uninterruptible power source, Hunter will provide one for the price listed below. APC Uninterruptible Power Supply: $200.00 (one needed for each location)
Sample 1
Uninterruptible Power Supply. American Power Conversion Corporation Back-UPS BE750G or Cyberpower OR750PFCLCD or equivalent (minimum 5 receptacles).
Sample 1
Uninterruptible Power Supply. American Power Conversion Corporation Back-UPS ES 750 or Newpoint 750 VA Battery Backup or Equivalent (minimum 5 receptacles).
Sample 1
Uninterruptible Power Supply. Customer shall provide a form of uninterruptible power for the fiber termination hardware and any Hunter facilities or equipment at the Customers location. If the Customer does not provide an uninterruptible power source, Hunter may choose to install one, at Hunter’s discretion, and reserves the right to invoice customer for costs.
Sample 1
Uninterruptible Power Supply. EDS shall not be liable for any failure or delay in the performance of its obligations under this Agreement if and to the extent such failure or delay is caused by a failure of the uninterruptible power supply existing at the Golden Data Center as of the Commencement Date, provided that EDS has taken reasonable steps to maintain such uninterruptible power supply. Coors acknowledges that EDS does not have an obligation to upgrade such uninterruptible power supply.
Sample 1
AutoNDA by SimpleDocs
Uninterruptible Power Supply. The UPS shall be used to operate control system components including, PC's, and operator interfaces. The UPS shall have sufficient capacity, including 20% reserve capacity, to supply the control system and all other connected loads under worst case operating conditions, and for up to one hour without an AC power source, or to safety shut down the plant, whichever is the longer. An external manual bypass shall be provided to enable the UPS to be removed for repair.
Sample 1

Related to Uninterruptible Power Supply

  • Delivery Point (a) All Energy shall be Delivered hereunder by Seller to Buyer at the Delivery Point. Seller shall be responsible for the costs of delivering its Energy to the Delivery Point consistent with all standards and requirements set forth by the FERC, ISO-NE, the Interconnecting Utility and any other applicable Governmental Entity and any applicable tariff.

  • Delivery Points ‌ Project water made available to the Agency pursuant to Article 6 shall be delivered to the Agency by the State at the delivery structures established in accordance with Article 10.

  • Plant The expression ‘Plant’ as used in the tender papers shall mean every temporary accessory necessary or considered necessary by the Engineer to execute, construct, complete and maintain the work and all altered, modified, substituted and additional works ordered in the time and the manner herein provided and all temporary materials and special and other articles and appliance of every sort kind and description whatsoever intended or used therefore.

  • Third Party Contractors Tenant shall obtain and deliver to Landlord, Third Party Contractor’s certificates of insurance and applicable endorsements at least seven (7) business days prior to the commencement of work in or about the Premises by any vendor or any other third-party contractor (collectively, a “Third Party Contractor”). All such insurance shall (a) name Landlord as an additional insured under such party’s liability policies as required by Section 10.3.1 above and this Section 10.6, (b) provide a waiver of subrogation in favor of Landlord under such Third Party Contractor’s commercial general liability insurance, (c) be primary and any insurance carried by Landlord shall be excess and non-contributing, and (d) comply with Landlord’s minimum insurance requirements.

  • Transponders will be assigned to each covert vehicle and are to be stored in the glove compartment, console or other secure place within the assigned vehicle when not in use.

  • Fuel 28.1 The Vehicle must be returned with the amount of fuel equal to that at the time of the commencement of the rental. If the Vehicle is returned with less fuel, the difference will be charged to You at a rate of $5.00 including GST per litre (which includes a service component).

  • Supply Agreements For a period of three years from the consummation of the IPO, Odetics shall not unilaterally terminate or assign its guarantee obligation with respect to any supply agreement pursuant to which it has guaranteed the performance by ATL of ATL's obligations, unless such suppliers have consented to the termination or assignment of such guarantee.

  • Supply of Products During the term of this Agreement and any extension hereof, the Seller shall sell and supply the products as set out in Schedule 1 hereto (“Products”) to SiPM and SiPM shall buy from the Seller such Products on a non-exclusive basis. The specifications of the Products are set out in Schedule 2 hereto. SUPPLY AGREEMENT - SiPM A Supply Agreement is a document between two parties, a Supplier and a Purchaser. The Supplier can be an individual or business and is the party that " supplies," or sells, the goods to the Purchaser. The Purchaser can also be an individual or a business and is the party that purchases for its use the goods that the Supplier provides.

  • Limited Capacity of Escrow Agent This Agreement expressly and exclusively sets forth the duties of Escrow Agent with respect to any and all matters pertinent hereto, and no implied duties or obligations shall be read into this Agreement against Escrow Agent. Escrow Agent acts hereunder as an escrow agent only and is not associated, affiliated, or involved in the business decisions or business activities of Issuer, portal, or Subscriber. Escrow Agent is not responsible or liable in any manner whatsoever for the sufficiency, correctness, genuineness, or validity of the subject matter of this Agreement or any part thereof, or for the form of execution thereof, or for the identity or authority of any person executing or depositing such subject matter. Escrow Agent shall be under no duty to investigate or inquire as to the validity or accuracy of any document, agreement, instruction, or request furnished to it hereunder, including, without limitation, the authority or the identity of any signer thereof, believed by it to be genuine, and Escrow Agent may rely and act upon, and shall not be liable for acting or not acting upon, any such document, agreement, instruction, or request. Escrow Agent shall in no way be responsible for notifying, nor shall it be responsible to notify, any party thereto or any other party interested in this Agreement of any payment required or maturity occurring under this Agreement or under the terms of any instrument deposited herewith. Escrow Agent’s entire liability, and Broker and Issuer’s exclusive remedy, in any cause of action based on contract, tort, or otherwise in connection with any services furnished pursuant to this Agreement shall be limited to the total fees paid to Escrow Agent by Issuer. The Escrow Agent shall not be called upon to advise any party as to the wisdom in selling or retaining or taking or refraining from any action with respect to any securities or other property deposited hereunder. Escrow Agent may consult legal counsel selected by it in the event of any dispute or question as to the construction of any of the provisions hereof or of any other agreement or of its duties hereunder, or relating to any dispute involving any party hereto, and shall incur no liability and shall be fully indemnified from any reasonable liability whatsoever in acting in accordance with the opinion or instruction of such counsel. Issuer shall promptly pay, upon demand, the reasonable fees and expenses of any such counsel.

  • Delivery Pressure Xxxxxx agrees to use due care and diligence to furnish gas hereunder at such uniform pressure as Seller may elect up to, but not exceeding 20 pounds per square inch gauge, and not less than 5 pounds per square inch gauge, at the "Point of Delivery". Buyer shall be responsible for the installation and operation of adequate safety equipment downstream of the Point of Delivery so as to relieve or control pressure variations within the limits described above that may, for any reason through malfunction of Seller's equipment or otherwise, occur on Buyer's side of the "Delivery Point".

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!