Pump Facilities Sample Clauses

Pump Facilities. Pump facilities are typically electric pump installations. Pumps are mounted on permanent structures with a suction pipe extending into the drainage ditch. Pumps are typically set to function on a remotely activated basis dependant upon water level in the ditch. Typical maintenance includes routine mechanical servicing of a pump and its electrical connections, as well as removal of any accumulated debris that may prevent or interfere with normal operation.
Sample 1Sample 2Sample 3See All (5)
AutoNDA by SimpleDocs
Pump Facilities. Pumping facilities are essential to many water systems and especially those with large distribution systems. They provide the means for moving water from one section of the distribution system to another via storage tanks. Without pumping facilities to maintain adequate tank levels, water quality could become compromised if pressures fluctuate radically or drop below 20 psi. Evaluation will include pump facility capacity (with largest pump out of service), condition, chemical addition (if any), and security. MONITORING/REPORTING/DATA VERIFICATION: Quality control is important in any industry that produces a product. A water system’s product is potable water. Improperly treated water can directly impact public health, so it is vital that a water system closely monitor its water quality. To ensure that the system is supplying water that meets or exceeds standards, the inspector will review all records submitted to the Department, all chemical monitoring within the past several years, verify that correct water quality data is being submitted to the Department (comparison of monthly reports with daily logs), and ensure that continued on page 25 What is a Sanitary Survey? - continued from page 24 correct testing procedures are being followed by the system’s certified operator. SYSTEM MANAGEMENT/OPERATION Water system management has a major effect on water system performance. Management provides direction for the system, sets specific quality goals and ensures adequate funding and support is available to enable the system to provide safe, reliable drinking water. This element focuses on water system management and operation. The inspector will review system funding, goals set by management, staffing requirements/staffing needs, O&M documents and SOP’s to be used by system operators. OPERATOR CERTIFICATION As applicable to the PWS classification of your water system, the inspector will determine if the system has a certified operator to run the water system. Are enough operators available and do they have the proper operator classification for the type of system you operate? These eight elements, when combined, form the basis of the Sanitary Survey. When the Sanitary Survey is completed the system will be provided with a letter which details the results of the Sanitary Survey listing deficiencies and recommendations. If necessary, the inspector may schedule a follow-up visit to ensure that the system is properly correcting the deficiencies. To learn about perform...
Sample 1

Related to Pump Facilities

  • Toilet Facilities The Employer provides the Contractor access to toilet facilities. Temporary chemical toilets are provided by the Contractor where deemed necessary.

  • New Facilities For all new Generating Facilities to be interconnected pursuant to the Tariff, other than wind- powered and other non-synchronous generation facilities, the Generation Interconnection Customer shall design its Customer Facility to maintain a composite power delivery at continuous rated power output at a power factor of at least 0.95 leading to 0.90 lagging. For all new wind- powered and other non-synchronous generation facilities the Generation Interconnection Customer shall design its Customer Facility with the ability to maintain a composite power delivery at a power factor of at least 0.95 leading to 0.95 lagging across the full range of continuous rated power output. For all wind-powered and other non-synchronous generation facilities entering the New Service Queue on or after November 1, 2016, the power factor requirement shall be measured at the high-side of the facility substation transformers. This power factor range standard shall be dynamic and can be met using, for example, power electronics designed to supply this level of reactive capability (taking into account any limitations due to voltage level, real power output, etc.) or fixed and switched capacitors, or a combination of the two. For all wind-powered and other non-synchronous generation facilities entering the New Service Queue on or after May 1, 2015, and before November 1, 2016, the power factor requirement shall be measured at the generator’s terminals. For new generation resources of more than 20 MW, other than wind- powered and other non-synchronous Generating Facilities, the power factor requirement shall be measured at the generator’s terminals. For new generation resources of 20 MW or less, and all wind-powered and other non-synchronous generation facilities entering the New Service Queue prior to May 1, 2015, the power factor requirement shall be measured at the Point of Interconnection. Any different reactive power design criteria that Transmission Provider determines to be appropriate for a wind-powered or other non-synchronous generation facility shall be stated in the Interconnection Service Agreement. A Transmission Interconnection Customer interconnecting Merchant D.C. Transmission Facilities and/ or Controllable A.C. Merchant Transmission Facilities shall design its Customer Facility to maintain a power factor at the Point of Interconnection of at least 0.95 leading and 0.95 lagging, when the Customer Facility is operating at any level within its approved operating range.

  • Existing Facilities Each of the Existing Facilities shall be repaid in full and terminated and all collateral security therefor shall be released, and the Administrative Agent shall have received pay-off letters in form and substance satisfactory to it evidencing such repayment, termination and release.

  • PUBLIC FACILITIES Supplier’s employees may be required to perform work at government- owned facilities, including schools. Supplier’s employees and agents must conduct themselves in a professional manner while on the premises, and in accordance with Participating Entity policies and procedures, and all applicable laws.

  • Generating Facility The Interconnection Customer’s device for the production of electricity identified in the Interconnection Request, but shall not include the Interconnection Customer’s Interconnection Facilities.

  • Interconnection Facilities 4.1.1 The Interconnection Customer shall pay for the cost of the Interconnection Facilities itemized in Attachment 2 of this Agreement. The NYISO, in consultation with the Connecting Transmission Owner, shall provide a best estimate cost, including overheads, for the purchase and construction of its Interconnection Facilities and provide a detailed itemization of such costs. Costs associated with Interconnection Facilities may be shared with other entities that may benefit from such facilities by agreement of the Interconnection Customer, such other entities, the NYISO, and the Connecting Transmission Owner.

  • Laundry Facilities SF State University assumes no responsibility in the use of laundry equipment or for lost items.

  • Facilities Keep all properties useful or necessary to Borrower's business in good repair and condition, and from time to time make necessary repairs, renewals and replacements thereto so that such properties shall be fully and efficiently preserved and maintained.

  • Verizon OSS Facilities Any gateways, interfaces, databases, facilities, equipment, software, or systems, used by Verizon to provide Verizon OSS Services to CBB.

  • Common Facilities Common Facilities shall mean the non-assigned parking areas; lobby; elevator(s); fire stairs; public hallways; public lavatories; all other general Building facilities that service all Building tenants; air conditioning rooms; fan rooms; janitors' closets; electrical closets; telephone closets; elevator shafts and machine rooms; flues; stacks; pipe shafts and vertical ducts with their enclosing walls. Lessor may at any time close temporarily any Common Facilities to make repairs or changes therein or to effect construction, repairs or changes within the Building, or to discourage non-tenant parking, and may do such other acts in and to the Common Facilities as in its judgement may be desirable to improve the convenience thereof, but shall always in connection therewith, endeavor to minimize any inconvenience to Lessee.

Time is Money Join Law Insider Premium to draft better contracts faster.