Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request. In addition to the requirements set forth in any applicable Business Associate Agreement as may be attached to this Contract, in the event of any actual security breach or reasonable belief of an actual security breach the Contractor either suffers or learns of that either compromises or could compromise State Data (a “Security Breach”), the Contractor shall notify the State within 24 hours of its discovery. Contractor shall immediately determine the nature and extent of the Security Breach, contain the incident by stopping the unauthorized practice, recover records, shut down the system that was breached, revoke access and/or correct weaknesses in physical security. Contractor shall report to the State: (i) the nature of the Security Breach; (ii) the State Data used or disclosed; (iii) who made the unauthorized use or received the unauthorized disclosure; (iv) what the Contractor has done or shall do to mitigate any deleterious effect of the unauthorized use or disclosure; and (v) what corrective action the Contractor has taken or shall take to prevent future similar unauthorized use or disclosure. The Contractor shall provide such other information, including a written report, as reasonably requested by the State. Contractor shall analyze and document the incident and provide all notices required by applicable law. In accordance with Section 9 V.S.A. §2435(b)(3), the Contractor shall notify the Office of the Attorney General, or, if applicable, Vermont Department of Financial Regulation (“DFR”), within fourteen (14) business days of the Contractor’s discovery of the Security Breach. The notice shall provide a preliminary description of the breach. The foregoing notice requirement shall be included in the subcontracts of any of Contractor’s subcontractors, affiliates or agents which may be “data collectors” hereunder. The Contractor agrees to fully cooperate with the State and assume responsibility at its own expense for the following, to be determined in the sole discretion of the State: (i) notice to affected consumers if the State determines it to be appropriate under the circumstances of any particular Security Breach, in a form recommended by the AGO; and (ii) investigation and remediation associated with a Security Breach, including but not limited to, outside investi...
Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request. In addition to the requirements set forth in any applicable Business Associate Agreement as may be attached to this Contract, in the event of any actual security breach or reasonable belief of an actual security breach the Contractor either suffers or learns of that either compromises or could compromise State Data (a “Security Breach”), the Contractor shall notify the State within 24 hours of its discovery. Contractor shall immediately determine the nature and extent of the Security Breach, contain the incident by stopping the unauthorized practice, recover records, shut down the system that was breached, revoke access and/or correct weaknesses in physical security. Contractor shall report to the State:
Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request. In the event of any actual security breach or reasonable belief of an actual security breach the Contractor either suffers or learns of that either compromises or could compromise State Data (a “Security Breach”), the Contractor shall notify the State within 24 hours of its discovery. Contractor shall immediately determine the nature and extent of the Security Breach, contain the incident by stopping the unauthorized practice, recover records, shut down the system that was breached, revoke access and/or correct weaknesses in physical security. Contractor shall report to the State: (i) the nature of the Security Breach; (ii) the State Data used or disclosed;
Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request.
