Personal Protective. Clothing It is understood that the point distribution system does not include personal protective clothing, which will be supplied by the Employer.
Personal Protective. EQUIPMENT (PPE)
Personal Protective. Equipment (PPE) requirements including all effects on cost or production due to the requirement to use PPE;
Personal Protective. 7.12 Where employees are required to wear Employer approved safety footwear they will be provided with reimbursement of up to one hundred and sixty ($160.00) dollars per calendar year upon provision of a receipt..
Personal Protective. Equipment (PPE) will be readily available to any unit member working on campus. This includes disposable face masks, gloves, and hand sanitizer. Unit members are free to bring their own face masks from home as long as they provide adequate coverage of the nose and mouth. Unit members who wish to use face xxxxxxx shall be provided such on request. A ready supply of PPE will be maintained by BCCHS for use by unit members, even during non-pandemic situations.
Personal Protective. EQUIPMENT (“PPE”) or Essential Protective Equipment (EPE) as determined by the Marin County Public Health Officer.
Personal Protective. Occupational Health and Safety Services, in conjunction with the Hospital management, shall identify and assess physical, chemical or biological hazards in the workplace. This hazard assessment shall be used to determine the type of including such devices as eye, face, hand and foot protection, required to protect employees and prevent workplace injuries and illnesses. The Hospital shall provide to employees as required and will determine selection based on workplace hazard assessments, workplace factors and legislative requirements.
Personal Protective equipment shall at all times be fully functional and in a condition acceptable to the Buyer’s safety personnel when on the Buyer’s site.
Personal Protective. Equipment (PPE). Contractor shall be responsible for ensuring all personnel arrive at the incident with the proper Personal Protective Equipment as prescribed in the agreement. Contractor shall be responsible for ensuring the PPE is operable and maintained in good repair throughout the duration of any assignment. Personal Protective Clothing will be maintained in good repair, and be cleaned at sufficient intervals to preclude unsafe working conditions. Contractor shall be responsible for ensuring that all personnel arrive with the following PPE:
Personal Protective. EQUIPMENT -In most circumstances, PPE should not be relied on to control risk. It should be used only as a last resort when all other reasonably practicable control measures have been used and the risk has not been eliminated, or as interim protection until higher level controls are implemented. There may also be situations when the use of other controls is not practicable. For electroplating PPE may include: eye protection gloves face splash protection waterproof apron waterproof footwear respirator with suitable filters. WORKPLACE FACILITIES - An electrochemical workplace should provide a clean hand washing station and an area for the changing of contaminated clothing to ensure hazardous chemicals are not spread through the workplace or out into the community. A clean eating area separate from the work area should be provided. Electrical Hazards – Electrochemical processes involve a combination of conductive solutions and live electrical currents. Common hazards in electroplating workplaces include exposed live conductors, damaged insulation, broken sockets, corrosion of system parts, and heaters not earthed. In order to avoid electrical hazards proper care must be taken for providing safe and suitable electrical equipment for example not using leads and tools in damp or wet conditions unless they are specially designed for those conditions, providing enough socket outlets—overloading socket outlets by using adaptors can cause fires, ensuring power circuits are protected by the appropriate rated fuse or circuit breaker to prevent overloading, arranging electrical leads so they will not be damaged, the regular inspection and testing of electrical equipment. So far as is reasonably practicable, prevent unauthorised alterations to or interference with the plant and take all reasonable steps to ensure the plant is only used for the purpose for which it is designed, unless a competent person has assessed that the proposed use does not increase the risk to health and safety, and ensure all safety features, warning devices, guarding, operational controls, emergency stops are used in accordance with instructions and information provided. Plant used in environments where the atmosphere is acidic is at an increased risk of corrosion damage. Regular inspection and maintenance should be conducted, especially for lifting equipment such as cranes, hoists, chains and hooks. PROCESS INFORMATION DETAILS Process ID 1 ANODIZING OF ALUMINUM ALLOYS Alloys AA – 6061 Type II A...
