Mechanical Inspection. SELLER agrees that all appliances, all plumbing systems including septic tank, if any, sewer and water lines, electrical system, heating system (including gas lines, if any), central air conditioning system, if any, and all other mechanical equipment sold with the Property, shall be in normal operating condition at the time of closing. SELLER agrees to give BUYER reasonable access to the Property to inspect mechanical equipment. BUYER agrees to pay for these inspection(s). BUYER agrees to deliver to SELLER or the Listing Agent, no later than the seventh (7th) day before the Closing Date, a written statement of all mechanical equipment that BUYER reasonably deems not to be in normal operating condition. SELLER agrees to make or pay for repairs of mechanical equipment, that a competent professional would reasonably determine to be necessary to put such equipment in normal operating condition in an amount not exceeding the amount stated in Paragraph 6 of this Contract. SELLER agrees that all such repairs shall be made in a workmanlike manner with good quality materials. If the cost of repairs exceeds the amount specified in Paragraph 6, SELLER, BUYER or both may pay any portion of the excess amount. If SELLER and BUYER cannot agree upon payment of the excess amount or disposition of the repairs, this Contract shall be canceled. If SELLER or the Listing Agent does not receive a written statement from BUYER as provided in this paragraph, or if SELLER completes repairs as agreed in this paragraph, the parties agree that SELLER’S repair obligations under this paragraph will be satisfied. SELLER agrees to give BUYER reasonable access to the Property before the Closing Date so that BUYER or BUYER’S representatives may, at BUYER’S expense, re-inspect mechanical equipment or inspect any repairs made pursuant to this paragraph.
Mechanical Inspection. BUYER may conduct an inspection of mechanical items and SELLER agrees to make or pay for repairs not exceeding $ ($0.00 if left blank) as provided in Standard Terms, Paragraph E.
Mechanical Inspection. Annual; Inspect PV module surfaces, frames, racking system (including tilts, windscreens, ballasts and penetrations), inspect all visible wiring, open every combiner box and pull box for inspection (roof only), perform minor adjustments as needed.
Mechanical Inspection. 25 Oil Tank Inspection ............................................ ................................ ........................ ......................... 26 Pool/Spa Inspection ............................................ ................................ ........................ ......................... 27 Roof Inspection................................................... ................................ ........................ ......................... 28 Septic Inspection (requires pumping) ................. ................................ ........................ ......................... 29 Septic Lid Removal ............................................ ................................ ........................ ......................... 30 Septic Pumping................................................... ................................ ........................ ......................... 31 Soils Inspection................................................... ................................ ........................ .........................
Mechanical Inspection. 1) Inspect for proper mechanical operation.
Mechanical Inspection. The above-mentioned vehicle MUST be inspected by a vendor approved by the local FAIM participating agency. The local FAIM agency and/or FAIM Administration reserves the right to cancel the sale based on the inspection. Title Transfer: Before releasing the FAIM check, the buyer, seller, and local FAIM coach are required to meet at the Department of Motor Vehicles to ensure there is no lien and the title is properly transferred.
Mechanical Inspection. 1. Agreement Buyer agrees to purchase and Seller agrees to sell, all right, title and interest to the Vessel on the terms and conditions as set forth herein (the “Agreement). Capitalized words herein refer to the items in the chart above unless otherwise defined herein. Listing Broker and Selling Broker shall be referred to herein as “Brokers.” If there is a Trade Allowance, the terms and conditions of the trade-in will be governed by a Trade-In Vessel Addendum.
Mechanical Inspection. The Tests on Take Over shall be completed by a mechanical inspection of the Facility. If major shortcomings are found, necessitating extensive repairs (eg refractory) or indicating a recurring problem (eg excessive fouling), ProjectCo shall undertake remedial action(s) and demonstrate that the Defect(s) is (are) removed by a test programme to be presented to and approved by the Department’s Representative.
Mechanical Inspection. All relays are to be examined to ensure that they are in proper working condition and correctly adjusted, correctly labelled and that the relay case, cover, glass and gaskets are in good order and properly fitting.
Mechanical Inspection. This instrument was carefully inspected before shipment. Upon receipt inspect the instrument for damage that might have occurred in transit. If there is damage due to shipping, file a claim with the carrier who transported the unit. The shipping and packing material should be saved if reshipment is required. If the original container is not to be used, then use a heavy carton box. Wrap the unit with plastic and place cardboard strips across the face for protection. Use packing material around all sides of the container and seal it with tape bands. Mark the box "FRAGILE".
