Flowcharts. Figure 1 Determination of the range of background noise Figure 2 Vehicle A-Weighted sound pressure level measurement correction criteria * * Former titles of the Agreement: Agreement concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958 (original version); Agreement concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Equipment and Parts which can be Fitted and/or be Used on Wheeled Vehicles and the Conditions for Reciprocal Recognition of Approvals Granted on the Basis of these Prescriptions, done at Geneva on 5 October 1995 (Revision 2). 1 As defined in the Consolidated Resolution on the Construction of Vehicles (R.E.3.), document ECE/TRANS/WP.29/78/Rev.6, para. 2 - xxx.xxxxx.xxx/xxxxx/xxxx/xx00/xx00xxx/xx00xxx/xx00xxxxxxxxxxx.xxxx 2 The “Low level” mode would provide the driver the tool to avoid complaints in quiet situations that otherwise could result from the “Normal level” mode. 3 The distinguishing numbers of the Contracting Parties to the 1958 Agreement are reproduced in Annex 3 to the Consolidated Resolution on the Construction of Vehicles (R.E.3), document ECE/TRANS/WP.29/78/Rev. 6, Annex 3 - xxx.xxxxx.xxx/xxxxx/xxxx/xx00/xx00xxx/xx00xxx/xx00xxxxxxxxxxx.xxxx 4 For the purpose of this Regulation, the previous versions of the standards IEC 61672-1:2004 and IEC 61672-3:2006 may be applied. 5 The site may take the form, for instance, of an open space of 50 m radius, the central part of which must be practically horizontal over a radius of at least 20 m, the surface being of concrete, asphalt or a similar material, which must not be moist or covered with powdery snow, tall weeds, or loose soil or cinders, as mentioned in ISO 10844:2014. The measurements shall be made on a clear day. No-one other than the observer reading the instrument shall remain near the audible reverse warning device or the microphone, since the presence of spectators may affect the readings of the instrument to a considerable extent, if they are near the audible reverse warning device or the microphone. Any peak which appears to be unrelated to the general sound level shall be disregarded in the reading. 6 The site may take the form, for instance, of an open space of 50 m radius, the central part of which must be practically horizontal over a radius of at least 20 m, the surface being of concrete, asphalt or a similar material, which must ...
Flowcharts. Figures 6 and 7 show the flowcharts for the baseline systems of the insulation panel and wood coating, respectively.
Flowcharts. These charts are for layoff and recall purposes only A- TO OF PARAGRAPH OF These are for layoff and only BODY SHOP E2 FLOWCHARTS charts are for layoff and only PAINT SHOP I I I GROUP I LAYOFF TOTHE OF OF THE INCLUDES INCLUDESPAINT ME for layoff LAYOFF TO THEPROVISIONSOF FACILITATOR FLOWCHARTS are for layoff and purposes CHASSIS GROUP FACILITATOR charta are for layoff FACILITATOR are for and only FORMATION These charts are for layoff and purposes only MAINTENANCE GROUP FLOWCHARTS These are for and purposes only (Skilledtrades WORKS CHART ELECTRICIANS POWER HOUSE OPERATORS I OF MEMORANDUM OF LOCAL WAGE AGREEMENT entered into this Q BETWEEN. General Motors of Canada Limited, Box Quebec, Hereinafter referred to as the Company, Automobile. and No. Quebec, Hereinafter referred to as the Union. the parties, together with other parties, entered into an agreement dated October referred to as the "Master Agreement"); and
Flowcharts. Figure 1 YES Re-measure "Background noise" Any transient disturbance? Measure "Background noise" for 10 seconds using the test microphone. (6.3.1.) (6.4.1.) (14.4.5.1.) (14.5.5.1.) Determination of the range of "Background noise" (14.4.5.) (14.5.5.) NO
Flowcharts. 1.4.1 The flowcharts provided within Appendix A are intended to describe the procedures for dealing with allegations of financial crime against employees. The flowcharts detail procedures that allow for evidence gathering and collation in a manner that will facilitate informed initial decisions by those requiring to make them; be this either CFS or the NHS Body, while ensuring that evidence gathered will be admissible in any possible future criminal proceedings.
Flowcharts. 3. The flowcharts illustrate the basic elements that constitute a fuel supply chain: each element describes the point of origin of the fuel, its point of delivery, the means of transportation between these two points and the different tests to be performed on the fuel all along this part of the logistic chain.
Flowcharts. For computer-based assessments, ETS will deliver test results within two-three weeks after a student completes testing in a given content area. Figure 6 below illustrates the process ETS will use for scoring computer-based CAASPP assessments. Figure 6. Computer-based Test Delivery — Scoring and Reporting Flow For all paper-pencil tests, ETS will deliver test results within six (6) weeks after receipt of materials to confirm complete and accurate processing. Figure 7 below illustrates the process ETS will use for scoring paper-pencil CAASPP assessments. Figure 7. Paper-pencil Test Delivery—Scoring and Reporting Flow Rescore Requests Request for a rescore will be provided to districts following a CDE-approved procedure for requesting the rescoring of an individual student’s responses or a set of classroom-level responses. ETS will provide results of any such rescores to the requesting district within 30 working days of receipt of the request. In the case that the rescore indicates any anomalies, ETS will verify the correct scores and reissue affected score reports. In such an event, there will be no charge to the district. ETS will also conduct CDE rescore requests at no charge to the CDE. If any such CDE-requested rescoring requires updating and/or distribution of new data and score reports, there will be no charge to the CDE or to the CAASPP contract.
Flowcharts. Collective Dispute Resolution Procedure (Local and National) For ease of reference at Annex C and Xxxxx D can be found flowcharts that clearly present the processes and timescales that should be followed when using the Collective Dispute Resolution Procedure.
Flowcharts. For computer-based assessments, ETS will deliver test results within two-three weeks after a student completes testing in a given content area. Figure 6 below illustrates the process ETS will use for scoring computer-based CAASPP assessments.
Flowcharts. 30 4.3.1 FCH BUS IN FIRE (SIMPLE ENVIRONMENT): 30
