Labeling and Identification. Lessee shall identify its Equipment and equipment cabinets (unless, such cabinet is located in a building owned by Lessee) by labels identifying Lessee’s name and contact phone number and shall permanently identify its coaxial cable at the top and bottom in accordance with the minimum standards described on Appendix titled Minimum Standards For Equipment Labels attached hereto and incorporated by this reference. Failure by Lessee to so identify its Equipment may cause an interruption in service of Lessee’s operation and shall constitute a Default of this Agreement, provided Lessor has given Licensee ten (10) Business Days prior notice that such labels or lack of labels do not comply with Lessor’s requirements, such notice gives Lessee reasonably adequate detail to remedy such failure, and Lessee has the opportunity to cure such Default pursuant to Section 12. In the event that Lessee fails to comply with this Section 18, Lessor reserves the right, in addition to any other rights it may have hereunder, to label Lessee’s Equipment and assess an administrative charge of One Thousand Five Hundred Dollars ($1,500), which shall be payable to Lessor thirty (30) days after receipt of an invoice.
Labeling and Identification. Licensee shall identify its equipment --------------------------- and equipment cabinets (unless such cabinet is located in a building owned by Licensee) by labels provided by Licensor (or, if not provided by Licensor, labels provided by Licensee and designed for such purpose) and shall permanently identify its coaxial cable at the top and bottom. Failure by Licensee to so identify its equipment may cause an interruption in service of licensee's operation and shall constitute a default of this Agreement.
Labeling and Identification. 6.19.1 For diagnostic and troubleshooting purposes, all combiner boxes shall be uniquely tagged and identified with such tagging on the record construction drawings. All string harnesses and array jumpers shall be labeled with a string number. These cables shall have a label affixed to the outer jacket with a cable marker tape at each termination. The marker tapes shall be vinyl or vinyl-cloth, self-adhesive wraparound type, with circuit identification legend machine printed by thermal transfer or equivalent process. Marker tapes to be approved by Owner before installation.
Labeling and Identification. Licensee shall identify its Equipment and equipment cabinets (unless such cabinet is located in a building owned by Licensee) by labels identifying Licensee's name and contact phone number and shall permanently identify its coaxial cable at the top and bottom. Failure by Licensee to so identify its Equipment may cause an interruption in service of Licensee's operation and shall constitute a Default of this Agreement. In the event that Licensee fails to comply with this Section 8.9 and following prior written notice to Licensee of no less than forty-five (45) days, Licensor reserves the right, in addition to any other rights it may have hereunder, to label Licensee's Equipment and assess a fee for Licensor's out-of-pocket costs (provided, however, that if such work is performed by Licensor or one of its Affiliates, such out-of-pocket costs shall include the cost of labor and materials incurred by Licensor but in no event to exceed $1,500), which shall be payable to Licensor upon receipt of an invoice.
Labeling and Identification. Original Containers 7-101.11 Identifying Information, Prominence* 5-101.11 Approved System* 5-501.19 Storage Areas and Units/Location 7-102.11 Working Containers, Common Name* 5-101.12 System Flushing and Disinfection* 5-101.13 Bottled Drinking Water* Quality 5-102.11 Standards* 5-102.12 Nondrinking Water* 5-102.13 Sampling 5-102.14 Sample Report Quantity and Availability 5-103.11 Capacity* 5-103.12 Pressure 5-103.13 Hot Water Distribution, Delivery, and Retention 5-104.11 System 5-104.12 Alternative Water Supply PLUMBING SYSTEM 5-201.11 Materials, Approved* Design, Construction, and Installation 5-202.11 Approved System/Cleanable Fixtures* 5-202.12 Handwashing Lav., Water Temp./Flow 5-202.13 Backflow Prevention, Air Gap* 5-202.14 Backflow Prevention Device, Design 5-202.15 Conditioning Device, Design Numbers and Capacities 5-203.11 Handwashing Lavatory* 5-203.12 Toilets and Urinals* 5-203.13 Service Sink 5-203.14 Backflow Prevention Device/Required* 5-203.15 Backflow Prevention Dev./Carbonator* Location and Placement 5-204.11 Handwashing Lavatory* 5-204.12 Backflow Prevention Device/Location 5-204.13 Conditioning Device, Location Operation and Maintenance 5-205.11 Using a Handwashing Lavatory 5-205.12 Prohibiting a Cross Connection* 5-205.13 Scheduling Device Inspect./Service 5-205.14 Fogging Device Reservoir/Cleaning* 5-205.15 System Maintained/Repair* MOBILE WATER TANK/MOBILE ESTAB. WATER TANK 5-301.11 Materials, Approved Design and Construction 5-302.11 Enclosed System, Sloped to Drain 5-302.12 Inspection Port, Protected/Secured 5-302.13 "V" Type Threads, Use Limitation 5-302.14 Tank Vent, Protected 5-302.15 Inlet and Outlet, Sloped to Drain 5-302.16 Hose, Construction/Identification Numbers and Capacities 5-303.11 Filter, Compressed Air 5-303.12 Protective Equipment or Device 5-303.13 Mobile Food Est. Water Tank Inlet Operation and Maintenance 5-304.11 Flushing and Disinfecting System* 5-304.12 Using Pump and Hoses/Backflow Prev. 5-304.13 Protect. Inlet/Outlet/Hose Fitting 5-304.14 Dedicating Tank, Pump, and Hoses 5-501.110 Storing Refuse/Recyclables/Return. 5-501.111 Areas/Enclosures/Receptacles, Repair 5-501.112 Outside Storage Prohibitions 5-501.113 Covering Receptacles 5-501.114 Using Drain Plugs 5-501.115 Maintaining Refuse Areas/Enclosures 5-501.116 Cleaning Receptacles Removal 5-502.11 Frequency 5-502.12 Receptacles or Vehicles Facilities for Disposal/Recycling/Refilling 5-503.11 Community or Individual Facility Physical Facilities
Labeling and Identification. Contractor shall label its equipment in a durable manner so as to ensure clear identification of ownership. Upon request from HFC, Contractor shall promptly provide a then- current list of all Contractor equipment stored at the Parking Facilities.
Labeling and Identification. Original Containers 7-101.11 Identifying Information, Prominence* 7-102.11 Working Containers, Common Name* OPERATIONAL SUPPLIES AND APPLICATIONS 7-201.11 Storage, Separation* Presence and Use 7-202.11 Restriction* 7-202.12 Conditions of Use* Container Prohibitions 7-203.11 Poisonous/Toxic Material Containers* Chemicals 7-204.11 Sanitizers* 7-204.12 Washing Fruits and Vegetables* 7-204.13 Boiler Water Additives* 7-204.14 Drying Agents* 7-205.11 Lubricants, Incidental Food Contact* Pesticides 7-206.11 Restricted-Use, Criteria* 7-206.12 Bait Stations* 7-206.13 Tracking Powders* Medicines 7-207.11 Restriction and Storage* 7-207.12 Medicines, Refrigerated Storage* 7-208.11 First Aid Supplies, Storage* 7-209.11 Other Personal Care Items, Storage STOCK AND RETAIL SALE 7-301.11 Storage and Display, Separation* Compliance and Enforcement CODE APPLICABILITY Variances
Labeling and Identification. Licensee shall identify its Equipment and equipment cabinets (unless such cabinet is located in a building owned by Licensee) by labels identifying Licensee's name and contact phone number and shall permanently identify its coaxial cable at the top and bottom. FAILURE BY LICENSEE TO SO IDENTIFY ITS EQUIPMENT MAY CAUSE AN INTERRUPTION IN SERVICE OF LICENSEE'S OPERATION AND SHALL CONSTITUTE A LICENSEE DEFAULT OF THIS AGREEMENT. In the event that Licensee fails to comply with this Section 8.8, Licensor reserves the right, in addition to any other rights it may have hereunder following ten (10) Days prior written notice, to label Licensee's Equipment and assess an Administrative Fee of One Thousand Five Hundred Dollars ($1,500), which shall be payable to Licensor upon receipt of an invoice.
