Plumbing and Fire Protection Sample Clauses

Plumbing and Fire Protection. 1 Plans showing building systems in diagrammatic form. .2 Concurrence with sizes and location of mechanical rooms. .3 Narrative input on basic systems description.
Sample 1Sample 2Sample 3See All (10)
AutoNDA by SimpleDocs
Plumbing and Fire Protection. Develop plumbing design to establish: (i) general location of plumbing lines; (ii) plumbing line sizing; and (iii) plumbing fixtures. Develop fire protection design showing generally sprinkler piping layout, fire department access areas and connections, and main utility connection.
Sample 1Sample 2
Plumbing and Fire Protection. Fire protection plans with header and riser layouts, detailing piping design with sizing indicated, sprinkler zone locations, sprinkler installation details including structural supports, penetration details and design calculations. Plumbing components shall be completely identified and located.
Sample 1Sample 2
Plumbing and Fire Protection. The model should include the following plumbing and fire protection elements at a minimum: • Waste and Vent Piping sized at and over 3/4” diameter, includes any insulation in model. Unless otherwise noted by the BIM Execution Plan. o Roof and floor drains, leaders, sumps, grease interceptors, tanks, water treatments and other major items. • Supply Piping larger than 3/4” diameter, includes any insulation in model. Unless otherwise noted and approved by the BIM Execution Plan.
Sample 1Sample 2
Plumbing and Fire Protection. 1. Design toilet rooms so that the plumbing fixtures can be installed back-to-back to minimize mains and runouts and vertically stack toilet rooms on consecutive floors.
Sample 1
Plumbing and Fire Protection. 1. All new plumbing systems and equipment shall be compatible with the Core & shell systems.
Sample 1

Related to Plumbing and Fire Protection

  • Fire Protection Contractor shall take adequate and reasonable precautions to protect the Work against damage by fire and smoke. For example, without limitation, Contractor shall do the following:

  • System Protection To prevent compromise of systems which contain DSHS Data or through which that Data passes:

  • TEACHER PROTECTION Section A: Working Conditions Paragraph 1: The Board agrees to str ive continually to provide working condi- tions which meet federal, state and local laws and regulations.

  • Eye Protection Approved eye protection shall be supplied to individual prescription to all employees who normally wear glasses and are required to wear eye protection for an appreciable amount of time in the performance of their duties.

  • Personal Protective Clothing and Equipment The Government considers operators as fireline personnel who will use and wear specified articles of personal protective equipment.

  • Job Protection 15.9.1 Subject to 15.10 below, an employee returning from parental leave is entitled to resume work in the same position or a similar position to the one they occupied at the time of commencing parental leave. A similar position means a position:

  • Staff Protection A. The District shall protect certificated employees acting within the scope of their employment by purchasing liability insurance in the amount of at least five million dollars ($5,000,000) per occurrence, and the District shall include the certificated employees as named insured under the liability insurance and errors and omissions policy of the school district.

  • Requirements for Protection In compliance with NPCC requirements and Good Utility Practice, Developer shall provide, install, own, and maintain relays, circuit breakers and all other devices necessary to remove any fault contribution of the Large Generating Facility to any short circuit occurring on the New York State Transmission System not otherwise isolated by Connecting Transmission Owner’s equipment, such that the removal of the fault contribution shall be coordinated with the protective requirements of the New York State Transmission System. Such protective equipment shall include, without limitation, a disconnecting device or switch with load- interrupting capability located between the Large Generating Facility and the New York State Transmission System at a site selected upon mutual agreement (not to be unreasonably withheld, conditioned or delayed) of the Developer and Connecting Transmission Owner. Developer shall be responsible for protection of the Large Generating Facility and Developer’s other equipment from such conditions as negative sequence currents, over- or under-frequency, sudden load rejection, over- or under-voltage, and generator loss-of-field. Developer shall be solely responsible to disconnect the Large Generating Facility and Developer’s other equipment if conditions on the New York State Transmission System could adversely affect the Large Generating Facility.

  • Whistle Blowing Protection The Employer agrees to adhere to the whistle blowing protection pursuant to the Long-Term Care Homes Act (LTCHA).

  • STUDENT DISCIPLINE AND TEACHER PROTECTION A. The Board recognizes its responsibility to give all support and assistance to teachers with respect to the maintenance of control and discipline in the classroom. Whenever it appears to the teacher and a representative of the Board that a particular pupil requires the attention of special counselors, social workers, law enforcement personnel, physicians or other professional persons the Board will take steps to relieve the teacher of responsibilities with respect to such pupil.

Time is Money Join Law Insider Premium to draft better contracts faster.