IN FLIGHT Sample Clauses

IN FLIGHT. The pilot will perform the following flight maneuvers at a minimum altitude of 2,500 feet above ground level (AGL):
Sample 1
AutoNDA by SimpleDocs
IN FLIGHT. (1) Explain use and relationship between altimeter and the vertical velocity indicator.
Sample 1
IN FLIGHT. Manager means any person in a management position within the Flight Attendant department, specifically the Flight Attendant Supervisor and above.
Sample 1
IN FLIGHT. Uniforms: United Express Flight Attendants are required to wear the professional uniform designated for flight attendants by United. There is to be no deviation from this uniform and it is to be worn at all times while on duty. Employees in uniform, on or off duty are not allowed to drink intoxicating beverages, give the appearance of being intoxicated or visit any establishment whose primary purpose is to dispense liquor (e.g. bars, saloons, cocktail lounges, liquor stores). “
Sample 1

Related to IN FLIGHT

  • Flight Crew (a) Lessor shall employ or engage and pay all salaries, benefits and/or compensation for a fully-qualified flight crew with appropriate credentials to conduct each flight undertaken under this Agreement. Lessor may use temporary flight crewmembers for a flight under this Agreement only if any such temporary crewmember is FlightSafety (or SimuFlite) trained, is current on the Aircraft and satisfies all of the requirements and conditions under the insurance coverage for the Aircraft. All flight crewmembers shall be included on any insurance policies that Lessor is required to maintain hereunder.

  • Technical Services Party B will provide technical services and training to Party A, taking advantage of Party B’s advanced network, website and multimedia technologies to improve Party A’s system integration. Such technical services shall include:

  • ELECTRICAL SERVICES A. Landlord shall provide electric power for a combined load of 3.0 xxxxx per square foot of useable area for lighting and for office machines through standard receptacles for the typical office space.

  • Maintenance and Support Services As long as you are not using the Help Desk as a substitute for our training services on the Tyler Software, and you timely pay your maintenance and support fees, we will, consistent with our then-current Support Call Process:

  • Aircraft Maintenance Operator shall, at its own expense, cause the Aircraft to be inspected, maintained, serviced, repaired, overhauled, and tested in accordance with FAR Part 91 so that the Aircraft will remain in good operating condition and in a condition consistent with its airworthiness certification and shall take such requirements into account in scheduling the Aircraft hereunder, including but not limited compliance with applicable airworthiness directives and service bulletins. Performance of maintenance, preventive maintenance or inspection shall not be delayed or postponed for the purpose of scheduling the Aircraft unless such maintenance or inspection can safely be conducted at a later time in compliance with applicable laws, regulations and requirements, and such delay or postponement is consistent with the sound discretion of the pilot-in-command. In the event that any non-standard maintenance is required during the term and will interfere with User’s requested or scheduled flights, Operator, or Operator’s pilot-in-command, shall notify User of the maintenance required, the effect on the ability to comply with User’s requested or scheduled flights and the manner in which the parties will proceed with the performance of such maintenance and conduct of such flight(s). In no event shall Operator be liable to User or any other person for loss, injury or damage occasioned by the delay or failure to furnish the Aircraft under this Agreement, whether or not maintenance-related.

  • TECHNICAL SUPPORT SERVICES 2.1 The technical support services (the "Services"): Party A agrees to provide to Party B the relevant services requested by Party B, which are specified in Exhibit 1 attached hereto ("Exhibit 1").

  • Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts. An adequately sized 3 phase “wye” wound step down transformer shall be provided to supply 208/120-volt, 3 phase power, for lighting, general service receptacles and dedicated computer based office equipment. Dedicated, isolated ground circuits shall be supplied from separate isolated ground power distribution panel(s). Lighting circuits shall be supplied from separate lighting panel(s). Panels shall have 20% spare capacity and be complete with 10% spare breakers of each size, but no less than 1 spare. No more than 4 duplex receptacles shall be connected to any single 20-amp dedicated isolated ground circuit or general service circuit.

  • Spares Boeing will revise, as applicable, the customized Recommended Spares Parts List (RSPL) and Illustrated Parts Catalog (IPC).

  • Maintenance and Support For so long as you timely pay your SaaS Fees according to the Invoicing and Payment Policy, then in addition to the terms set forth in the SLA and the Support Call Process, we will:

Time is Money Join Law Insider Premium to draft better contracts faster.