Impervious Surface Sample Clauses

Impervious Surface. The cooperating entity may submit a request for waiver of the 2-percent impervious surface limitation for each parcel within 90 days prior to closing on the easement (if applicable). A cooperating entity may also employ its own process for waiving the impervious surface limitation if the process is applied on a parcel-by-parcel basis. The cooperating entity’s process for waiving the impervious surface limitation must be submitted to the State Conservationist not less than 90 days prior to closing an easement. The cooperating entity’s process must be approved by the NRCS Deputy Chief for Easements and Landscape Planning.
Sample 1Sample 2Sample 3See All (4)
AutoNDA by SimpleDocs
Impervious Surface. Surface area that is either impervious to water or which substantially prevents the infiltration of water into the soil at that location. Impervious Surfaces include, but are not limited to: pavement, concrete, asphalt, rooftops, and other hard surfacing materials, and do not include soil, crushed stone, or gravel surfaces.
Sample 1Sample 2
Impervious Surface. The total amount of Impervious Surface on the Property cannot exceed two (2) acres. Grantor may utilize and allocate this Impervious Surface within and between reserved structures and Building Envelopes in Grantor’s sole and absolute discretion. This Easement does not permit any additional Impervious Surface on the Property once the total allowable Impervious Surface coverage has been utilized unless existing Impervious Surface is removed in an amount equal to or greater than the proposed additional Impervious Surface, and the area occupied by such removed Impervious Surface has been re- vegetated to Grantee’s reasonable satisfaction.
Sample 1
Impervious Surface. Maximum 85% of the total net area, including but not limited to, main buildings, accessory buildings, parking lots, roads, drives, alleys, and loading areas.
Sample 1
Impervious Surface. Impervious surfaces, resulting from other than Temporary Agricultural Improvements, including any surface that prevents direct percolation of water into the soil such as structures and buildings (with and without flooring), paved areas and rooftops on the Protected Property both within and outside the Building Envelope shall not exceed 2 percent of the total acreage of the Protected Property.
Sample 1
Impervious Surface. 1) East Property: Based on the current and proposed uses and subsequent parking requirement as depicted in Exhibit D.
Sample 1
Impervious Surface. Based on the current and proposed uses and subsequent parking requirement, the imperious surface limit is established at 60%.
Sample 1
AutoNDA by SimpleDocs
Impervious Surface. A constructed hard surface that either prevents or retards the entry of water into the soil and causes water to run off the surface in greater quantities and at an increased rate of flow than prior to development. Examples include rooftops, sidewalks, patios, driveways, parking lots, storage areas, and concrete, asphalt, or gravel roads.
Sample 1

Related to Impervious Surface

  • Surface  Grade and shape the road surface, turnouts, and shoulders to the original shape on the TYPICAL SECTION SHEET. Inslope or outslope as directed to provide a smooth, rut-free traveled surface and maintain surface water runoff in an even, unconcentrated manner.  Blading shall not undercut the backslope or cut into geotextile fabric on the road.  If required by the Contract Administrator, water shall be applied as necessary to control dust and retain fine surface rock.  Surface material shall not be bladed off the roadway. Replace surface material when lost or worn away, or as directed by the Contract Administrator.  Remove shoulder berms, created by grading, to facilitate drainage, except as marked or directed by the Contract Administrator.  For roads with geotextile fabric: spread surface aggregate to fill in soft spots and wheel ruts (barrel spread) to prevent damage to the geotextile fabric.

  • Groundwater The groundwater shall not be degraded as a result of the waste maintained at the facility.

  • Road Surfaces (1) Grade, shape, crown, and/or outslope surface and shoulders.

  • Leased Premises Lessor hereby leases to Lessee, and Lessee leases and takes from Lessor, the Leased Premises subject to the conditions of this Lease.

  • The Premises Landlord hereby leases to Tenant and Tenant hereby leases from Landlord the premises set forth in Section 2.2 of the Summary (the “Premises”). The outline of the Premises is set forth in Exhibit A attached hereto, and an outline of the Project is set forth in Exhibit A-1 attached hereto. The parties hereto agree that the lease of the Premises is upon and subject to the terms, covenants and conditions herein set forth, and Tenant covenants as a material part of the consideration for this Lease to keep and perform each and all of such terms, covenants and conditions by it to be kept and performed and that this Lease is made upon the condition of such performance. The parties hereto hereby acknowledge that the purpose of Exhibit A is to show the approximate location of the Premises in the “Building,” as that term is defined in Section 1.1.2, below, only, and such Exhibit is not meant to constitute an agreement, representation or warranty as to the construction of the Premises, the precise area thereof or the specific location of the “Common Areas,” as that term is defined in Section 1.1.3, below, or the elements thereof or of the accessways to the Premises or the “Project,” as that term is defined in Section 1.1.2, below. Except as specifically set forth in this Lease, Tenant shall accept the Premises in its presently existing “as-is” condition and Landlord shall not be obligated to provide or pay for any improvement work or services related to the improvement of the Premises. Tenant also acknowledges that neither Landlord nor any agent of Landlord has made any representation or warranty regarding the condition of the Premises, the Building or the Project or with respect to the suitability of any of the foregoing for the conduct of Tenant’s business, except as specifically set forth in this Lease. However, notwithstanding the foregoing, Landlord agrees that base Building electrical, mechanical, heating, ventilation and air conditioning and plumbing systems located in the Premises shall be in good working order and the roof shall be water tight as of the date Landlord delivers possession of the Premises to Tenant. Except to the extent caused by the acts or omissions of Tenant or any Tenant Parties (as defined in Section 10.13 below) by any alterations or improvements performed by or on behalf of Tenant, if such systems and/or the roof are not in good working order as of the date possession of the Premises is delivered to Tenant and Tenant provides Landlord with notice of the same within ninety (90) days following the date Landlord delivers possession of the Premises to Tenant, Landlord shall be responsible for repairing or restoring the same at Landlord’s sole cost and expense. Subject to any repairs or restoration required by the immediately preceding sentence, the commencement of business operations from the Premises by Tenant shall presumptively establish that the Premises and the Building were at such time in good and sanitary order, condition and repair. For purposes of Section 1938 of the California Civil Code, Landlord hereby discloses to Tenant, and Tenant hereby acknowledges, that the Premises, the Building and the Project have not undergone inspection by a Certified Access Specialist (CASp).

  • Excavation If any excavation shall be made upon land adjacent to or under the Building, or shall be authorized to be made, Tenant shall afford to the person causing or authorized to cause such excavation, license to enter the Premises for the purpose of performing such work as said person shall deem necessary or desirable to preserve and protect the Building from injury or damage and to support the same by proper foundations, without any claim for damages or liability against Landlord and without reducing or otherwise affecting Tenant’s obligations under this Lease.

  • The Site The site of the Project Highway (the “Site”) shall comprise the site described in Schedule-A in respect of which the Right of Way shall be provided by the Authority to the Contractor. The Authority shall be responsible for:

  • Contamination The presence in, on or under land, air or water of a substance (whether a solid, liquid, gas, odour, heat, sound, vibration or radiation) at a concentration above the concentration at which the substance is normally present in, on or under land, air or water in the same locality, that presents a risk of Environmental Harm, including harm to human health or any other aspect of the Environment, or could otherwise give rise to a risk of non-compliance with any Statutory Requirement for the protection of the Environment.

  • Demised Premises The Landlord hereby demises and leases to the Tenant, and the Tenant hereby leases from the Landlord, upon and subject to the terms and provisions of this Lease (which term is used herein shall include all Exhibits attached hereto or referred to herein), the commercial space (sometimes hereinafter referred to as the "Demised Premises") depicted on Exhibit A hereto annexed and made a part hereof. Said Demised Premises contain approximately six thousand six hundred fifty-one (6,651) square feet of floor area (measuring from (i) the center of the two side demising walls and (ii) the front lease line of the Demised Premises, through the rear wall), commonly known as suite 3800 on level 3 as shown on Exhibit A-1 attached hereto of the multi-level structure (the "Mall Building"), which Landlord has constructed on a parcel of land (the "Shopping Center Site") located in Dallas, Dallas County, Texas. The metes and bounds description of the Shopping Center Site is set forth on Exhibit A-2 annexed hereto and made a part hereof. In the event, within sixty (60) days after commencement of the term of this Lease, either party hereto finds that the actual floor area of the Demised Premises differs by ten (10) square feet or more from the floor area set forth hereinabove and such difference is confirmed by Landlord's independent architect (which confirmation shall be binding upon Landlord and Tenant absent bad faith or manifest error on the part of Landlord's architect), Landlord and Tenant shall execute an amendment to this Lease setting forth the actual floor area, and proportionately changing Tenant's monetary obligations, including Minimum Rent, based upon the ratio of the actual floor area of the Demised Premises to the floor area set forth hereinabove. The term "

  • Common Areas Tenant shall have the non-exclusive right to use in common with other tenants in the Project, and subject to the Rules and Regulations referred to in Article 5 of this Lease, those portions of the Project which are provided, from time to time, for use in common by Landlord, Tenant and any other tenants of the Project (such areas, together with such other portions of the Project designated by Landlord, in its discretion, including certain areas designated for the exclusive use of certain tenants, or to be shared by Landlord and certain tenants, are collectively referred to herein as the “Common Areas”). The Common Areas shall consist of the “Project Common Areas” and the “Building Common Areas.” The term “Project Common Areas,” as used in this Lease, shall mean the portion of the Project designated as such by Landlord or areas within the Project that the occupants of the Building are permitted to utilize pursuant to a recorded declaration and which areas shall be maintained in accordance with the declaration. The term “Building Common Areas,” as used in this Lease, shall mean the portions of the Common Areas located within the Building reasonably designated as such by Landlord. The manner in which the Common Areas are maintained and operated shall be at the reasonable discretion of Landlord and the use thereof shall be subject to the Rules and Regulations as Landlord may make from time to time. Landlord reserves the right to close temporarily, make alterations or additions to, or change the location of elements of the Project and the Common Areas, provided that, in connection therewith, Landlord shall perform such closures, alterations, additions or changes in a commercially reasonable manner and, in connection therewith, shall use commercially reasonable efforts to minimize any material interference with Tenant’s use of and access to the Premises.

Time is Money Join Law Insider Premium to draft better contracts faster.