Compliance with Technical Standards Sample Clauses

Compliance with Technical Standards and Safety Act, 2000
AutoNDA by SimpleDocs
Compliance with Technical Standards. The Concessionaire shall comply with and implement, and shall cause all Work and the Plant Operations to comply with, Standard Industry Practice, applicable recommendations and instructions of the equipment manufacturers and the Technical Standards in all material respects at all times during the Term (including any changes or modifications to the Technical Standards made pursuant to the terms of this Agreement); provided that the Concessionaire shall have a reasonable period of time (a) following the Closing Date to carry out any changes to the development and construction of the Plant in order to cause the development and construction of the Plant to comply with the Technical Standards in effect as of the Closing Date and (b) from time to time to comply with the introduction of changes or modifications to the Technical Standards that are made in accordance with the terms of this Agreement. The Technical Standards shall be construed flexibly in light of their objectives. The Technical Standards shall not be deemed to be violated if a failure to comply could not reasonably be expected to (i) give rise to an Environmental Non-Compliance or (ii) have a material adverse effect on Plant Operations or the condition of the Plant or Plant Site, other than actions or omissions that endanger human health or safety. To the extent that any term or provision of the Technical Standards conflicts with any term or provision otherwise specified in this Agreement, then such term or provision of this Agreement shall govern and shall supersede any such conflicting term or provision in the Technical Standards. Except as specifically set forth in this Agreement, the Concessionaire shall perform all Work required to comply with and implement the Technical Standards as part of the development and construction of the Plant and the Plant Operations at its sole cost and expense.
Compliance with Technical Standards. Grantee shall, at all times, meet or exceed FCC Technical Standards for cable television signal quality as set forth in the FCC Rules and Regulations, and subsequent amendments thereto.

Related to Compliance with Technical Standards

  • Applicable Technical Standards The Applicable Technical Requirements and Standards that apply to the Customer Facility and the Interconnection Facilities are identified in Schedule D to this ISA.

  • Technical Standards The Generation System shall be installed and operated by the Interconnection Customer consistent with the requirements of this Agreement; the Technical Requirements; the applicable requirements located in the National Electrical Code (NEC); the applicable standards published by the American National Standards Institute (ANSI) and the Institute of Electrical and Electronic Engineers (IEEE); and local building and other applicable ordinances in effect at the time of the installation of the Generation System.

  • Compliance with Standards Although the standards for workmanship, material, and equipment have been selected in these specifications as a basis of reference, standards and specifications of the other bank member countries and recommendations of standards international organizations will be acceptable provided they are substantially equivalent to the designated standards and provided furthermore that the contractor submits for approval detailed specifications which he proposes to use. Reference to brand names or catalog numbers if any in these specifications have been made only for that equipment for which it has been determined that a degree of standardization is necessary to maintain certain essential features. And in certain cases such references have also been made for purposes of convenience to specify the requirements, in either case offers of alternative goods, which have similar characteristics and provide performance and quality at lease equal to those specified are acceptable. If the contractor offers materials, equipment, design calculations or tests, which conform to standards other than those specified, full details of the differences between the proposed standards and that specified in so far as they affect the design or purpose of the equipment, are to be supplied by the contractor if called upon to do so by the engineer, where required by the engineer for approval purposes, the contractor shall supply, without charge, duplicate copies of the proposed standards with English translations of the relevant portions. The contractor shall have available in his place of business (or in his supplier’s works) the relevant copies of standards or codes used for the use of the Engineer.

  • COMPLIANCE WITH THE CONTRACT WORK HOURS AND SAFETY STANDARDS ACT (1) Overtime requirements. No contractor or subcontractor contracting for any part of the contract work which may require or involve the employment of laborers or mechanics shall require or permit any such laborer or mechanic in any workweek in which he or she is employed on such work to work in excess of forty hours in such workweek unless such laborer or mechanic receives compensation at a rate not less than one and one-half times the basic rate of pay for all hours worked in excess of forty hours in such workweek.

  • Compliance with Accessibility Standards All parties to this Agreement shall ensure that the plans for and the construction of all projects subject to this Agreement are in compliance with standards issued or approved by the Texas Department of Licensing and Regulation (TDLR) as meeting or consistent with minimum accessibility requirements of the Americans with Disabilities Act (P.L. 101-336) (ADA).

  • ETHICAL STANDARDS a. Distributor and each of its sub-distributors will comply with the United States Foreign Corrupt Practices Act and without derogating from the generality of the foregoing, will not have its directors, officers or employees, directly or indirectly, offer, promise or pay any bribes or other improper payments for the purposes of promoting and/or selling Products to any individual, corporation, government official or agency or other entity. No gift, benefit or contribution in any way related to MEC or the promotion and/or sale of Products will be made to political or public officials or candidates for public office or to political organizations, regardless of whether such contributions are permitted by local laws.

  • COMPLIANCE WITH APPLICABLE LAWS AND STANDARDS 9.1.1 Each party must comply with all Applicable Laws in performing their obligations under this Agreement.

  • Compliance with Data Privacy and Security Laws and Standards Contractor shall comply with all applicable State and federal data privacy and data security laws, rules, and regulations.

  • DECLARATION OF COMPLIANCE WITH APPLICABLE STANDARDS 1. Does the Work report experiments involving human subjects? [ ] YES [ ] NO  If Yes, were the reported experiments in accordance with the ethical standards of the committee responsible for human experimentation (institutional and national), and with the Helsinki Declaration of 1975, as revised in 2013 (xxxx://xxxxxx.xxx.xxx/ecodes/node/3931 )? [ ] YES [ ] NO (If Yes, the Assignor must submit a copy of the approval and consent-to-disclose form to Xxxxxxx Science Publishers by fax or email.) Please state whether Ethical Approval was given, by whom and the relevant Judgement’s reference number. (If No, the Assignor must mention an institutional or regional guideline.) 2. Does the Work report experiments involving animals? [ ] YES [ ] NO  If Yes, were the reported experiments in accordance with the standards set forth in one of below national guidelines and regulations: o The US National Research Council's "Guide for the Care and Use of Laboratory Animals," o The US Public Health Service's "Policy on Humane Care and Use of Laboratory Animals," and "Guide for the Care and Use of Laboratory Animals." o UK : the Animals (Scientific Procedures) Act 1986 Amendment Regulations (SI 2012/3039). [ ] YES [ ] NO 6 [v.122016] CONFLICTS OF INTEREST Conflicts of interest arise when authors, reviewers, or editors have interests (such as financial or personal interests) that are not made clear and that may influence their judgment on the content of their work. Authors and editors who submit work for publication with Xxxxxxx Science are required to disclose and acknowledge all forms of financial support relating to the work to be published, all commercial or financial involvement that might present an appearance of a conflict of interest in respect of the work, and all agreements relating to sponsorship of any research upon which the work is based. Are there any actual, or potential, conflicts of interest? [ ] YES [ ] NO If Yes, details of the actual or potential conflicts of interest must be set-out in the spaces provided below. DISCLOSURE REGARDING ACTUAL OR POTENTIAL CONFLICTS OF INTEREST: [INSERT] DISCLOSURE REGARDING THIRD PARTY FINANCIAL CONTRIBUTIONS: [INSERT] LANGUAGE AND EDITING: Does Assignor require assistance in having the English grammar and style of the Work checked and improved by Xxxxxxx Science? [ ] YES [ ] NO If Yes, Xxxxxxx Science will provide a quote in respect of the same.

  • Compliance with Laws, Rules and Regulations Tenant, at its sole cost and expense, shall comply with all laws, ordinances, orders, rules and regulations of state, federal, municipal, or other agencies or bodies having jurisdiction over use, condition, and occupancy of the Leased Premises. Tenant must use and maintain the Leased Premises in a clean, careful, safe, and proper manner and in compliance with all Applicable Laws, including Applicable Laws pertaining to health, safety, disabled persons, and the environment; provided, however, that Tenant shall not be required to make any structural changes or repairs to the Leased Premises unless the need for such structural changes or repairs is caused by Tenant, its agents, employees, invitees, or others for whom Tenant is responsible pursuant to the terms and provisions of this Lease. Notwithstanding anything to the contrary contained elsewhere in this section, it is expressly agreed and understood that Tenant’s obligation to comply with all Applicable Laws does not apply to any violations of Applicable Laws that (a) were in effect and (b) were being violated or with which the Leased Premises was not in compliance immediately prior to the time Tenant accepted the Leased Premises, including without limitation any existing environmental contamination. Tenant will comply with the rules and regulations of the Leased Premises adopted by Landlord in its reasonable discretion. All such rules and regulations and changes and amendments thereto will be sent by Landlord to Tenant in writing and shall thereafter be carried out and observed by Tenant.

Time is Money Join Law Insider Premium to draft better contracts faster.