Conditions Date Sample Clauses

Conditions Date. As referred to in Article XXI of Schedule “A 2010”: <DATE>
AutoNDA by SimpleDocs
Conditions Date. (a) If a Condition is not satisfied, or waived by Aurizon Network in accordance with clause 2.2, by the Conditions Date for the Condition, then this Agreement will automatically terminate without the need for a Party to give notice of termination to the other Party.
Conditions Date. As referred to in Article XXI of M13 Schedule “A 2013”:
Conditions Date. As referred to in Article XXI of M13 Schedule “A 2013”: Month DD, 20 Receipt Points and Delivery Point, Quantities, and Pressures The following defines each of the Receipt Points: Receipt Point #1:[Name] The gas production site measured by Xxxxxxxx’s meter located at [Lot , Concession , Province of Ontario, Station # Township, ] County, NTD: Repeat for multiple Receipt Points as necessary Maximum Daily Quantity: Receipt Point #1 10³m³ of gas. NTD: Repeat for multiple Receipt Points as necessary Pressures: Xxxxxxx's MAOP at each Receipt Point shall be as follows: Receipt Point #1 MAOP is kPa. NTD: Repeat for multiple Receipt Points as necessary The pressure of the gas delivered by Shipper to Enbridge at the Receipt Point(s) shall be sufficient to move gas into Enbridge's pipeline but may not exceed the MAOP at the Receipt Point(s) as specified above. Enbridge may change the MAOP from time to time and Enbridge shall provide to Shipper six (6) months’ notice of such change in accordance with the provisions of Article XVIII 2(c) of the M13 General Terms & Conditions. The following defines the Delivery Point: XXXX (Facilities): Enbridge's compressor station site, situated in the northwest corner of Lot Twenty-Five (25), Concession II, in the Township of Xxxx-Xxxxxxxx, in the County of Lambton. This point is applicable for quantities of gas that have been previously transported or stored under other contracts that Shipper may have in place with Enbridge. Pressures: XXXX (Facilities): Deliveries by Enbridge shall be made at a pressure of not greater than 4,825 kPa.
Conditions Date. As referred to in Section 6.02: <DATE>
Conditions Date. As referred to in Article XXI of M13 Schedule “A 2013”: Month DD, 20 Receipt Points and Delivery Point, Quantities, and Pressures The following defines each of the Receipt Points: Receipt Point #1:[Name] The gas production site measured by Xxxxxxxx’s meter located at [Lot , Concession , Province of Ontario, Station # Township, ] County, NTD: Repeat for multiple Receipt Points as necessary Maximum Daily Quantity: Receipt Point #1 10³m³ of gas. NTD: Repeat for multiple Receipt Points as necessary Pressures: Xxxxxxx's MAOP at each Receipt Point shall be as follows: Receipt Point #1 MAOP is kPa.
Conditions Date. As referred to in Article XXI of Schedule “A”: <DATE> Special Provisions Insert here any special provisions applicable to this Contract Authorized Overrun Please check one: Applicable [ ] Not applicable [ ] Rate for Service
AutoNDA by SimpleDocs

Related to Conditions Date

  • Termination Conditions This Agreement terminates upon the earlier of any of the following events: 18.1. Podmínky ukončení platnosti smlouvy Platnost této smlouvy skončí, jakmile nastane kterákoliv z následujících událostí:

  • Room Condition The university agrees to provide and the resident agrees to maintain the assigned room and all public areas in and around the immediate building(s) accessible to the resident in a clean, safe and sanitary condition. Upon termination of this agreement, the student should leave the assigned room, its furnishings, and its equipment in as good an order and condition as the same were upon commencement of the student’s occupancy, ordinary wear and tear excepted. University staff will complete an inventory of furnishings and an assessment of damages; charges will be assessed to the responsible individual(s). Personal property left in a room following the termination of occupancy will be deemed abandoned. Students will be charged for the removal of such property.

  • Closing Conditions (a) The obligations of the Company hereunder in connection with the Closing are subject to the following conditions being met:

  • Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.

  • Conditions to Closing Each Purchaser’s obligation to purchase and pay for the Notes to be sold to such Purchaser at the Closing is subject to the fulfillment to such Purchaser’s satisfaction, prior to or at the Closing, of the following conditions:

  • Training Conditions 3.1 The Trainee shall attend an approved training course or training program prescribed in the Training Agreement or as notified to the trainee by the relevant State or Territory Training Authority in accredited and relevant Traineeship Schemes.

  • Conditions Precedent The effectiveness of this Amendment is subject to the satisfaction of all of the following conditions precedent:

  • BASIC CONDITIONS The State shall have no obligation to disburse money for the Project under this Grant Agreement until the Grantee has satisfied the following conditions:

  • PROJECT CONDITIONS A. The Grantee agrees to the following Project Conditions:

  • ADDITIONAL SPECIAL CONTRACT CONDITIONS A. Special Contract Conditions revisions: the corresponding subsections of the Special Contract Conditions referenced below are replaced in their entirety with the following:

Time is Money Join Law Insider Premium to draft better contracts faster.