Xxcuuming
Xxcuuming Sample Clauses
Related to Xxcuuming
Generators Temporary installation of generators, and permanent installation of generators that are placed inside existing non-residential buildings or that occupy an area under 50 square feet behind the building they serve.
Grooming The parties agree that the agency shall have the right to set reasonable and professional grooming standards for its employees. The agency and state agree to consult with the Association in the development of said grooming standards.
Blasting Blasting shall be permitted only for road construction purposes unless advance permission is obtained from Forest Service. Whenever the Industrial Fire Precaution Level is II or greater, a fire security person equipped with a long handled round point No. 0 or larger shovel and a 5 gallon backpack pump can filled with water, will stay at location of blast for 1 hour after blasting is done. Blasting may be suspended by Forest Service, in areas of high rate of spread and resistance to control. Fuses shall not be used for blasting. Explosive cords shall not be used without permission of Forest Service, which may specify conditions under which such explosives may be used and precautions to be taken.
Load Shedding The Distributor may carry out Load Shedding in the following circumstances:
KITCHEN Discard all leftover food in large trash receptacle in kitchen and empty any smaller trash receptacles if used into large trash can in kitchen. Empty large trash bin into the dumpster, (if feasible). If not, please notify front desk. Flatware is to be pre-soaked, washed in dishwasher, dried, returned to drawers and placed facing in the same direction. Dishes, glassware, chopping boards, cooking utensils, pots/pans, baking sheets etc. should be washed in accordance with the instructions on the dish washing machine and returned DRY to dish carts and cupboards. Please check for lipstick/chap stick marks and clean those off accordingly before putting glasses/cups away. Wipe down outside of dishwasher, empty dishwasher food trap into trash and wash out. Counters and sinks wiped down with the water and bleach solution. If used, please wipe inside and out microwave oven; wall/warming ovens, inside the refrigerator and refrigerator door. Run garbage disposal in large double sink by dishwashing machine to clear food waste (Please do not put any food waste in small sinks). Wipe out Alto-Shaam (Warming Ovens) and clean food trays if used. Rinse out any Dish Tubs. Empty any tubs of excess ice outside, if used. Sweep floor of food debris. Empty large trash bin into the dumpster (if feasible). If not please notify front desk. B BQ’s: Make sure propane is turned off after use Clean grill racks with wire brush and wipe up any spills /food debris from the BBQ Leave outside to cool. Please check with Front Desk regarding storage of cold and cleaned BBQ’s PATIO: Return outdoor umbrellas and furniture to original positions. Wipe down outdoor furniture if spills have occurred. Dispose of trash/food waste and cigarette butts in trash receptacles. The following applies if any food and/or beverages have been served in these rooms: GREAT ROOM: Wipe down tables with bleach /water solution. (Located under the sink in the kitchen next to the coffee maker). If linens have been used or rented, please shake off any food debris in trash receptacles and place linens in mesh bags provided. Sorting by color or type is not necessary. Notify front desk of any beverage spills as soon as they occur. Empty any trash receptacles into large trash can in kitchen and then empty that into the dumpster (if feasible). If not please notify front desk. Sweep/Vacuum carpet of any food debris. (These items are located in the cupboard next to Men’s restroom.
Loading RPMG shall schedule the loading and shipping of all outbound corn oil purchased hereunder, but all labor and equipment necessary to load trucks and rail cars and other associated costs shall be supplied and borne by Producer without charge to RPMG. Producer shall handle the corn oil in a good and workmanlike manner in accordance with RPMG’s written requirements and normal industry practice. Producer shall maintain the truck and rail loading facilities in safe operating condition in accordance with normal industry standards and shall visually inspect all trucks and rail cars to assure (i) cleanliness so as to avoid contamination, and (ii) that such trucks and railcars are in a condition suitable for transporting the corn oil. RPMG and RPMG’s agents shall have adequate access to the Ethanol Facility to load Producer’s corn oil on an industry standard basis that allows RPMG to economically market Producer’s corn oil. RPMG’s employees shall follow all reasonable safety rules and procedures promulgated by Producer and provided to RPMG reasonably in advance and in writing. Producer shall supply product description tags, certificates of analysis, bills of lading and/or material safety data sheets that are applicable to all shipments. In the event that Producer fails to provide the labor, equipment and facilities necessary to meet RPMG’s loading schedule, Producer shall be responsible for all costs and expenses, including without limitation actual demurrage and wait time, incurred by RPMG resulting from or arising in connection with Producer’s failure to do so.
Safety Glasses 10.3.1 Where a teacher is considered to be working in an “eye danger” area, the teacher shall receive a personal issue of standard neutral safety glasses which shall remain the property of the employer.
Generating Facility The Interconnection Customer’s device for the production of electricity identified in the Interconnection Request, but shall not include the Interconnection Customer’s Interconnection Facilities.
Power System Stabilizers The Developer shall procure, install, maintain and operate Power System Stabilizers in accordance with the requirements identified in the Interconnection Studies conducted for Developer’s Large Generating Facility. NYISO and Connecting Transmission Owner reserve the right to reasonably establish minimum acceptable settings for any installed Power System Stabilizers, subject to the design and operating limitations of the Large Generating Facility. If the Large Generating Facility’s Power System Stabilizers are removed from service or not capable of automatic operation, the Developer shall immediately notify the Connecting Transmission Owner and NYISO. The requirements of this paragraph shall not apply to wind generators.
Dewatering 4.7.1 Where a part of a site is affected by surface water following a period of rain, thus rendering some areas unsafe for productive work, consistent with the Employer’s obligations under the OH&S Act, all non- trades employees shall assist in ‘dewatering’ their own work site or area if it is so affected. Such work to be paid at single time rates. Productive work will continue in areas not so affected.
