Specific Products Sample Clauses

Specific Products. The parties agree that certain Products will bear the following Primary Branding and Secondary Branding:
AutoNDA by SimpleDocs
Specific Products. Certain of the warranty terms and conditions for the following products deviate from the terms and conditions of this Limited Warranty as indicated in the table below. If there is a conflict between any provisions of this Limited Warranty and any provision in the table below, the provisions of the latter will take precedence and govern the warranties for the particular product. Product: Deviation: Goliath pans 10-Year Warranty Period. Metacaulk 30-Year Warranty Period. Pro-Fit Quick Connectors 5-Year Warranty Period. This Limited Warranty is a pass-through warranty from the manufacturer of the product, Essen Tech Co., LTD. and solely covers replacement of that portion of the product proven to be defective due to a manufacturing defect. This Limited Warranty does not apply to changes to the product or variations of color (fading), shade or texture of the product due to age or fair and ordinary wear and tear. RSH-series This Limited Warranty is a pass-through warranty from PSP Products, Inc. (“Manufacturer”), the manufacturer of the surge protection device (“SPD”), and covers the following: Limited Product Warranty: RSH-50, RSH-60, RSH-120: Lifetime Warranty Period RSH-60VMD: 5-Year Warranty Period RSH-VRM60A: 3-Year Warranty Period RSH-50VRMKIT: 3-Year Warranty Period Enhanced Connected Equipment Warranty: If any heating, ventilation and air conditioning equipment connected to the SPD (“Connected Equipment”) is damaged as a result of SPD failure during a surge event, Manufacturer will, at its sole discretion, repair or replace the Connected Equipment subject to the following Warranty Periods and Dollar Limits: SPD Connected Equipment Warranty Period Connected Equipment Dollar Limit RSH-50 5 Years $5,000 RSH-60 5 Years $7,500 RSH-60VMD 5 Years $5,000 RSH-120 Lifetime $100,000 Coverage is applicable only if the SPD (1) was fully functional immediately prior to the claim event; (2) was properly installed per the installation instructions; and (3) sustained surge damage as a result of the claim event. You must return the SPD to Manufacturer and the SPD must be determined to have failed based on Manufacturer's test procedures. This coverage is secondary to any applicable warranties, service contracts and all other insurance. If the claim is found to be valid, Manufacturer will pay up to the deductible amount of the homeowners’ insurance or the cost of the damage, whichever is less. All of the above items must be met in order to have a valid claim.

Related to Specific Products

  • Country-Specific Provisions The Award shall be subject to any special provisions set forth in Exhibit A for your country, if any. If you relocate to one of the countries included in Exhibit A during the life of the Award or while holding Shares acquired upon vesting of the Restricted Share Units, the special provisions for such country shall apply to you, to the extent the Company determines that the application of such provisions is necessary or advisable in order to comply with applicable laws with regard to the acquisition, issuance or sale of the Shares or facilitate the administration of the Plan. Exhibit A constitutes part of this Agreement.

  • Licensed Products Lessee will obtain no title to Licensed Products which will at all times remain the property of the owner of the Licensed Products. A license from the owner may be required and it is Lessee's responsibility to obtain any required license before the use of the Licensed Products. Lessee agrees to treat the Licensed Products as confidential information of the owner, to observe all copyright restrictions, and not to reproduce or sell the Licensed Products.

  • New Products You agree to comply with NASD Notice to Members 5-26 recommending best practices for reviewing new products.

  • Marking of Licensed Products To the extent commercially feasible and consistent with prevailing business practices, Company shall xxxx, and shall cause its Affiliates and Sublicensees to xxxx, all Licensed Products that are manufactured or sold under this Agreement with the number of each issued patent under the Patent Rights that applies to such Licensed Product.

  • AUDIT OF LICENSED PRODUCT USAGE Contractor shall have the right to periodically audit, no more than annually, at Contractor’s expense, use of licensed Product at any site where a copy of the Product resides provided that: (i) Contractor gives Licensee(s) at least thirty (30) days advance written notice, (ii) such audit is conducted during such party’s normal business hours, (iii) the audit is conducted by an independent auditor chosen on mutual agreement of the parties. Contractor shall recommend a minimum of three (3) auditing/accounting firms from which the Licensee will select one (1). In no case shall the Business Software Alliance (BSA), Software Publishers Association (SPA), Software and Industry Information Association (SIIA) or Federation Against Software Theft (FAST) be used directly or indirectly to conduct audits, or be recommended by Contractor; (iv) Contractor and Licensee are each entitled to designate a representative who shall be entitled to participate, and who shall mutually agree on audit format, and simultaneously review all information obtained by the audit. Such representatives also shall be entitled to copies of all reports, data or information obtained from the audit; and (v) if the audit shows that such party is not in compliance, Licensee shall be required to purchase additional licenses or capacities necessary to bring it into compliance and shall pay for the unlicensed capacity at the NYS Net Price in effect at time of audit, or if none, then at the Contractor’s U.S. Commercial list price. Once such additional licenses or capacities are purchased, Licensee shall be deemed to have been in compliance retroactively, and Licensee shall have no further liability of any kind for the unauthorized use of the software.

  • Product Supply The Parties shall reasonably cooperate and assist each other in transferring ownership of Product drug product and/or Product drug substance (such material, CERTAIN CONFIDENTIAL PORTIONS OF THIS EXHIBIT WERE OMITTED AND REPLACED WITH “[***]”. A COMPLETE VERSION OF THIS EXHIBIT HAS BEEN FILED SEPARATELY WITH THE SECRETARY OF THE SECURITIES AND EXCHANGE COMMISSION PURSUANT TO AN APPLICATION REQUESTING CONFIDENTIAL TREATMENT PURSUANT TO RULE 406 PROMULGATED UNDER THE SECURITIES ACT OF 1933, AS AMENDED. collectively, the “Product Lots”) set forth in Exhibit A attached hereto as promptly as reasonably practicable following the Effective Date; provided, however, that neither Party shall be required to pay money to any Third Party, commence any litigation with, or offer or grant any accommodation (financial or otherwise) to any Third Party. Such Product Lots shall be delivered EXW (Ex Works) (Incoterms 2010) AMGEN, Thousand Oaks, California. Any expense for shipment shall be borne by AKERO (including any import or export duties or taxes). Subject to the terms of this Section 5.4 and Section 6.2 (Additional AMGEN Warranties), AMGEN transfers the Product Lots to AKERO “as is”, and makes no other representation to AKERO in connection therewith. The Parties have entered into a Quality Agreement substantially in the form attached hereto as Exhibit F, dated as of the date hereof, governing the quality of the Product Lots to be supplied pursuant to this Section 5.4. For the avoidance of doubt, Product Lots consisting of drug product as set forth in Exhibit A supplied pursuant to this Section 5.4 shall be labeled for their intended clinical use as set forth in Exhibit A and the labeling of any Product drug product manufactured after the Effective Date shall be the responsibility of AKERO. Except for the Licensed Materials and such Product Lots to be transferred to AKERO, AKERO shall be responsible for, and shall bear the cost of, obtaining (whether by manufacturing or causing to be manufactured) research, clinical and commercial supplies of the Product. From and after the Effective Date, AKERO shall be responsible for all costs and expenses in connection with the storage of, and any stability studies performed on, the Product Lots.

  • Additional Products Upon satisfying the minimum order requirements above, Enrolled Affiliate may order Additional Products.

  • Combination Products If a LICENSED PRODUCT , DISCOVERY PRODUCT and/or THERAPEUTIC PROUCT is sold to any third party in combination with other products, devices, components or materials that are capable of being sold separately and are not subject to royalties hereunder (“OTHER PRODUCTS,” with the combination of products being referred to as “COMBINATION PRODUCTS” and the Other Product and Licensed Product in such Combination Product being referred to as the “COMPONENTS”), the NET SALES of such LICENSED PRODUCT, DISCOVERY PRODUCT and/or THERAPEUTIC PRODUCT included in such COMBINATION PRODUCT shall be calculated by multiplying the NET SALES of the COMBINATION PRODUCT by the fraction A/(A+B), where A is the average NET SALES price of such LICENSED PRODUCT, DISCOVERY PRODUCT and/or THERAPEUTIC PRODUCT in the relevant country, as sold separately, and B is the total average NET SALES price of all OTHER PRODUCTS in the COMBINATION PRODUCT in the relevant country, as sold separately. If, in any country, any COMPONENT is not sold separately, NET SALES for royalty determination shall be determined by the formula [C / (C+D)], where C is the aggregate average fully absorbed cost of the LICENSED PRODUCT, DISCOVERY PRODUCT and/or THERAPEUTIC PRODUCT components during the prior Royalty Period and D is the aggregate average fully absorbed cost of the other essential functional components during the prior Royalty Period, with such costs being determined in accordance with generally accepted accounting principles. To the extent that any SUBLICENSE INCOME relates to a COMBINATION PRODUCT or is otherwise calculated based on the value of one or more licenses or intellectual property rights held by the COMPANY, an AFFILIATE or SUBLICENSEE, COMPANY shall determine in good faith and report to THE PARTIES the share of such payments reasonably attributable to COMPANY’s or such AFFILIATE’s sublicense of the rights granted hereunder, based upon their relative importance and proprietary protection, which portion shall be the SUBLICENSE INCOME. THE PARTIES shall have the right to dispute such sharing determination in accordance with the dispute provisions of the AGREEMENT.

  • Licensed Product “Licensed Product” shall mean any article, composition, apparatus, substance, chemical material, method, process or service whose manufacture, use, or sale is covered or claimed by a Valid Claim within the Patent Rights. For clarity, a “Licensed Product” shall not include other product or material that (a) is used in combination with Licensed Product, and (b) does not constitute an article, composition, apparatus, substance, chemical material, method, process or service whose manufacture, use, or sale is covered or claimed by a Valid Claim within the Patent Rights.

  • Research Use The Requester agrees that if access is approved, (1) the PI named in the DAR and (2) those named in the “Senior/Key Person Profile” section of the DAR, including the Information Technology Director and any trainee, employee, or contractor1 working on the proposed research project under the direct oversight of these individuals, shall become Approved Users of the requested dataset(s). Research use will occur solely in connection with the approved research project described in the DAR, which includes a 1-2 paragraph description of the proposed research (i.e., a Research Use Statement). Investigators interested in using Cloud Computing for data storage and analysis must request permission to use Cloud Computing in the DAR and identify the Cloud Service Provider (CSP) or providers and/or Private Cloud System (PCS) that they propose to use. They must also submit a Cloud Computing Use Statement as part of the DAR that describes the type of service and how it will be used to carry out the proposed research as described in the Research Use Statement. If the Approved Users plan to collaborate with investigators outside the Requester, the investigators at each external site must submit an independent DAR using the same project title and Research Use Statement, and if using the cloud, Cloud Computing Use Statement. New uses of these data outside those described in the DAR will require submission of a new DAR; modifications to the research project will require submission of an amendment to this application (e.g., adding or deleting Requester Collaborators from the Requester, adding datasets to an approved project). Access to the requested dataset(s) is granted for a period of one (1) year, with the option to renew access or close-out a project at the end of that year. Submitting Investigator(s), or their collaborators, who provided the data or samples used to generate controlled-access datasets subject to the NIH GDS Policy and who have Institutional Review Board (IRB) approval and who meet any other study specific terms of access, are exempt from the limitation on the scope of the research use as defined in the DAR.

Time is Money Join Law Insider Premium to draft better contracts faster.