Interim Guide, Warning And Regulatory Signs Sample Clauses

Interim Guide, Warning And Regulatory Signs. Interim guide, warning, or regulatory signs required to direct traffic and pedestrians shall be furnished, installed, reused, and maintained by the Contractor in accordance with the MUTCD, the Plans, Special Provisions, Special Conditions, or as directed by the Engineer. These signs shall remain the property of the Contractor. The bottom of all interim signs shall be mounted at least seven (7’) feet above the level of the pavement edge when the signs are used for long-term stationary operations as defined by Section 6G.02 of the MUTCD. Special Conditions under Subsection 150.11 may modify this requirement. Portable signs may be used when the duration of the work is less than three (3) days or as allowed by the special conditions in Subsection 150.11. Portable signs shall be used for all punchlist work. All portable signs and sign mounting devices utilized in work shall be NCHRP 350 compliant. Portable interim signs shall be mounted a minimum of one (1’) foot above the level of the pavement edge for directional traffic of two (2) lanes or less and a minimum of seven (7’) feet for directional traffic of three (3) or more lanes. Signs shall be mounted at the height recommended by the manufacturer’s crashworthy testing requirements. Portable interim signs which are mounted at less than seven (7’) feet in height may have two 18 inch x 18 inch fluorescent red-orange or orange-red warning flags mounted on each sign. All regulatory sign blanks shall be rigid whether the sign is mounted as a portable sign, on a Type III barricade or as a permanent mount height sign. Any permanent mount height interim sign that is designed to fold in half to cover a non-applicable message on the sign shall have reflectorized material on the folded over portion of the sign. The reflectorized material shall be orange in color with a minimum of ASTM Type I engineering grade sheeting with a minimum area of six inches by six inches (6” x 6”) facing the direction of traffic at all times when the sign is folded. Interim signs may be either English or metric dimensions.
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to Interim Guide, Warning And Regulatory Signs

  • Statutory and Regulatory Compliance Contractor shall comply with all laws and regulations applicable to the Community Development Block Grant-Disaster Recovery funds appropriated by the Disaster Relief Appropriations Act, 2013 (Pub. L. 113-2), including but not limited to the applicable Office of Management and Budget Circulars, which may impact the administration of funds and/or set forth certain cost principles, including the allowability of certain expenses.

  • Policies and Regulations 34 In addition to the Federal Acquisition Regulation (FAR) clauses referred to 35 and listed herein of this Request for Proposal (RFP), the contractor shall 36 comply with the Federal Regulations, Acts, Executive Orders, Special 37 Publications, Guidelines, NOAA Directives and Policies and standards listed 38 below. This listing is not all-inclusive and is not intended to relieve the 39 contractor of its responsibilities for identification of applicable statutes, 40 regulations and procedures and compliance therewith, when performing work 41 under this SOW. 42  Xxxxxxxx-Xxxxxxx Xxxxxxx, Management, and Conservation Act (MSA) 43  Marine Mammal Protection Act (MMPA) 44  Endangered Species Act (ESA) 45  Data Quality Control Act (P.L. 106-514) 46  Information Technology Security Policy 47  Fisheries Management Plans (FMP) 48  Biological Opinions (BO) 49  Take Reduction Team (TRT) 50  NOAA Safety Standards 1  Fair Labor Standards Act (FLSA) 2  Service Contract Act (SCA) 3  Department of Labor Wage Determinations 4  Applicable Federal and State labor laws 5  At-Sea Monitor Health and Safety regulations 6  Federal, state, and local safety regulations 7  Merchant Marine Act (Xxxxx Act) and General Maritime Law 8  U.S. Xxxxxxxxx and Harbor Worker’s Compensation Act

  • wire HDSL-Compatible Loop This is a designed Loop that meets Carrier Serving Area (CSA) specifications, may be up to 12,000 feet long and may have up to 2,500 feet of bridged tap (inclusive of Loop length). It may be a 2-wire or 4-wire circuit and will come standard with a test point, OC, and a DLR.

  • -wire ADSL-Compatible Loop This is a designed Loop that is provisioned according to Revised Resistance Design (RRD) criteria and may be up to 18,000 feet long and may have up to 6,000 feet of bridged tap (inclusive of Loop length). The Loop is a 2-wire circuit and will come standard with a test point, OC, and a DLR.

  • Program Guidelines The goal for this program is to help small businesses expand their market reach by investing in greater hardware and software applications. In the age of technology, there are many innovative ways that business can offer their goods and services to an e-commerce online customer base. The following eligible items are permitted, based on business type: Hardware: • Computers • Printer, scanner, copier (All in one) Software: • Internet service (1 year)Website – Turnkey website landing page package • Virus Protection • Microsoft Office 365 • Remote Client Software (Team Viewer) Other services: Virtual Training courses (Gotomeeting, Zoom, other virtual meetings – Max 3 month service) Tech Support with set up and remote trouble shooting The Process The following identifies the steps in the application process:

  • Drug and Alcohol Policy 66.1 The Parties agree to apply the Drug and Alcohol Management Program (as amended from time to time)

  • Legal and Regulatory Compliance The Consultant shall perform all services and prepare documents in compliance with the applicable requirements of laws, codes, rules, regulations, ordinances, and standards.

  • General Guidelines 1. Conduct yourself in a responsible manner at all times in the laboratory.

  • SPAM POLICY You are strictly prohibited from using the Website or any of the Company's Services for illegal spam activities, including gathering email addresses and personal information from others or sending any mass commercial emails.

  • DRUG & ALCOHOL POLICY The parties agree that employees represented by this Agreement shall be free from the influence of drugs and/or alcohol while at work. The Agency's Drug/Alcohol Policy will be adhered to by such employees.

Time is Money Join Law Insider Premium to draft better contracts faster.