Employment and Training Administration The ratio of trainees to journeymen on the job site shall not be greater than permitted under the plan approved by the Employment and Training Administration. Every trainee must be paid at not less than the rate specified in the approved program for the trainee's level of progress, expressed as a percentage of the journeyman hourly rate specified in the applicable wage determination. Trainees shall be paid fringe benefits in accordance with the provisions of the trainee program. If the trainee program does not mention fringe benefits, trainees shall be paid the full amount of fringe benefits listed on the wage determination unless the Administrator of the Wage and Hour Division determines that there is an apprenticeship program associated with the corresponding journeyman wage rate on the wage determination which provides for less than full fringe benefits for apprentices. Any employee listed on the payroll at a trainee rate who is not registered and participating in a training plan approved by the Employment and Training Administration shall be paid not less than the applicable wage rate on the wage determination for the classification of work actually performed. In addition, any trainee performing work on the job site in excess of the ratio permitted under the registered program shall be paid not less than the applicable wage rate on the wage determination for the work actually performed. In the event the Employment and Training Administration withdraws approval of a training program, the contractor will no longer be permitted to utilize trainees at less than the applicable predetermined rate for the work performed until an acceptable program is approved.
Orientation and Training A transferring employee will be orientated separately to both or their new home in accordance with Article 20 the collective agreement of the designated employer.
EMPLOYEE DEVELOPMENT AND TRAINING 1. The State agrees to provide advice and counseling to employees with respect to career advancement opportunities and agency developments which have an impact on their careers.
STUDENTS AND TRAINEES 1. Payments which a student, business apprentice or trainee who is or was immediately before visiting a Contracting State a resident of the other Contracting State and who is present in the first-mentioned State solely for the purpose of his education or training receives for the purpose of his maintenance, education or training shall not be taxed in that State, provided that such payments arise from sources outside that State.
Professional Development and Training 4.1 The purpose of professional development and training requirements for interpreters is to maintain the skill levels interpreters possess at the time they pass their interpreter certification examination, and to further enhance their skills and knowledge. Both the State and the Union encourage interpreters to complete training and continuing education activities.
Business and Travel Expenses Upon presentation of reasonable substantiation and documentation as the Company may specify from time to time, the Employee shall be reimbursed in accordance with the Company’s expense reimbursement policy, for all reasonable out-of-pocket business and travel expenses incurred and paid by the Employee during the Employment Term and in connection with the performance of the Employee’s duties hereunder.
Education and Training The foundation of this Program is education and voluntary compliance. It is recognized that alcohol and chemical dependency may make voluntary cessation of use difficult, and one of the Program’s principal aims is to make voluntary steps toward ending substance abuse easily available. The outside contractor shall review and develop on-going educational and training information on the adverse consequences of substance abuse and the responsibility to avoid being under the influence of alcohol or chemicals at work. Certain training required by the DOT Regulations shall be the responsibility of the Substance Abuse Program.
Synchronous Generation The Interconnection Customer shall design its Small Generating Facility to maintain a composite power delivery at continuous rated power output at the Point of Interconnection at a power factor within the range of 0.95 leading to 0.95 lagging, unless the NYISO or the Transmission Owner in whose Transmission District the Small Generating Facility interconnects has established different requirements that apply to all similarly situated generators in the New York Control Area or Transmission District (as applicable) on a comparable basis, in accordance with Good Utility Practice.
Customer Support and Training System Agency will provide support for the CMBHS, including problem tracking and problem resolution. System Agency will provide telephone numbers for Grantees to obtain access to expert assistance for CMBHS-related problem resolution. System Agency will provide initial CMBHS training. Grantee shall provide subsequent ongoing end-user training.
Non-Synchronous Generation The Interconnection Customer shall design its Small Generating Facility to maintain a composite power delivery at continuous rated power output at the high-side of the generator substation at a power factor within the range of 0.95 leading to 0.95 lagging, unless the NYISO or the Transmission Owner in whose Transmission District the Small Generating Facility interconnects has established a different power factor range that applies to all similarly situated non-synchronous generators in the control area or Transmission District (as applicable) on a comparable basis, in accordance with Good Utility Practice. This power factor range standard shall be dynamic and can be met using, for example, power electronics designed to supply this level of reactive capability (taking into account any limitations due to voltage level, real power output, etc.) or fixed and switched capacitors, or a combination of the two. This requirement shall only apply to newly interconnecting non-synchronous generators that have not yet executed a Facilities Study Agreement as of September 21, 2016.
