Installation and Maintenance of Security System Sample Clauses

Installation and Maintenance of Security System. Subject to survey recommendations, DS will install standard security systems at Defense Component offices at post upon request of the DOD Executive Agent, either by using Security Engineering Officers, Seabees, or Security Engineering Contractors or other cleared U.S. contractors. Equipment installed shall either be procured by DOD Component Offices at post or obtained from the DS inventory. The maintenance of standard DS technical security equipment at Defense Component offices at post will be included in the DS Security Engineering Maintenance Program. The maintenance of non-standard equipment, which is not in DS inventory, will be the responsibility of the post Defense Component office. In cases where Defense Components require technical equipment which is non-standard to the DOS inventory, the local Defense Component office will procure, install and maintain the equipment at its own cost. Non-standard technical equipment will only be used if a DS Security Engineering Officer certifies that it will not interfere with any standard DOS equipment installed. The Defense Component office, with DS concurrence, may contract separately for maintenance of security systems at remote sites which require extensive maintenance of a timely and frequent nature.
Sample 1
AutoNDA by SimpleDocs

Related to Installation and Maintenance of Security System

  • Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.

  • Construction and Maintenance There are on-going maintenance, renovation and construction projects taking place in and around the residences. The work typically takes place during regular business hours, but may begin earlier or extend into evenings or weekends. On-going construction or renovation projects will continue through midterm and final exam periods. The University will take measures to ensure that prudent construction practices are followed, but there may be noise, dust and temporary interruption of some services. Residents may be required to temporarily or permanently relocate to facilitate construction or renovation to their residence area. There will be no compensation or reduction to your residence fees due to disruption and/or relocation.

  • Supply and Maintenance of Equipment It is the responsibility of the Employer to furnish and maintain all equipment, machinery and supplies required by employees in the performance of their duties. Employees shall not suffer any loss in salary in the event that they cannot carry out their normal duties by reason of the Employer failing to properly maintain equipment, machinery or supplies or by reason of power failures or other circumstances not attributable to the employees.

  • Operation and Maintenance 17.1 O&M obligations of the Concessionaire

  • Road Maintenance Purchaser shall maintain roads, commensurate with Purchaser’s use, in accor- dance with Road Maintenance Requirements in C5.31 and the Road Maintenance Specifications. Performance of road maintenance work by Purchaser may be required prior to, during, or after each period of use. The timing of work accomplishment shall be based on Purchaser’s Op- erating Schedule under B6.31. When two or more commercial users are simultane- ously using the same road where Forest Service is not requiring maintenance deposits, the commercial users will develop maintenance responsibilities and arrangements for accomplishing the work. Forest Service must agree to this plan. If the commercial users cannot agree on main- tenance responsibilities, Forest Service shall resolve the differences. If Purchaser elects to use different roads than those listed in C5.31, Forest Service shall determine Pur- chaser’s commensurate share of road maintenance and revise road maintenance deposits in C5.32. If Forest Service cannot perform its full commensu- rate share of road maintenance, Forest Service shall make a cash payment to Purchaser for performance of such work. Unless agreed in writing, prehaul maintenance shall be completed on any portion of road prior to hauling on that portion. Maintenance, as used in this contract, does not include road reconstruction or repairs of an extraordi- nary nature.

  • Installation, Inspection, and Maintenance The Contractor is responsible for installation and maintenance of the BMPs as a part of its Bid. The Design Professional shall obtain the services of a qualified testing laboratory to inspect the BMPs in accordance with the permits, the costs of such inspections to be borne by the Owner. In the event of Abnormal Weather Conditions or force majeure, the Contractor shall be compensated for re-installation of BMPs at established Unit Prices.

  • Installation and Use You may install and use the Software only for the number of licenses acquired by you. In order to exercise your rights to the Software under this Agreement, you must activate your copy of the Software in the manner described during the launch sequence.

  • Maintenance of Services 5.1 Services resold pursuant to this Attachment and BellSouth’s General Subscriber Service Tariff and Private Line Service Tariff and facilities and equipment provided by BellSouth shall be maintained by BellSouth.

  • Project Maintenance The Local Government shall be responsible for maintenance of locally owned roads and locally owned facilities after completion of the work. The State shall be responsible for maintenance of the state highway system after completion of the work if the work was on the state highway system, unless otherwise provided for in existing maintenance agreements with the Local Government.

  • Operation and Maintenance Manuals Receipts for transmittal of Operation and Maintenance Manuals, Brochures and Data to the Design Professional (or Commissioning Agent) as required by Section 6.1.1.5.

Time is Money Join Law Insider Premium to draft better contracts faster.