Drying time and temperature Sample Clauses

Drying time and temperature.Β The drying time as well as drying temperature must be followed for all coating processes (zinc dust priming, priming as well as top coating) in accordance with manufacturer's specifications. This is the only way that the best possible corrosion protection can be ensured.

Related to Drying time and temperature

  • Temperature Where low temperature and/or self-service cases are used for any of such merchandise coming under the jurisdiction of the Union, such cases shall be served only by employees covered by this Agreement.

  • TRANSPORTATION, TRAVEL TIME AND ROOM AND BOARD 15.01 The Employer shall remunerate employees for travel time and mileage as follows:

  • Receipt Points The Points of Receipt are listed in Appendix 2.

  • Meters 7.1.1 For installation of Meters, Meter testing, Meter calibration and Meter reading and all matters incidental thereto, the SPD and SECI shall follow and be bound by the Central Electricity Authority (Installation and Operation of Meters) Regulations, 2006, the Grid Code, as amended and revised from time to time.

  • Health plan specification The Employer will require health plans participating in the Group Insurance Program to develop and implement health promotion and health education programs for State employees and their dependents.

  • DELIVERY PRESSURE Seller agrees to use due care and diligence to furnish gas hereunder at such uniform pressure as Seller may elect up to, but not exceeding 20 pounds per square inch gauge, and not less than 2 pounds per square inch gauge, at the "Point of Delivery" . Buyer shall be responsible for the installation and operation of adequate safety equipment downstream of the Point of Delivery so as to relieve or control pressure vari ations within the limits described above that may, for any reason through malfunction of Seller's equipment or otherwise, occur on Buyer's side of the "Delivery Point". TRANSPORTATION SERVICE

  • Signaling Parameters All SS7 signaling parameters will be provided in conjunction with traffic exchange trunk groups, where and as available. These parameters include Automatic Number Identification ("ANI"), Calling Party Number ("CPN"), Privacy Indicator, calling party category information, originating line information, charge number, etc. Also included are all parameters relating to network signaling information, such as Carrier Information Parameter ("CIP"), wherever such information is needed for call routing or billing. GTE will provide SS7 via GR-394-SS7 and/or GR-317-SS7 format(s).

  • Delivery Point (a) All Energy shall be Delivered hereunder by Seller to Buyer at the Delivery Point. Seller shall be responsible for the costs of delivering its Energy to the Delivery Point consistent with all standards and requirements set forth by the FERC, ISO-NE, the Interconnecting Utility and any other applicable Governmental Entity and any applicable tariff.

  • Delivery Points β€Œ Project water made available to the Agency pursuant to Article 6 shall be delivered to the Agency by the State at the delivery structures established in accordance with Article 10.

  • Compressed Work Week Notwithstanding the provisions of this Article, upon request of an employee and the concurrence of the Employer, an employee may complete their weekly hours of employment in a period of other than five (5) full days provided that over a period of twenty-eight (28) calendar days the employee works an average of thirty-seven decimal five (37.5) hours per week. As part of the provisions of this clause, attendance reporting shall be mutually agreed between the employee and the Employer. In every twenty-eight (28) day period such an employee shall be granted days of rest on such days as are not scheduled as a normal work day for such employee. Notwithstanding anything to the contrary contained in this Agreement, the implementation of any variation in hours shall not result in any additional overtime work or additional payment by reason only of such variation, nor shall it be deemed to prohibit the right of the Employer to schedule any hours of work permitted by the terms of this Agreement.