Union Conventions The chapter chairperson or his/her representative elected to attend a function of the International Union such as convention, or educational conferences, upon proper application, shall be allowed a total of five (5) days per year time off without loss of time or pay to attend such conference and/or conventions.
Convention Except as otherwise provided in this Conveyance, each calendar day, month, quarter and year shall be deemed to begin at 12:01 a.m. Central Time on the stated day or on the first day of the stated month, quarter or year, and to end at 12:00 a.m. Central Time on the next day or on first day of the next month, quarter or year, respectively.
Scope of the Convention Article 1
Day count convention Any interest, commission or fee accruing under a Finance Document will accrue from day to day and is calculated on the basis of the actual number of days elapsed and a year of 360 days or, in any case where the practice in the Relevant Interbank Market differs, in accordance with that market practice.
Business Day Convention If the date on which any payment is due to be made under this Agreement shall occur on a day on which is not a Business Day, such payment shall be made in accordance with the Business Day Convention as specified in the Notes or the Indenture.
File Naming Conventions Files will be named according to the following convention: {gTLD}_{YYYY-‐MM-‐DD}_{type}_S{#}_R{rev}.{ext} where:
Particular Methods of Procurement of Goods Works and Services (other than Consultants’ Services)
Conventions For purposes of this Article XIII, Party A means the Carrier from which a telephone number is Ported, and Party B means the carrier to which a telephone number is ported.
Other Methods of Procurement of Goods The following table specifies the methods of procurement, other than International Competitive Bidding, which may be used for goods. The Procurement Plan shall specify the circumstances under which such methods may be used: Procurement Method
Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.