Measurements and arithmetic conventions Sample Clauses

Measurements and arithmetic conventions. All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.
Measurements and arithmetic conventions. All measurements and calculations shall be in the metric system and calculations done to two (2) decimal places, with the third digit of five (5) or above being rounded up and below five (5) being rounded down.
Measurements and arithmetic conventions. 1.3.1 All measurements and calculations shall be in metric system and calculations done in 2 decimals places, with the third digit of 5 or above rounded up and below 5 belong down except in Fee calculation which shall be rounded off to nearest Indian Rupee Hundred (100).
Measurements and arithmetic conventions. All measurements and calculations shall be in the metric system and calculations done to two
Measurements and arithmetic conventions. All measurements and calculations shall be in metric system and calculations done to 2 decimal places, with the third digit of 5 or above being rounded up and below 5 being rounded down except in Xxxxxxxxx Charges calculation which shall be rounded off to nearest rupee.
Measurements and arithmetic conventions. 1.4.1 All measurements and calculations in respect of financial matters shall be in the metric system and calculations done to two (2) decimal places, with the third digit of five (5) or above being rounded up and below five (5) being rounded down, however all calculations in respect of technical matters shall be in SI/foot pound and second system in accordance with the provision of the SCHEDULE G (Detailed Project Report).
Measurements and arithmetic conventions. All measurements and calculations shall be in the metric system and calculations done to 2(two) decimal places, with the third digit of 5(five) or above being rounded up and below 5(five) being rounded down; provided that the drawings, engineering dimensions and tolerances may exceed 2 (two) decimal places, if required.
Measurements and arithmetic conventions. All measurements and calculations shall be in metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down. Ambiguities and Discrepancies In case of ambiguities or discrepancies within this Agreement, the following shall apply: between two Article of this Agreement, the provisions of specific Articles relevant to the issue under consideration shall prevail over those in other Articles; between any value written in numerals and that in words, the latter shall prevail; and between the provisions of this Agreement and any other documents forming part of it, the former shall prevail.
Measurements and arithmetic conventions. All measurements and calculations shall be in metric system and calculations done to 2 decimal places, with the third digit of 5 or above being rounded up and below 5 being rounded down. Ambiguities and Discrepancies In case of ambiguities or discrepancies within this Agreement, the following shall apply: