Hive inspection Sample Clauses

Hive inspection. In order to undertake inspection of established colony, first of all the beekeeper should have to be able to minimize the sting by using proper management and handling of honeybees. When approaching an established hive of bees with intent to open for inspection, the beekeeper does not move in to the line of flight of the worker bees leaving for and returning from the field. Always approach the hive from the side or from the back. In order to suppress (calm down) the bees, smoke of good quality shall be puffed into the entrance. A few good puffs of smoke create communication barriers in the guard bees and this in turn disorganizes the defense system of the hive. Using smoke also prompt the bees gorge themselves with honey and in this satiated condition they are less likely to sting. Wait one or two minutes for the smoke to penetrate to the corners of the hive to ensure that the disorganization of the colony is complete, before opening the hive. The first step to open the hive is to remove the outer cover, which is usually the telescopic type. This cover has its inner cover underneath which when in position still effectively seals the hive. The bees usually seal the inner cover with propolis, a sticky resin material. To break the propolis seal and to open the hive, the operator shall is forced hive tool into the line of the union between the lid (inner cover) and the adjacent hive body and at the cover. As the lid is first raised a few puffs of smoke must be forced into this opening. In the case of well-sealed lids it may be necessary to pry (force open) each of the corners in turn before the lid can be removed without damaging it. If the top hive body needs no inspection the inner cover can of course, be left in position. In this way excessive bee flight is prevented. After removing the outer cover, put up site down alongside the hive. This makes a convenient rest on which to place hive bodies. These hive bodies must be placed across the unturned cover so that as few bees as possible are squashed. The inner cover and most other types of covers other than the telescopic type have to be levered up to get them off. When the inner cover removed, the colony is exposed from the top. A puff or two puffs of smoke blown across the top of the frames will induce the bees to go down into the hive body. Then by using hive tool (chisel), open the hive, put the hive cover up side along side of the hive and smoke horizontally and periodically, start inspection from the fra...
AutoNDA by SimpleDocs

Related to Hive inspection

  • MOVE-IN INSPECTION Before, at the time of the Tenant accepting possession, or shortly thereafter, the Landlord and Tenant: (check one) ☐ - Agree to inspect the Premises and write any present damages or needed repairs on a move-in checklist. ☐ - Shall not inspect the Premises or complete a move-in checklist.

  • SITE INSPECTION Where a site inspection is required by the Bid Specifications or Project Definition, Bidder shall be required to inspect the site, including environmental or other conditions for pre-existing deficiencies that may affect the installed Product, equipment, or environment or services to be provided and, which may affect Bidder’s ability to properly deliver, install or otherwise provide the required Product. All inquiries regarding such conditions shall be made in writing. Bidder shall be deemed to have knowledge of any deficiencies or conditions which such inspection or inquiry might have disclosed. Bidder must provide a detailed explanation with its Bid if additional work is required under this clause in order to properly complete the delivery and installation of the required Product or provide the requested service.

  • IN INSPECTION Before, at the time of the Tenant accepting possession, or shortly thereafter, the Landlord and Tenant: (check one) ☐ - Agree to inspect the Premises and write any present damages or needed repairs on a move-in checklist. ☐ - Shall not inspect the Premises or complete a move-in checklist.

  • Records Inspection Payor shall keep, and shall require its Permitted Sellers to keep, complete, true and accurate books of accounts and records for the purpose of determining the basis and accuracy of payments to be made under this Agreement. Such records shall be kept in accordance with GAAP, showing Net Sales on country-by-country and Licensed Product-by-Licensed Product basis, and Payor’s or its Permitted Sellers’ usual internal practices and procedures (which shall be commercially reasonable), consistently applied. Such books and records shall be kept for at least [*] ([*]) years following the end of the Calendar Quarter to which they pertain. Such records will be open for inspection by Payee during such five (5) year period by independent accountants reasonably acceptable to Payor, solely for the purpose of verifying the basis and accuracy of amounts in the payment statements hereunder. Such inspections shall be made no more than [*] each Calendar Year, at reasonable time and on reasonable notice and shall be limited to information related to Licensed Products. Results of any such inspection shall be deemed to be Confidential Information of Payor. If any errors in favor of Payor are discovered in the course of such inspection, then within thirty (30) days of written request by Payee, Payor shall pay Payee those amounts that Payee would have received in the absence of such errors, plus interest pursuant to and in accordance with Section 6.1(c). Inspections conducted under this Section 6.5 shall be at the expense of Payee, unless a variation or error in favor of Payor exceeding [*] percent ([*] %) of the amount due for the period covered by the inspection is established in the course of such inspection, whereupon all reasonable, documented costs relating to the inspection for such period will be paid promptly by Payor. In the event of overpayment to Payee, any amount of such overpayment shall be fully creditable against amounts payable for the immediately succeeding Calendar Quarter.

  • Goods Inspection The Commissioner of DAS, in consultation with the Client Agency, shall determine the manner and prescribe the inspection of all Goods and the tests of all samples submitted to determine whether they comply with all of the specifications in the Contract. If any Goods fail in any way to meet the specifications in the Contract, the Client Agency or the Commissioner of DAS may, in its sole discretion, either reject it and owe nothing or accept it and pay for it on an adjusted price basis, depending on the degree to which the Goods meet the specifications. Any decision pertaining to any such failure or rejection shall be final and binding.

  • Safety Inspection During inspection of County facilities conducted by the State Division of Occupational Safety and Health for the purpose of determining compliance with the California OSHA requirements, an OCEA designated employee shall be allowed to accompany the inspector while the inspector is in the employee's agency/department. The employee so designated shall suffer no loss of pay when this function is performed during the employee's regularly scheduled work hours.

  • Vehicle Inspection All State agencies must have a formal vehicle inspection program for State vehicles to assure that vehicles are clean, properly equipped, maintained, and in good repair. Each program must provide:

  • Move-in; Inspection; Delay Before Resident may access or occupy the premises, any required installments or other payments then due (including any Administrative Fee, which is earned and payable upon mutual execution of this Agreement) must be paid in full with cleared funds and guaranty or prepayment requirements satisfied. The application fee (if any) is non-refundable and is not applicable toward any other payments required of Resident under this Agreement. Prior to Resident’s taking possession of the assigned bedroom space (and any re-assigned bedroom space), Resident will conduct an inspection of the assigned bedroom space and apartment and will note on the Check-In/Check-Out Inspection Report (“Inspection Report”) any defects, damage or other conditions observed, if not already identified by Owner on such report; upon completion and approval by Owner, the Inspection Report will become part of this Agreement. At the time of move-out, Resident is encouraged to inspect the bedroom space and apartment with Owner’s representative by making an appointment during business hours at least 48 hours in advance. Within three business days following Resident’s move-out (or, as applicable, following the move-out of all residents of an apartment) at the termination of this Agreement, or within a reasonable time if Resident moves out without notifying Owner, Owner will note the then-present condition of the assigned bedroom space and apartment, including all appliances and fixtures, and any damages incurred and/or extraordinary cleaning deemed necessary by Owner or extraordinary wear as determined by Owner. Resident will promptly pay all costs of restoring the bedroom space and apartment to the same condition upon move-in, less normal wear. Resident acknowledges that except as provided in the Inspection Report, each bedroom space and apartment are being delivered in "as-is" condition, and Resident’s acceptance of the assigned bedroom space and apartment at the beginning of the Term constitutes Resident’s acknowledgment that the bedroom space and apartment and all fixtures are in good repair and condition. Owner will not be responsible for any damages or consequences suffered by Resident as a result of Owner’s inability to timely deliver possession of the apartment or assigned bedroom space to Resident on the anticipated Start Date; in such event, the rent payable will be abated until Owner tenders possession and such delay will not extend or decrease the term or change the End Date. Resident acknowledges that any model apartment at the Property shown to Resident in person, online or through other means is intended to be representative of the general quality and type of construction and materials within apartments. Specific items of décor and furnishings and the actual colors, styles, materials, upholstery and other treatments in the apartment assigned to Resident may vary from those in the model apartment. The actual apartment assigned to Resident may also vary in approximate size, square footage and layout. Resident’s apartment will not include custom lighting, lamps, decorations, linens, unattached appliances or other personal property as may be shown in the model apartment.

  • Inspection The Issuer shall, with reasonable prior notice, permit any representative of the Indenture Trustee, during the Issuer’s normal business hours, to examine the books of account, records, reports and other papers of the Issuer, to make copies and extracts therefrom, to cause such books to be audited by Independent certified public accountants, and to discuss the Issuer’s affairs, finances and accounts with the Issuer’s officers, employees, and Independent certified public accountants, all at such reasonable times and as often as may be reasonably requested. The Indenture Trustee shall and shall cause its representatives to hold in confidence all such information except to the extent disclosure may be required by law (and all reasonable applications for confidential treatment are unavailing) and except to the extent that the Indenture Trustee may reasonably determine that such disclosure is consistent with its obligations hereunder.

  • TESTING AND INSPECTION 6.1 Pre-Commercial Operation Date Testing and Modifications

Time is Money Join Law Insider Premium to draft better contracts faster.