DESIGN’ISH Tools Sample Clauses

DESIGN’ISH Tools. All DESIGN’ISH Tools are and shall remain the exclusive property of DESIGN’ISH. DESIGN’ISH hereby grants to Client a nonexclusive, nontransferable (other than the right to sublicense such uses to Client’s web hosting or internet service providers), perpetual, worldwide license to use the DESIGN’ISH Tools solely to the extent necessary with the Final Deliverables for the Project. Client may not directly or indirectly, in any form or manner, decompile, reverse engineer, create derivative works or otherwise disassemble or modify any DESIGN’ISH Tools comprising any software or technology of DESIGN’ISH.
Sample 1
AutoNDA by SimpleDocs
DESIGN’ISH Tools. Subject to the representations and warranties of the Client in connection with the materials supplied by Client, DESIGN’ISH represents and warrants that, to the best of DESIGN’ISH’s knowledge, the DESIGN’ISH Tools do not knowingly infringe the rights of any third party, and use of same in connection with the Project will not knowingly violate the rights of any third parties except to the extent that such violations are caused by Client Content, or the modification of, or use of the Deliverables in combination with materials or equipment outside the scope of the applicable specifications, by Client or third parties.
Sample 1

Related to DESIGN’ISH Tools

  • Hand Tools The MOA will provide common hand tools of the trade, which the MOA deems necessary to complete the work assigned. The MOA will not be responsible for hand tools personally owned by an employee and used at the employee’s discretion.

  • Licensed Materials The materials that are the subject of this Agreement are set forth in Appendix A ("Licensed Materials").

  • WORK TOOLS 5.01 All Employees must have all the necessary hand tools listed in the Master Agreement (Employee Tool List). Replacement will be the responsibility of the Employee. APPENDIX TO THE ONTARIO PROVINCIAL AGREEMENT OF THE I.C.I. SECTOR OF THE CONSTRUCTION INDUSTRY FOR OSHAWA, LOCAL 1832, TERRITORIAL JURISDICTION AS FOLLOWS: COUNTIES OF DURHAM AND THAT PORTION OF ONTARIO NOT INCLUDED UNDER TORONTO LOCAL 1819 TERRITORIAL JURISDICTION.

  • Licensed Software Computer program(s) provided by Contractor in connection with the Deliverables, subject to Section 14 of this Contract.

  • Software Title and ownership to Existing Software Product(s) delivered by Contractor under the Contract that is normally commercially distributed on a license basis by the Contractor or other independent software vendor proprietary owner (“Existing Licensed Product”), embedded in the Custom Products, shall remain with Contractor or the proprietary owner of other independent software vendor(s) (ISV). Effective upon acceptance, such Product shall be licensed to Authorized User in accordance with the Contractor or ISV owner’s standard license agreement, provided, however, that such standard license, must, at a minimum: (a) grant Authorized User a non-exclusive, perpetual license to use, execute, reproduce, display, perform, adapt (unless Contractor advises Authorized User as part of Contractor’s proposal that adaptation will violate existing agreements or statutes and Contractor demonstrates such to the Authorized User’s satisfaction) and distribute Existing Licensed Product to the Authorized User up to the license capacity stated in the Purchase Order or work order with all license rights necessary to fully effect the general business purpose(s) stated in the Bid or Authorized User’s Purchase Order or work order, including the financing assignment rights set forth in paragraph (c) below; and (b) recognize the State of New York as the licensee where the Authorized User is a state agency, department, board, commission, office or institution. Where these rights are not otherwise covered by the ISV’s owner’s standard license agreement, the Contractor shall be responsible for obtaining these rights at its sole cost and expense. The Authorized User shall reproduce all copyright notices and any other legend of ownership on any copies authorized under this clause. Open source software is developed independently of Contractor and may be governed by a separate license (“open source software”). If the open source software is governed by a separate License and provided under this Contract, Contractor shall provide a copy of that license in the applicable Documentation and the Authorized User's license rights and obligations with respect to that open source software shall be defined by those separate license terms and subject to the conditions, if any, therein. Nothing in this Contract shall restrict, limit, or otherwise affect any rights or obligations the Authorized User may have, or conditions to which the Authorized User may be subject, under such separate open source license terms.

  • Customer Materials 12.1 The Supplier including any of its employees, agents, consultants, contractors and any third party shall:

  • Hardware IF HARDWARE IS IDENTIFIED ON A TRANSACTION DOCUMENT, THE SALE AND USE OF THE HARDWARE WILL BE GOVERNED BY TERMS OTHER THAN THIS XXXX. OT DISCLAIMS ALL WARRANTIES AND LIABILITY WITH RESPECT TO THE HARDWARE.

  • Firmware The Contractor shall deliver firmware required for production acceptance testing in accordance with CDRL A009 Contractor’s Supplier Configuration Management Plan. The Contractor shall use Government furnished software for testing. Deliverable Data Item (See DD-1423): CDRL A009: “Contractor’s Supplier Configuration Management Plan”

  • Programming (a) Pursuant to Section 624 of the Cable Act, the Licensee shall maintain the mix, quality and broad categories of Programming set forth in Exhibit 4, attached hereto and made a part hereof. Pursuant to applicable federal law, all Programming decisions, including the Programming listed in Exhibit 4, attached hereto, shall be at the sole discretion of the Licensee.

  • User 4.9.1 Not to use the Property otherwise than for the Permitted Use;

Time is Money Join Law Insider Premium to draft better contracts faster.