DESCRIPTION OF SERVICES (SCOPE OF WORK Sample Clauses

DESCRIPTION OF SERVICES (SCOPE OF WORK. VENDOR shall supply all required payment and performance bonds and shall pay employees applicable prevailing wages in accordance with state and federal law where required. VENDOR shall furnish, at its own expense, all labor, materials, equipment and other items necessary to carry out the terms of this Agreement. VENDOR shall provide the following services to DISTRICT: (Additional pages may be added and shall be marked Exhibit “A” and are incorporated herein by this reference).
Sample 1Sample 2Sample 3See All (7)
AutoNDA by SimpleDocs
DESCRIPTION OF SERVICES (SCOPE OF WORK. Any amendments, additions, or other executed items performed by the parties to supplement this agreement, will be automatically incorporated into this agreement.
Sample 1Sample 2Sample 3
DESCRIPTION OF SERVICES (SCOPE OF WORK. Part 1 –
Sample 1Sample 2Sample 3

Related to DESCRIPTION OF SERVICES (SCOPE OF WORK

  • Description of Services (a) Services Provided on an Ongoing Basis, If Applicable.

  • Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.

  • Scope of Work The Contractor has overall responsibility for and shall provide and furnish all materials, equipment, tools and labor as necessary or reasonably inferable to complete the Work, or any phase of the Work, in accordance with the Owner’s requirements and the terms of the Contract Documents.

  • Statement of Work The Contractor shall provide the services and staff, and otherwise do all things necessary for or incidental to the performance of work, as set forth below:

  • CORRECTION OF WORK 13.2.1 The Contractor shall be responsible for correcting all Work which the Architect has found to be defective or which fails to conform to the Contract Documents whether observed be- fore or after Substantial Completion and whether or not fabricated, installed or completed. The Contractor shall bear all costs of correcting such rejected Work, including compensation for the Architect's and the State’s additional services made necessary thereby. The Architect, upon a finding of defect or failure to conform, shall immediately notify the State and Contractor, in writing, of the defect. The Contractor shall begin correcting the defective or non-conforming Work within ten (10) days unless the State agrees to a Change Order which reflects the reduction in Contract Sum due to the value of diminishment of the defective or nonconforming Work.

Time is Money Join Law Insider Premium to draft better contracts faster.