Densitometer Sample Clauses

Densitometer. Where installed, the flowing density of the stream shall be determined by the continuous use of a densitometer of standard make installed in accordance with MPMS Chapter 14.6 and the manufacturer's recommendations and operated so that the instrument will properly measure the density of the fluid at flowing pressure and temperature.
AutoNDA by SimpleDocs
Densitometer. Im Densitomter wird die Ausgabeorientierung des Bildes festgelegt und der aktuelle Scanrahmen als Miniatur dargestellt. Mit dem Umschalt-Xxxxx „Pixel-Lupe/Übersicht“ wird der Inhalt des kleinen Quadrates aus der Hand des Mauszeigers vergrößert angezeigt. Die untere Hälfte dient zur Kontrolle der Farbwerte. Links werden die „Vorher“- und rechts die „Nachher“-Farbe und deren Werte angezeigt.
Densitometer. The accuracy of the densitometer shall be verified Monthly by calibrating and proving the instrument in accordance with the API MPMS Chapter 14, Section 6 and the manufacturer's recommendations. Two (2) provings shall be performed to establish the densitometer correction factor. The determined densitometer correction factor thus obtained shall be applied to the Daily registered meter reading. The average of the two provings shall be taken as the densitometer correction factor if the two provings are within 0.05% of each other. A densitometer shall not be removed from service for maintenance without first proving such densitometer. The densitometer correction factor so determined shall be used in accordance with Paragraph 7(A) of this Exhibit, FACTOR DEVIATION.
Densitometer. You can set the image output orientation in the densitometer pallet. The image orientation will be shown by a small image of the current scan frame. With the toggle button “Pixel-Zoom/Overview“ you can switch to pixel zoom, monitoring the small area with regard to the position of the mouse. The lower half of the pallet serves to monitor the clour values. Left showing “Before“- and right the “After“ colour and their corresponding colour values.
Densitometer. The densitometer will measure density in grams per cubic centimeter at flowing conditions.

Related to Densitometer

  • Temperature Where low temperature and/or self-service cases are used for any of such merchandise coming under the jurisdiction of the Union, such cases shall be served only by employees covered by this Agreement.

  • Speed The relative importance we attach is “high”.

  • Cost of Metering The Issuer shall not be obligated to pay any costs associated with the routine metering duties set forth in this Section 2, including the costs of installing, replacing and maintaining meters, nor shall the Issuer be entitled to any credit against the Servicing Fee for any cost savings realized by the Servicer as a result of new metering and/or billing technologies.

  • Electrical Provide drawings for the following systems:

  • Metering The Interconnection Customer shall be responsible for the Connecting Transmission Owner’s reasonable and necessary cost for the purchase, installation, operation, maintenance, testing, repair, and replacement of metering and data acquisition equipment specified in Attachments 2 and 3 of this Agreement. The Interconnection Customer’s metering (and data acquisition, as required) equipment shall conform to applicable industry rules and Operating Requirements.

  • Configuration The configuration for the Purchase Right Aircraft will be the Detail Specification for Model 767-3S2F aircraft at the revision level in effect at the time of the Supplemental Agreement. Such Detail Specification will be revised to include (i) changes required to obtain required regulatory certificates and (ii) other changes as mutually agreed upon by Boeing and Customer.

  • Fuel 28.1 The Vehicle must be returned with the amount of fuel equal to that at the time of the commencement of the rental. If the Vehicle is returned with less fuel, the difference will be charged to You at a rate of $5.00 including GST per litre (which includes a service component).

  • HEATING The Hirer shall ensure that no unauthorised heating appliances shall be used on the premises when open to the public without the consent of the management committee. Portable Liquefied Propane Gas (LPG) heating appliances shall not be used.

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.

  • Generator Subject to the provisions of this Section 29.36, Tenant shall be entitled to install, operate and maintain a generator and any other equipment related thereto, including, without limitation, a fuel system, wiring and shaft space (“Generator”) next to the Building at Tenant’s sole cost and expense (without paying any additional fee or rental to Landlord for the use thereof). Prior to the installation of the Generator, Tenant shall inspect the proposed location to determine a suitable location for the Generator, and Tenant shall submit written plans and specifications relative to the type, size and proposed location (including any proposed screening) of the Generator to Landlord for its review and written approval. Tenant shall be solely responsible for the cost of acquisition, installation, operation, and maintenance of the Generator; and Tenant shall install, maintain and operate the Generator in accordance with all federal, state, and local laws, statutes, ordinances, rules and regulations, including without limitation, obtaining and maintaining any and all permits, approvals and licenses required to install and operate the Generator by any governmental authority having jurisdiction. Landlord and Tenant agree that, upon the expiration of earlier termination of the Lease Term, Tenant shall not be required to remove the Generator, any associated cabling, wiring and screening or other improvements. Tenant shall not be entitled to grant or assign to any third party (other than a permitted assignee of Tenant’s rights under the Lease or a permitted subtenant relative to the Premises (or a portion thereof)) the right to use the Generator without Landlord’s prior written consent (which consent may be granted or withheld in Landlord’s discretion). Upon reasonable advance notice to Tenant (and provided Landlord reasonably coordinates with Tenant and provides an alternate source of backup generator capacity during said transition), Landlord shall be entitled to cause the Generator to be moved to another location near the Building, at Landlord’s cost and expense. Tenant shall pay all personal property taxes on the Generator. Tenant shall also pay any increases in the real property taxes of the Building due to the installation of the Generator within thirty (30) days of receipt of notice from Landlord which includes proof of such increase in taxes. Tenant’s indemnity obligations under Section 5.4.1.5 of the Lease, relating to the use of Hazardous Materials, shall apply to the use and operation of the Generator. Finally, Tenant’s insurance obligations under Section 10.3 of the Lease shall apply to the Generator.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!