Ceiling Weights Sample Clauses

Ceiling Weights. The overhead structure is designed for a dead load of 7 pounds per square foot. TENANT shall provide at TENANT’S expense, and subject to BUILDING MANAGEMENT’S approval, special support and bracing to accommodate greater ceiling weights.
AutoNDA by SimpleDocs

Related to Ceiling Weights

  • Ceiling 8.5.1 Single Tenanted Floors

  • Ceilings The obligation of Sellers to indemnify the Buyer Indemnitees pursuant to (A) Sections 9.02(a)(i) (other than with respect to any breach of the Fundamental Representations, a failure to perform any Post-Closing Covenant or the special warranty contained in Section 3.01(c)) shall not exceed, in the aggregate fifteen percent (15%) of the unadjusted Purchase Price, and (B) Section 9.02(a)(viii) shall not, with respect to any Property affected by the failure to obtain the applicable Third Party Consent, exceed the Allocated Value of such Property.

  • Weights The weight of the coal delivered hereunder shall be determined on a per shipment basis by Buyer on the basis of scale weights at the generating station(s) unless another method is mutually agreed upon by the parties. Such scales shall be duly reviewed by an appropriate testing agency and maintained in an accurate condition. Seller shall have the right, at Seller’s expense and upon reasonable notice, to have the scales checked for accuracy at any reasonable time or frequency. If the scales are found to be over or under the tolerance range allowable for the scale based on industry accepted standards, either party shall pay to the other any amounts owed due to such inaccuracy for a period not to exceed thirty (30) days before the time any inaccuracy of scales is determined.

  • Walls Sheetrock (drywall) damage should be patched and fire-taped so that there are no holes in either office or warehouse.

  • Configuration The configuration for the Purchase Right Aircraft will be the Detail Specification for Model 767-3S2F aircraft at the revision level in effect at the time of the Supplemental Agreement. Such Detail Specification will be revised to include (i) changes required to obtain required regulatory certificates and (ii) other changes as mutually agreed upon by Boeing and Customer.

  • Rentable Area 6.1. The term “

  • Partitions (a) Partitions within the Premises shall have 2” gypsum board on each sided of 3-5/8” metal studs, 16’ on center, taped and spackled. Partitions between the Premises, corridor(s) and between the Premises and adjacent space, shall have 5/8” fire code gypsum board, taped and spackled, on each side of 3-5/8” metal studs, 16” on center above finished ceiling to underside of metal deck. Demising partitions and corridor partitions to have thermofibre insulation installed within, and to be constructed from floor to underside of metal deck above.

  • Temperature The Committed Gas shall not have a temperature of less than forty degrees Fahrenheit (40°F) nor more than one hundred twenty degrees Fahrenheit (120°F).

  • MULTIPLE BUILDINGS If the Premises are part of a group of buildings controlled by Lessor, Lessee agrees that it will abide by, keep and observe all reasonable rules and regulations which Lessor may make from time to time for the management, safety, care, and cleanliness of the grounds, the parking and unloading of vehicles and the preservation of good order, as well as for the convenience of other occupants or tenants of such other buildings and their invitees, and that Lessee will pay its fair share of common expenses incurred in connection therewith.

  • FLOORING Grade and quality of carpeting to be selected by Landlord, with color to be selected by Tenant from those offered by Landlord.

Time is Money Join Law Insider Premium to draft better contracts faster.