Ceiling Heights definition

Ceiling Heights. Tenant’s responsibility as to clear height from floor slab. 4. Roof: The roof is of single ply material type, or equal, as provided within the existing Gateway project.
View Source
Ceiling Heights. Standard height 8'-4" in common areas. • Perimeter offices 8'-10", • Ceiling heights are approximate and are subject to change based on existing building infrastructure.
View Source
Ceiling Heights. Clean Room Area; 27' clear Manufacturing Area; 27' clear in one section, and 12' clear in another section. ================================================================================
View Source

Examples of Ceiling Heights in a sentence

  • Ceiling Heights: Tenant’s responsibility as to clear height from floor slab.

  • Ceiling Heights: Ceilings in Manufacturing Assembly area to be a minimum of 9’-3’ clear AFF.

  • Ceiling Heights: Clear ceiling heights are approximately 12'-2" feet at ground floor tenant areas, and approximately 9'-2" at floors 2, 3, 4 and 5 tenant areas.

  • Ceiling Heights in the MDF, IDF or other equipment rooms shall be a minimum of 8’-6” clear and have sufficient space above the ceiling for independent HVAC units, ducting, cable trays, or other necessary devices.

  • Slab to Slab Height 14' - 0" Ceiling Heights 11' finished ceiling in lobby and 9' finished ceiling in office areas.

  • Block/Lot 147 / 1101 Frontage ±25’ building width, commercial storefront is approximately 20’ wide Floor Area ±1,883 ground floor ±1,849 sub-cellar ±3,732 total square feet Ceiling Heights ±15’ ground floor ±8-10’ lower level Zoning C6-2A / TMU (Tribeca Mixed-Use Special District) Permitted Uses & Restrictions The commercial unit may be used for any permitted use according to zoning regulations and the condominium certificate of occupancy, declaration and by-laws including zoning use groups 6 and ▇▇.


More Definitions of Ceiling Heights

Ceiling Heights. If your existing building has 8’­0” or higher ceiling heights there shouldn’t be any issues, but if a ceiling is lower in parts or throughout a floor level then this can become a sticking issue.
View Source