Test Readiness Review - The Test Sample Clauses

Test Readiness Review - The Test. Readiness Review (TRR) is a series of tests to be conducted in coordination with the Authority, Consultant and General Contractor as outlined in the TSA Site Specific Test Plan (SSTP) and witnessed and validated by TSA and/or a TSA contractor to ensure that the project CBIS is ready for the Testing and Commissioning phases. Once the Test Readiness Review has been issued by the Authority, Consultant and General Contractor will follow TSA change management processes outlined in TSA PGDS. The Authority, Consultant and General Contractor will coordinate and provide a benchmarked copy of the Programmable Logic Controller (PLC) programming to TSA at the following project milestones: • Pre-TRR • Pre-ISAT • Post-ISAT • Post-Operational Run-In
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs
Test Readiness Review - The Test. Readiness Review (TRR) is a series of tests to be conducted in coordination with the Authority, Consultant and General Contractor as outlined in the TSA Site Specific Test Plan (SSTP) and witnessed and validated by TSA and/or a TSA contractor to ensure that the project CBIS is ready for the Testing and Commissioning phases. Once the Test Readiness Review has been issued by the Authority, Consultant and General Contractor will follow TSA change management processes outlined in TSA PGDS. HCAA Project Number 5991 14 Checked Baggage Upgrades and Optimization Design Team Scope or Work The Authority, Consultant and General Contractor will coordinate and provide a benchmarked copy of the Programmable Logic Controller (PLC) programming to TSA at the following project milestones: • Pre-TRR • Pre-ISAT • Post-ISAT • Post-Operational Run-In
Sample 1

Related to Test Readiness Review - The Test

  • ACCEPTANCE TESTS 11.1 If the Contract provides acceptance tests for Goods and/or the result of Services after their completion and/or delivery to the Purchaser, the acceptance shall only be considered as definitive when such tests have demonstrated the compliance of the Goods and/or the result of the Services to the requirements in the Contract.

  • Acceptance Testing At the time of installation of a LIS trunk group, and at no additional charge, acceptance tests will be performed to ensure that the service is operational and meets the applicable technical parameters.

  • Project Review A. Programmatic Allowances

  • Test The outer surface of the lamp lenses shall be subjected once or more than once to the action of the sand jet produced as described above. The jet shall be sprayed almost perpendicular to the surface to be tested. The deterioration shall be checked by means of one or more samples of glass placed as a reference near the lenses to be tested. The mixture shall be sprayed until the variation in the diffusion of light on the sample or samples measured by the method described in Appendix 2, is such that: Δ d = (T5 - T4) / T2 ≤ 0.0250 ± 0.0025 Several reference samples may be used to check that the whole surface to be tested has deteriorated homogeneously. Annex 6 - Appendix 4

  • Inspection/Testing All Products sold pursuant to this Agreement will be subject to inspection/testing by or at the direction of H- GAC and/or the ordering Customer, either at the delivery destination or the place of manufacture. In the event a Product fails to meet or exceed all requirements of this Agreement, and unless otherwise agreed in advance, the cost of any inspection and/or testing, will be the responsibility of the Contractor.

Time is Money Join Law Insider Premium to draft better contracts faster.