Responsibilities 1. Subject to the provisions of this Agreement, BNY shall with respect to each Specified Country select an Eligible Foreign Custodian. In connection therewith, BNY shall: (a) determine that assets of the Funds held by such Eligible Foreign Custodian will be subject to reasonable care, based on the standards applicable to custodians in the relevant market in which such Eligible Foreign Custodian operates, after considering all factors relevant to the safekeeping of such assets, including, without limitation, those contained in paragraph (c)(1) of the Rule; (b) determine that the Funds’ foreign custody arrangements with each Eligible Foreign Custodian are governed by a written contract with the Custodian which will provide reasonable care for the Funds’ assets based on the standards specified in paragraph (c)(1) of the Rule; (c) determine that each contract with an Eligible Foreign Custodian shall include the provisions specified in paragraph (c)(2)(i)(A) through (F) of the Rule or, alternatively, in lieu of any or all of such (c)(2)(i)(A) through (F) provisions, such other provisions as BNY determines will provide, in their entirety, the same or a greater level of care and protection for the assets of the Funds as such specified provisions; (d) monitor pursuant to the Monitoring System the appropriateness of maintaining the assets of the Funds with a particular Eligible Foreign Custodian pursuant to paragraph (c)(1) of the Rule and the performance of the contract governing such arrangement; and (e) advise the Funds whenever BNY determines under the Monitoring System that an arrangement (including, any material change in the contract governing such arrangement) described in preceding clause (d) no longer meets the requirements of the Rule.
RESPONSIBILITIES OF THE EMPLOYER 1. The Employer agrees to display the following notices supplied by DHS in a prominent place that is clearly visible to prospective employees and all employees who are to be verified through the system:
Responsibilities of the Parties 1.5.1 The Parties shall perform all obligations of this Agreement in accordance with all Applicable Laws and Regulations, Operating Requirements, and
Responsibilities of the Recipient Section 3.01. The Recipient shall cooperate with the Administrator, the Bank and the Consultants to ensure that the Technical Assistance is carried out promptly and effectively and, for this purpose, shall issue appropriate instructions to its officials, agents and representatives.
Capabilities A. The Parties agree that the DRE must possess the legal, technical, and financial capacity to:
Testing Capabilities 7.2.2.10.2.1 LIS Acceptance Testing is provided where equipment is available, with the following test lines: seven-digit access to balance (100 type), milliwatt (102 type), nonsynchronous or synchronous, automatic transmission measuring (105 type), data transmission (107 type), loop-around, short circuit, open circuit, and non-inverting digital loop-back (108 type), and such other acceptance testing that may be needed to ensure that the service is operational and meets the applicable technical parameters.
Scope of Responsibilities The responsibilities of the Operating Committee shall be the following:
Responsibilities and Rights A. Nothing in this grievance procedure shall be construed to apply to matters for which an administrative remedy is provided before the Civil Service Commission. Where a matter within the scope of this grievance procedure is alleged to be both a grievance and an unfair labor practice under the jurisdiction of the XXX, the employee may elect to pursue the matter under either the grievance procedure herein provided, or by action before the XXX. The employee's election of either procedure shall constitute a binding election of the remedy chosen and a waiver of the alternative remedy.
RESPONSIBILITIES OF THE UNIVERSITY 1. The UNIVERSITY shall designate in writing a faculty member to coordinate with a designee of the FIELDWORK SITE.
RESTRICTIONS AND RESPONSIBILITIES 2.1 Customer will not, directly or indirectly: reverse engineer, decompile, disassemble or otherwise attempt to discover the source code, object code or underlying structure, ideas, know-how or algorithms relevant to the Services or any software, documentation or data related to the Services (“Software”); modify, translate, or create derivative works based on the Services or any Software (except to the extent expressly permitted by Company or authorized within the Services); use the Services or any Software for timesharing or service bureau purposes or otherwise for the benefit of a third; or remove any proprietary notices or labels.