REPORT ON IMPORTING MOTOR VEHICLES Sample Clauses

REPORT ON IMPORTING MOTOR VEHICLES. Not later than 18 months after regulations are first prescribed under section 2(e)(1)(B) of the Imported Vehicle Safety Compliance Act of 1988, the Secretary shall submit to Congress a report of the actions taken to carry out subchapter III of this chapter and the effectiveness of those ac- tions, including any testing by the Secretary under section 30146(c)(2) of this title. After the first report, the Secretary shall submit a report to Congress under this subsection not later than July 31 of each year. (Pub. L. 103–272, § 1(e), July 5, 1994, 108 Stat. 972.) HISTORICAL AND REVISION NOTES Revised Sec- tion Source (U.S. Code) Source (Statutes at Large) 30169(a) ...... 30169(b) ...... 15:1408. 15:1397 (note). Sept. 9, 1966, Pub. L. 89–563,§ 120, 80 Stat. 728; May 22,1970, Pub. L. 91–265, § 5, 84Stat. 263; Oct. 27, 1974,Pub. L. 93–492, § 110(b), 88 Stat. 1484. Oct. 31, 1988, Pub. L. 100–562, § 2(e)(4), 102 Stat. 2825. In subsection (a), before clause (1), the words ‘‘pre- pare and’’, ‘‘comprehensive’’, and ‘‘but not be restricted to’’ are omitted as unnecessary. In clause (1), the words ‘‘occurring in such year’’ are omitted as surplus. In clause (2), the words ‘‘in such year’’ are omitted as sur- plus. The words ‘‘under this chapter’’ are substituted for ‘‘Federal’’ for consistency in this chapter. In clause (3), the words ‘‘applicable Federal motor vehicle’’ are omitted as surplus. In clause (4), the word ‘‘all’’ is omitted as surplus. In clause (5), the words ‘‘including relevant policy recommendations’’ and ‘‘during such year’’ are omitted as surplus. In clause (6), the words ‘‘a statement of . . . including judicial decisions, settle- ments, or pending litigation during such year’’ are omitted as surplus. In clause (7), the word ‘‘motoring’’ is omitted as surplus. In clause (8), the words ‘‘The re- port required by subsection (a) of this section shall con- tain such’’ are omitted because of the restatement. The words ‘‘additional . . . as the Secretary xxxxx’’ and ‘‘several’’ are omitted as surplus. REFERENCES IN TEXT Section 2(e)(1)(B) of the Imported Vehicle Safety Compliance Act of 1988, referred to in subsec. (b), is sec- tion 2(e)(1)(B) of Pub. L. 100–562, which was set out as a note under section 1397 of Title 15, Commerce and Trade, prior to repeal by Pub. L. 103–272, § 7(b), July 5, 1994, 108 Stat. 1379. CHAPTER 303NATIONAL DRIVER REGISTER Sec. 30301. Definitions. 30302. National Driver Register. 30303. State participation. 30304. Reports by chi...
AutoNDA by SimpleDocs

Related to REPORT ON IMPORTING MOTOR VEHICLES

  • TEXAS MOTOR VEHICLE BOARD LICENSING All that deal in motor vehicles shall maintain current licenses that are required by the Texas Motor Vehicle Commission Code. If at any time during this Agreement term, any required Contractor license is denied, revoked, or not renewed, Contractor shall be in default of this Agreement, unless the Texas Motor Vehicle Board issues a stay or waiver. Contractor shall promptly provide copies of all current applicable Texas Motor Vehicle Board documentation to H-GAC upon request.

  • Motor Vehicle Allowance 5.1.1 Employees required by their employer to use their own vehicles for school business shall be paid an allowance of $0.62 per kilometre.

  • Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67

  • Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.

  • Motor Vehicles (i) Upon the Collateral Agent’s written request, each Grantor shall deliver to the Collateral Agent originals of the certificates of title or ownership for each motor vehicle with a value in excess of $10,000 owned by it, with the Collateral Agent listed as lienholder, for the benefit of the Noteholders.

  • Xxxxx-Xxxxx Act compliance IF proposing on PART 2, Texas Statute requires compliance with Xxxxx-Xxxxx Act, as amended (40 U.S.C. 3141- 3148). When required by Federal program legislation, all prime construction contracts in excess of $2,000 awarded by non-Federal entities must include a provision for compliance with the Xxxxx-Xxxxx Act (40 U.S.C. 3141-3144, and 3146-3148) as supplemented by Department of Labor regulations (29 CFR Part S, "Labor Standards Provisions Applicable to Contracts Covering Federally Financed and Assisted Construction"). In accordance with the statute, contractors must be required to pay wages to laborers and mechanics at a rate not less than the prevailing wages specified in a wage determination made by the Secretary of Labor. In addition, contractors must be required to pay wages not less than once a week. The non-Federal entity must place a copy of the current prevailing wage determination issued by the Department of Labor in each solicitation. The decision to award a contract or subcontract must be conditioned upon the acceptance of the wage determination. The non-Federal entity must report all suspected or reported violations to the Federal awarding agency. The contracts must also include a provision for compliance with the Xxxxxxxx "Anti-Kickback" Act {40 U.S.C. 314S), as supplemented by Department of Labor regulations (29 CFR Part 3, "Contractors and Subcontractors on Public Building or Public Work Financed in Whole or in Part by Loans or Grants from the United States"). The Act provides that each contractor or subrecipient must be prohibited from inducing, by any means, any person employed in the construction, completion, or repair of public work, to give up any part of the compensation to which he or she is otherwise entitled. The non-Federal entity must report all suspected or reported violations to the Federal awarding agency. BY SUBMITTING A PROPOSAL FOR PART 2 OF THIS SOLICITATION, the Vendor agrees, AS REQUIRED BY LAW, to comply with the Xxxxx Xxxxx Act, IF APPLICABLE and if proposing on PART 2 of this solicitation.

  • Reporting on Utilization of Subject Inventions 1. The Performer agrees to submit, during the term of the Agreement, an annual report on the utilization of a subject invention or on efforts at obtaining such utilization that are being made by the Performer or its licensees or assignees. Such reports shall include information regarding the status of development, date of first commercial sale or use, gross royalties received by the Performer, and such other data and information as the agency may reasonably specify. The Performer also agrees to provide additional reports as may be requested by DARPA in connection with any march-in proceedings undertaken by DARPA in accordance with Paragraph I of this Article. DARPA agrees it shall not disclose such information to persons outside the Government without permission of the Performer, unless required by law.

  • Financial Institution with Only Low-Value Accounts An Estonian Financial Institution satisfying the following requirements:

  • Motor Vehicle Where You have purchased a motor vehicle with the Funding:

  • Emergency Action on Imports of Particular Products Where any product is being imported in such increased quantities and under such conditions as to cause, or threaten to cause:

Time is Money Join Law Insider Premium to draft better contracts faster.