Geotechnical Investigation Perform in accordance with the City Design Manual and other City requirements as designated in writing by the Director.
Environmental Inspection at End of Agreement Term A. At Authority’s discretion, at least one hundred and twenty (120) days before the expiration or early termination of the Term as provided herein, Company will conduct an environmental inspection and examination of the Company Premises. At its discretion, Authority may complete environmental reviews to determine if recognized environmental conditions exist that could warrant soil and groundwater sampling. If warranted by the findings of Company or Authority’s inspection or if requested by Authority, a compliance audit or site assessment will be performed within the aforementioned time period by a qualified professional acceptable to Authority who will report the findings to Authority. The cost for professional consulting or engineering services required for such audit will be at the expense of Company. If a site assessment is conducted, Company agrees to pay all associated laboratory and testing fees incurred to test and analyze samples collected during the site assessment process. The Authority may also choose to conduct the compliance audit or site assessment. If the results of the assessment indicate that the Company Premises have been impacted by the release of Hazardous Substances, Company will immediately take such action as is necessary and will provide a substantial guaranty in a form and content acceptable to Authority that Company will clean up the contamination at its own expense, at no expense to Authority, and in accordance with Applicable Laws to the extent that it is obligated to do so by virtue of the foregoing provisions of this Article.
Site Preparation Contractor shall not begin a project for which the site has not been prepared, unless Contractor does the preparation work at no cost, or until Region 4 ESC includes the cost of site preparation in a purchase order. Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre-installation requirements.
Project Engineer If the Project has been designed by the Project Engineer, the Project Engineer is to act as the Owner's representative, assumes all duties and responsibilities, and has the rights and authority assigned to Project Engineer in the Contract Documents in connection with completion of the Work all in accordance with the Contract Documents.
Project Management Project Management Institute (PMI) certified project manager executing any or all of the following: • Development of Project Charter • Development of project plan and schedule • Coordination and scheduling of project activities across customer and functional areas • Consultation on operational and infrastructure requirements, standards and configurations • Facilitate project status meetings • Timely project status reporting • Address project issues with functional areas and management • Escalation of significant issues to customers and executive management • Manage project scope and deliverable requirements • Document changes to project scope and schedule • Facilitate and document project closeout
Environmental Assessment and Mitigation Development of a transportation project must comply with applicable environmental laws. The party named in article 1, Responsible Parties, under AGREEMENT is responsible for the following:
Investigational Services This plan covers certain experimental or investigational services as described in this section. Clinical Trials This plan covers clinical trials as required under R.I. General Law § 27-20-60. An approved clinical trial is a phase I, phase II, phase III, or phase IV clinical trial that is being performed to prevent, detect or treat cancer or a life-threatening disease or condition. In order to qualify, the clinical trial must be: • federally funded; • conducted under an investigational new drug application reviewed by the Food and Drug Administration (FDA); or • a drug trial that is exempt from having such an investigational new drug application. To qualify to participate in a clinical trial: • you must be determined to be eligible, according to the trial protocol; • a network provider must have concluded that your participation would be appropriate; and • medical and scientific information must have been provided establishing that your participation in the clinical trial would be appropriate. If a network provider is participating in a clinical trial, and the trial is being conducted in the state in which you reside, you may be required to participate in the trial through the network provider. Coverage under this plan includes routine patient costs for covered healthcare services furnished in connection with participation in a clinical trial. The amount you pay is based on the type of service you receive. Coverage for clinical trials does not include: • the investigational item, device, or service itself; • items or services provided solely to satisfy data collection and that are not used in the direct clinical management; or • a service that is clearly inconsistent with widely accepted standards of care.
Phase I a. In Phase I, the project will be connected as a tap to the Transmission Owner’s 230kV transmission line MWP-2 via one 230kV circuit breaker in series with one of two ring bus breakers for stuck breaker protection (one in each direction) and a tie-line breaker, as shown on the one-line diagram labeled CL-E-IA-01 attached to this Appendix A as Figure 1. The changes to the existing MWP-2 line protection for this arrangement are described in Phase I System Upgrades in Section II of this Appendix A.
Phase II A small portion of the work for the Phase II modifications to the Plattsburgh Substation will be performed by Transmission Owner, and the remainder will be performed by Clinton and Xxxxxxxxx. A detailed definition of the specific scope for Transmission Owner and Clinton and Xxxxxxxxx including interface points shall be defined during the design phase and, as such documents become available, copies will be delivered to the NYISO, Transmission Owner, Noble Altona Windpark, LLC and Marble River, LLC. The full scope includes the installation of wave traps, CCVT’s and modifications and/or additions to relaying on the MWP-1 and MWP- 2 lines. These lines will be reconfigured at the completion of Phase II to connect to Xxxxx and Xxxxxxx Substations on MWP-1 and the Xxxx Substation on MWP-2. Clinton and Xxxxxxxxx will design the upgrades and purchase the materials based on the outline specification that was prepared and issued by Transmission Owner. The work to be performed by Clinton and Xxxxxxxxx will include both the materials for the exterior and interior installations and items for Transmission Owner installation inside the control building in existing relay panels and communication racks. In addition, Clinton and Xxxxxxxxx will be responsible for the exterior and interior construction work and will provide construction management services in coordination with Transmission Owner. The civil design for the foundations and the electrical design for the cable runs to the control room will be designed by, as approved by Transmission Owner, and installed under the supervision and control of Clinton and Xxxxxxxxx. The equipment will be selected and procured in accordance with the specifications developed during the detailed engineering phase, copies of which shall be furnished to the NYISO, Transmission Owner, Noble Altona Windpark, LLC and Marble River, LLC. The construction of the foundations, structures, wave traps, CCTV and cable runs into the control building to the termination cabinets will be completed by Clinton and Xxxxxxxxx. The work at the Plattsburgh Substation will be installed under Transmission Owner’s CPP-1. Transmission Owner will provide Protection and Controls Engineering, install and terminate wiring from the termination cabinets to the control panels and relays, install relays and equipment in the existing panels, and will commission such work inside the 230kV control building. Transmission Owner will develop the communications protocols and data flow over the circuits.
Formal Investigation Once the matter has been brought to the attention of the Store executive, an internal investigation of the complaint will be conducted at which time the complainant will be requested to present, in writing, the particulars of the harassment. Such internal investigation will be initiated no later than ten (10) business days of the matter being brought to the attention of the Store executive, and shall be concluded no later than thirty (30) business days of the initiation of the investigation. Any extension of the aforementioned time frames must have the agreement of the complainant and the union if the complainant has chosen to involve it. Based on the outcome of the investigation, which will be provided in writing upon the completion of the investigation, to both the complainant and the union, should the complainant consent to this disclosure, it will be determined if there has been a breach of Company policy on harassment, and the appropriate action will be taken in the event that harassment is determined to have occurred. STEP THREE - SUBSEQUENT INCIDENTS Subsequent incidents should immediately be reported and followed by a written description to the most senior store executive involved in Step Two for further investigation and disciplinary action, if confirmed, with a copy to the union Chairperson with the consent of the complainant. After all steps of the Harassment Protection Policy have been exhausted, if the incident has not been resolved to the satisfaction of the employee, the employee may file a grievance at Step 2 of the grievance procedure.
