PAINTING-WOODWORK Sample Clauses

PAINTING-WOODWORK. Refer clause 17.6 of MES Schedule, Part-I. PARTICULAR SPECIFICATIONS (CONTD…)
Sample 1
AutoNDA by SimpleDocs

Related to PAINTING-WOODWORK

  • Painting All exterior surfaces and materials requiring paint shall be prime coated plus 2 coats of Xxxxxxx Xxxxxxxx Pro-Mar alkyd flat exterior finish, or Xxxxxxx-Xxxxxxxx SWP exterior gloss paint. All porous exterior surfaces (e.g. unpainted wood) shall be sealed with 2 coats of Xxxxxxxx’x Water Seal following the manufacturers application instructions. Interior surfaces requiring paint shall be prime coated plus 2 coats of Xxxxxxx Xxxxxxxx Pro-Mar Latex Eg-Shel enamel. Concrete block walls shall receive 1 coat of Xxxxxxx Xxxxxxxx Pro-Mar Block Filler and 2 coats of Xxxxxxx Xxxxxxxx Pro-Mar latex Eg-Shel enamel. Interior finishes and color selections shall be approved by the State. A schedule of colors and finishes shall be prepared by the Owner/Lessor and approved by the State.

  • Decoration 22.1 The Tenant shall decorate the Property as often as is reasonably necessary and also in the last three months before the end of the term.

  • Decorations The only acceptable form of affixing items to walls is the use of white sticky tack, and must be removed by the Resident prior to move out, or be subject to removal charges. Spikes, hooks, screws, tacks or nails or any permanent adhesion type tape shall not be put into or on the walls or woodwork, ceilings, furnishings, doors or windows of any part of the Residence. Residents may not decorate the outside of their room door unless for special occasions approved by the Manager. Strings of indoor lights should not be in direct contact with any flammable materials and should not be left on while the room is unattended.

  • Carpet Cleaning Shampooing carpets with the deep dirt extraction (steam cleaning) method per manufactures recommendations.

  • Interior (a) Ceilings, sidewalls and bulkhead panels shall be clean and free of cracks and stains;

  • DECORATING Decorating must be done during the time period you have reserved this facility. (If you wish to decorate the day before the event, you must pay the rental fee of $600.00). • Materials such as tacks, nails, staples, glue, etc. may not be used to attach decorations to walls or tables. 3M packing tape may be used for applying decorations to wood surfaces. NO TAPE ON SHEETROCK WALLS. • Damage to walls will result in loss of deposit and possible additional fees and charges. • Decorations of any kind may not be attached to the ceiling tiles and/or grids. • Rice and birdseed are permitted outdoors. • Under no circumstances are tables, chairs, or any equipment/furniture to be removed from this facility. • If serving food and/or drinks, all tables must be covered with some type of tablecloth. • No spray glue, bottled bubbles, smoke machines, spray glitter, spray paint, or any type of aerosol adhesives will be allowed in the facility. • Changing the appearance of this building other than normal decorating is NOT PERMITTED. CAPACITY AND SEATING Main Hall Balcony Meeting Rooms 400 Auditorium Style 100 Auditorium Style 50 Auditorium Style or or only 250 with Tables & Chairs 80 with Tables & Chairs RENTAL PROCEDURES • No food or drink is allowed on the stage unless PRE-APPROVED IN ADVANCE. • Any food remaining from the event must be removed from the facility. If any food is left, it will be disposed of immediately after the event. • All functions must shut down one hour prior to end time for cleaning, removing food, decorations, and equipment/furniture belonging to the renter. This includes shutting down music and stop serving alcohol. The City of Ocean Springs will not be responsible for any items left in the facility following the conclusion of the reserved event. • The kitchen area must be cleaned by the rental party. • Gambling in any form is strictly prohibited. • No animals other than service dogs are allowed in the facility. • Maintaining order and control over all persons or guests in the group and encouraging them to abide by all the policies and procedures of this facility during the reserved period of time is the renter’s responsibility. FAILURE TO COMPLY WITH THESE REGULATIONS MAY RESULT IN LOSS OF ALL OR PORTIONS OF THE DEPOSIT TO COVER APPLICABLE FEES. Renter, including his/her/its heirs, member, assigns, agents, and/or representatives, agrees that The City shall not be liable for any injury or damages, whether to person or property, originating in contract, tort, equity, or otherwise, associated with Renter’s use of the facility, inside or outside the subject building. Renter further agrees to hold harmless, defend, release, covenant not to xxx, and indemnify The City for any and all liability, claims, demands, actions, and causes of action whatsoever arising out of or related to any loss, damage, or injury that may be sustained by Renter, a third party, and/or any other person, whether based in tort, contract, or equity, whether caused by the negligence of The City or otherwise, that is in any way associated with Renter’s use of the Facility.

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.

  • Walls 12 Developer shall provide rustication patterns on all walls, except drainage headwalls, in Aesthetic 13 Area 3 in accordance with Exhibit L2.24 of the LAADCR. The final designs shall resemble these 14 simulations.

  • Exterior and interior functional areas and spaces of the Project, with technical and equipment requirements on each;

  • Finishing Work It has been clearly understood by the Alottee, that the Occupancy Certificate/Completion Certificate, as the case may be, are issued by the concerned authorities, when the entire civil construction work of the apartment is complete and the apartment is in a habitable state, however, to prevent any loss or damage, the internal fittings, furnishings and finishing work is done after obtaining completion certificate/occupancy certificate as the case may be. Further the internal fittings, furnishings and finishing work may also depend upon the choice of the Allottee. Therefore to ensure that there is no loss or damage to the internal fittings, furnishings and finishing work and the same may be carried on as per the choice of the Allottee, internal works such as fitting of switch boards, doors, sanitary fittings, plumber fittings like water taps/showers etc., final colour coat on the internal walls, floor tiles or any other internal work of like nature, shall be completed after obtaining occupancy certificate/completion certificate and before handing over the possession of the apartment to the Allottee.

Time is Money Join Law Insider Premium to draft better contracts faster.