Link Source Type Distribution Sample Clauses

Link Source Type Distribution. The national default Source Type Distribution was obtained from a national scale MOVES run for the 2015 calendar year. Using the vehicle miles traveled (VMT) information from the ‘movesactivityoutput’ table within the output database, the Source Type Distributions were transformed into a Source Type Hour Fraction for intersection, arterial, and freeway scenarios. To ensure conservative results, the Source Type Hour Fraction was based on the national 14 See : xxxx://xxx.xxx.xxx/lib/46000/46500/46598/DOT-VNTSC-FHWA-12-05.pdf and xxxx://xxx.xxx.xxx/ttnchie1/conference/ei19/session6/xxxx.pdf 15 Differences in emission rates are dependent on the fleet mixture, fuel supply and formulation, grade, and road type that may affect the overall emissions rates results depicted in this figure. However, the emission profile as shown in the figure would remain the same in that it is only temperature dependent above 75 degrees F. Note that data was only reported at 60 degree and 80 degree Fahrenheit making it appear that an emission sensitivity to temperature occurs below 75 degrees F. default, but adjusted, in two steps, to reflect a higher proportion of vehicles that have higher CO emissions rates. These two steps are detailed below:  Passenger trucks have the highest CO emission rates of all MOVES source types, except gasoline operated single unit trucks. Passenger cars have the largest fraction of the total national vehicle mix and passenger trucks are the second largest fraction of the total national vehicle mix. To ensure conservative emissions rate estimates for the PA, the Source Type Hour Fraction was adjusted to reflect a 50/50 proportional split between passenger car and passenger truck source types.  Gasoline vehicle types typically have higher CO emission rates than diesel vehicle types within MOVES. In the Federal Highway Administration (FHWA) Carbon Monoxide (CO) Categorical Hot-Spot Finding (FHWA, February 2014), it was assumed that the lowest observed fraction of non-gasoline vehicles was 5% of the total vehicle mix. To provide a more conservative emission rate than used in the Federal Highway Administration (FHWA) Carbon Monoxide (CO) Categorical Hot-Spot Finding, the national default Source Type Hour Fraction was adjusted by reducing combination and single-unit trucks to represent 0% of the total fleet mix. The remaining 5% fraction was added to the passenger truck source type after the conservative 50/50 passenger car to passenger truck split was appl...
AutoNDA by SimpleDocs

Related to Link Source Type Distribution

  • Unbundled Sub-Loop Distribution Intrabuilding Network Cable (USLD-INC) is the distribution facility owned or controlled by BellSouth inside a building or between buildings on the same property that is not separated by a public street or road. USLD-INC includes the facility from the cross connect device in the building equipment room up to and including the point of demarcation at the End User’s premises.

  • Single Source Selection Services for tasks in circumstances which meet the requirements of paragraph 3.10 of the Consultant Guidelines for Single Source Selection, may, with the Association's prior agreement, be procured in accordance with the provisions of paragraphs 3.9 through 3.13 of the Consultant Guidelines.

  • Distribution of UDP and TCP queries DNS probes will send UDP or TCP “DNS test” approximating the distribution of these queries.

  • Distribution Services The Distributor shall sell and repurchase Shares as set forth below, subject to the registration requirements of the 1933 Act and the rules and regulations thereunder, and the laws governing the sale of securities in the various states ("Blue Sky Laws"):

  • Distribution Protocol (1) At a time wholly within the discretion of Class Counsel, but on notice to the Settling Defendants, Class Counsel will bring motions seeking orders from the Courts approving the Distribution Protocol. The motions can be brought before the Effective Date, but the orders approving the Distribution Protocol shall be conditional on the Effective Date occurring.

  • Initial Business Combination/Distribution Procedure The Company may consummate the Initial Business Combination and conduct redemptions of Common Stock for cash upon consummation of such Initial Business Combination without a stockholder vote pursuant to Rule 13e-4 and Regulation 14E of the Exchange Act, including the filing of tender offer documents with the Commission. Such tender offer documents will contain substantially the same financial and other information about the Initial Business Combination and the redemption rights as is required under the Commission’s proxy rules and will provide each stockholder of the Company with the opportunity prior to the consummation of the Initial Business Combination to redeem the Common Stock held by such stockholder for an amount of cash equal to (A) the aggregate amount then on deposit in the Trust Account as of two Business Days prior to the consummation of the Initial Business Combination representing (x) the proceeds held in the Trust Account from the Offering and the sale of the Private Placement Warrants and (y) any interest, divided by (B) the total number of Public Shares then outstanding. In the event the Company conducts redemptions pursuant to the tender offer rules, the Company’s offer to redeem will remain open for at least 20 Business Days, in accordance with Rule 14e-1(a) under the Exchange Act, and the Company will not be permitted to complete the Initial Business Combination until the expiration of the tender offer period. If, however, the Company elects not to file such tender offer documents, a stockholder vote is required by law or stock exchange listing requirement in connection with the Initial Business Combination, or the Company decides to hold a stockholder vote for business or other legal reasons, the Company will submit such Initial Business Combination to the Company’s stockholders for their approval (“Business Combination Vote”). The company will give not less than 10 days nor more than 60 days prior written notice of any such meeting, if required, at which a Business Combination Vote shall be taken. With respect to the Business Combination Vote, the Sponsor and the Company’s initial stockholders, executive officers and directors have agreed to vote all of their Founder Shares and Public Shares in favor of the Company’s initial Business Combination. If the Company seeks stockholder approval of the Initial Business Combination, the Company will offer to each Public Stockholder holding shares of Common Stock the right to have its shares redeemed in conjunction with a proxy solicitation pursuant to the proxy rules of the Commission at a per share redemption price (the “Redemption Price”) equal to (I) the aggregate amount then on deposit in the Trust Account as of two Business Days prior to the consummation of the Initial Business Combination representing (1) the proceeds held in the Trust Account from the Offering and the sale of the Private Placement Warrants and (2) any interest, divided by (II) the total number of Public Shares then outstanding. The Company may proceed with such Initial Business Combination only if a majority of the shares voted are voted to approve such Initial Business Combination. If, after seeking and receiving such stockholder approval, the Company elects to so proceed, it will redeem shares, at the Redemption Price, from those Public Stockholders who affirmatively requested such redemption. Only Public Stockholders holding Common Stock who properly exercise their redemption rights, in accordance with the applicable tender offer or proxy materials related to such Initial Business Combination, shall be entitled to receive distributions from the Trust Account in connection with an Initial Business Combination, and the Company shall pay no distributions with respect to any other holders or shares of capital stock of the Company in connection therewith. In the event that the Company does not effect an Initial Business Combination within the time period set forth in the Amended and Restated Certificate of Incorporation, the Company will (i) cease all operations except for the purpose of winding up, (ii) as promptly as reasonably possible but not more than ten (10) Business Days thereafter, redeem 100% of the Public Shares, at a per-share price, payable in cash, equal to the aggregate amount then on deposit in the Trust Account, including any interest (which shall be net of amounts withdrawn to pay taxes and up to $100,000 of interest to pay dissolution expenses), divided by the number of then outstanding Public Shares, which redemption will completely extinguish Public Stockholders’ rights as stockholders (including the right to receive further liquidation distributions, if any), subject to applicable law, and (iii) as promptly as reasonably possible following such redemption, subject to the approval of the Company’s remaining stockholders and the Company’s board of directors, dissolve and liquidate, subject in each case to the Company’s obligations under Delaware law to provide for claims of creditors and the requirements of other applicable law. Only Public Stockholders holding Common Stock included in the Securities shall be entitled to receive such redemption amounts and the Company shall pay no such redemption amounts or any distributions in liquidation with respect to any other shares of capital stock of the Company. The Company will not propose any amendment to the Amended and Restated Certificate of Incorporation to modify the substance or timing of the Company’s obligation to provide for the redemption of the Public Shares in connection with an Initial Business Combination or to redeem 100% of its Public Shares if it does not complete its initial business combination within the time period set forth in the Amended and Restated Certificate of Incorporation, unless it provides its public stockholders with the opportunity to redeem their shares of Class A common stock upon approval of any such amendment, as described in the Statutory Prospectus and Prospectus.

  • Unbundled Channelization (Multiplexing) 5.7.1 To the extent NewPhone is purchasing DS1 or DS3 or STS-1 Dedicated Transport pursuant to this Agreement, Unbundled Channelization (UC) provides the optional multiplexing capability that will allow a DS1 (1.544 Mbps) or DS3 (44.736 Mbps) or STS-1 (51.84 Mbps) Network Elements to be multiplexed or channelized at a BellSouth central office. Channelization can be accomplished through the use of a multiplexer or a digital cross-connect system at the discretion of BellSouth. Once UC has been installed, NewPhone may request channel activation on a channelized facility and BellSouth shall connect the requested facilities via COCIs. The COCI must be compatible with the lower capacity facility and ordered with the lower capacity facility. This service is available as defined in NECA 4.

  • Supplier Selection If Customer selects a seat or galley supplier that is not on the Boeing recommended list, such seat or galley will become BFE and the provisions of Exhibit A, Buyer Furnished Equipment Provisions Document, of the AGTA will apply.

  • Unbundled Network Terminating Wire (UNTW) 2.8.3.1 UNTW is unshielded twisted copper wiring that is used to extend circuits from an intra-building network cable terminal or from a building entrance terminal to an individual End User’s point of demarcation. It is the final portion of the Loop that in multi-subscriber configurations represents the point at which the network branches out to serve individual subscribers.

  • Distribution System The Transmission Provider's facilities and equipment used to transmit electricity to ultimate usage points such as homes and industries directly from nearby generators or from interchanges with higher voltage transmission networks which transport bulk power over longer distances. The voltage levels at which Distribution Systems operate differ among areas. Distribution Upgrades – The additions, modifications, and upgrades to the Transmission Provider's Distribution System at or beyond the Point of Interconnection to facilitate interconnection of the Small Generating Facility and render the transmission service necessary to effect the Interconnection Customer's wholesale sale of electricity in interstate commerce. Distribution Upgrades do not include Interconnection Facilities.

Time is Money Join Law Insider Premium to draft better contracts faster.