Judgements of the Sample Clauses

Judgements of the. Court of Justice shall be binding on the Member States, the Institutions of the Community and on individuals and corporate bodies. The Court consists of seven (7) Justices, appointed from Member States and is headed by President who is assisted by a Vice-President and the five other justices. The presidency is rotated amongst members according to the protocol of the Court. The official languages of the Court are English, French and Portuguese in accordance with the Article 31 of the Protocol and Article 87 of the Treaty. The Court is empowered by the provisions of Article 76(2) to exercise jurisdiction over any dispute arising from the interpretation or the application of the provisions of the Treaty in the event only that the parties to the disputes have not amicably settled the dispute through direct agreement without prejudice to the provisions of the treaty. The decision of the Court is final.
Sample 1
AutoNDA by SimpleDocs

Related to Judgements of the

  • Requirements of the job Some or all of the following are needed to perform work at this level:

  • Components of the Contract Any and all plans or drawings prepared by the Department, the document titled “General Provisions and Contract Specifications for Highway Construction”, the advertisement, the Tender Form and Agreement together with Schedule A, Schedule of Special Provisions; Schedule B, Identification of Principals; Schedule C, Schedule of Tendered Unit Prices; Schedule D, Schedule of Equipment; and Schedule E, Schedule of Sub-Contractors, as well as any addenda which may be issued by the Department pursuant to this Contract shall hereby be a part of this Contract as fully and to the same effect as if the same had been set forth at length in the body of the Contract.

  • Members of the Union executive shall be able to act as a Union Xxxxxxx in the absence of the employee’s area Xxxxxxx.

  • Measurements and Dimensions Before ordering material or doing work that is dependent upon coordination with building conditions, the Contractor shall verify all dimensions, elevations, grades, and pitch by taking measurements at the building and shall be responsible for the correctness of same. Any discrepancies between the drawings and/or specifications and the existing conditions shall be referred to the Design Professional for additional instructions before any work affected thereby is begun.

  • Overriding powers of the Authority 17.10.1 If in the reasonable opinion of the Authority, the Concessionaire is in material breach of its obligations under this Agreement and, in particular, the Maintenance Requirements, and such breach is causing or likely to cause material hardship or danger to the Users, the Authority may, without prejudice to any of its rights under this Agreement including Termination thereof, by notice require the Concessionaire to take reasonable measures immediately for rectifying or removing such hardship or danger, as the case may be.

  • Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.

  • Requirements of the position Some or all of the following are needed to perform work at this level:

  • Other Costs and Emergencies § 6.7.1 Other costs incurred in the performance of the Work if, and to the extent, approved in advance in writing by the Owner.

  • Investigations The respective representations and warranties of the Parties contained in this Agreement or any certificate or other document delivered by any Party at or prior to the Closing and the rights to indemnification set forth in Article XI shall not be deemed waived or otherwise affected by any investigation made, or knowledge acquired, by a Party.

  • Lockouts No lockout of employees shall be instituted by the Employer during the term of this Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.