AML/KYC Procedures “AML/KYC Procedures” means the customer due diligence (CDD) procedures of a Reporting Financial Institution pursuant to the anti-money laundering or similar requirements of the jurisdiction concerned to which such Reporting Financial Institution is subject.
Layoff Procedures 120. Layoffs shall be administered pursuant as follows: An employee with permanent seniority in class shall have the right to displace an employee with less permanent seniority in the same class in any department. All bumping and displacement shall first occur within the department that affected the layoff in question prior to City-wide bumping.
Notification Procedures To address non-compliance, the receiving Competent Authority would notify the providing Competent Authority pursuant to Article 5 of the IGA. The notification procedures would differ depending upon whether the receiving Competent Authority seeks to address administrative or other minor errors or significant non-compliance.
Formal Procedures a. Upon presentation to the Vice President of a petition, signed by one-third (1/3) of the full-time members of the department who are eligible to participate, excluding the Department Chair, stating specific reasons for recalling the Department Chair, the Vice President shall promptly give fourteen (14) days written notice to all full-time department members setting forth the time, date and place of a meeting to consider the recall petition and to vote on either a motion that the Department Chair continue in office or a motion to recommend to the President that he/she declare a vacancy to exist in the chair of the department. The Department Chair may be present at this meeting.
Referral Procedures (a) For signatory Unions now having a job referral system contained in a Schedule A, the Contractor agrees to comply with such system and it shall be used exclusively by such Contractor, except as modified by this Agreement. Such job referral system will be operated in a nondiscriminatory manner and in full compliance with federal, state, and local laws and regulations which require equal employment opportunities and non-discrimination. All of the foregoing hiring procedures, including related practices affecting apprenticeship, shall be operated so as to consider the goals of the College to encourage employment of College residents and utilization of small local businesses on the Project, and to facilitate the ability of all Contractors to meet their employment needs. The Unions will exert their best efforts to recruit and refer sufficient numbers of skilled craft workers to fulfill the labor requirements of the Contractor, including specific employment obligations to which the Contractor may be legally and/or contractually obligated; and to refer apprentices as requested to develop a larger, skilled workforce. The Unions will work with their affiliated regional and national unions, and jointly with the Community Workforce Coordinator and others designated by the College, to identify and refer competent craft persons as needed for Project Work, and to identify and hire individuals, particularly residents of the College, for entrance into joint labor/management apprenticeship programs, or to participation in other identified programs and procedures to assist individuals in qualifying and becoming eligible for such apprenticeship programs, all maintained to increase the available supply of skilled craft personnel for Project Work and future construction of maintenance work to be undertaken by the College.
Transfer Procedures 1. The transfers referred to in Article 4, 5, 6 and 7 shall be effected without undue delay and, at all events, within six months after all fiscal obligations have been met and shall be made in a convertible currency. All the transfers shall be made at the prevailing exchange rate applicable on the date on which the investor applies for the related transfer, with the exception of the provisions under point 3 of Article 5 concerning the exchange rate applicable in case of nationalization or expropriation.
Other Procurement Procedures The following procurement methods may be used for the procurement of works and goods that the Bank agrees meets the requirements established in the provisions of Section III of the Procurement Policies:
TERMINATION PROCEDURES The Contractor acknowledges that this Agreement may be terminated for Convenience or Default.
CLAIM PROCEDURES Claim forms or claim information as to the subject policy can be obtained by contacting Benmark, Inc. (800-544-6079). When the Named Fiduciary has a claim which may be covered under the provisions described in the insurance policy, they should contact the office named above, and they will either complete a claim form and forward it to an authorized representative of the Insurer or advise the named Fiduciary what further requirements are necessary. The Insurer will evaluate and make a decision as to payment. If the claim is payable, a benefit check will be issued in accordance with the terms of this Agreement. In the event that a claim is not eligible under the policy, the Insurer will notify the Named Fiduciary of the denial pursuant to the requirements under the terms of the policy. If the Named Fiduciary is dissatisfied with the denial of the claim and wishes to contest such claim denial, they should contact the office named above and they will assist in making an inquiry to the Insurer. All objections to the Insurer's actions should be in writing and submitted to the office named above for transmittal to the Insurer.
Informal Procedures 1. If a teacher feels that s/he may have a grievance, s/he must first discuss the matter with the person directly involved in an effort to resolve the problem informally.
