Commercial Density Sample Clauses

Commercial Density. In Developer's sole discretion, the Project may include up to three hundred thousand five hundred (300,500) square feet of gross floor area of commercial uses in the locations shown on the Final Development Plan and Exhibit L. The particular uses allowed within these locations shall be determined upon submission and approval of a site plan for such commercial or mixed used development subject to then-applicable provisions of the Town's Land Use Ordinance except as otherwise provided by this Agreement. Commercial density may be modified pursuant to the density transfer provision set forth in Sections 10.5 and 15 of this Agreement.
Sample 1
AutoNDA by SimpleDocs
Commercial Density. Development on the Property shall be limited to the total densities as set forth in this Agreement, which shall be binding upon Owner and Beaufort County in the futuremaximum commercial square feet of density available under the ZDSO as of the Effective Date. Development beyond the total commercial square feet of density described and depicted in the Development Plan shall require an updated traffic impact analysis, and availability of additional commercial density shall be limited to that allowed under such traffic impact analysis. The right to fully develop or construct all of the commercial density provided for herein, notwithstanding the submission or approval of a development plan or otherwise, shall not limit the right to such stated density, nor prohibit subsequent or future construction up to the stated amountherein shall be binding on Owner and the County. It being specifically understood that Owner, its successors and assigns shall have the absolute right to develop the Property to the commercial square feet of density stated herein. Owner shall have the right to make revisions to the Development Plan for matters including, but not limited to, adjustments to the dimensions of lots and buildings so long as the same are in keeping with the character and intent of the Development Agreement Ordinance and shall be administered and approved by the DRT. The maximum density for the Property shall be equal to the maximum density available under the ZDSO as of the Effective Date.
Sample 1

Related to Commercial Density

  • Commercial Driver’s License As a result of recent Federal statutory requirements, the State of Michigan enacted Act 346 of 1988. The parties agree that as a result of these statutory requirements some employees within the Technical Bargaining Unit may be required to obtain and retain a Commercial Drivers License (CDL) to continue to perform certain duties for the State. Whenever a CDL is referred to in this Section, it is understood to mean the CDL and any required endorsements. In order to implement this provision, the parties agree to the following:

  • Building Commissioning Services The Owner may provide as a part of its testing services the Building Commissioning services involving the project’s HVAC and exhaust systems, temperature control systems, fire detection and alarm systems, emergency power and lighting system, fire suppression system, security locks and security locking control systems, food service equipment (if applicable), and laundry equipment (if applicable). In the event the Using Agency’s Program specifies additional commissioning services, the Owner shall procure such services as well. The Owner, through its Executive Administrator, may engage an independent Commissioning Authority. It is the intent of this Article that the Commissioning Authority enforce the requirements mentioned herein and certify that the systems and equipment listed all function properly prior to the initiation of each final inspection.

  • CONSTRUCTION INDUSTRY DEVELOPMENT & PROMOTION FUND 19.01 The Employer shall contribute to the Union’s Construction Industry Development and Promotion Fund (the “Industry Fund”) the amount identified at Schedule “A” for each hour worked by each employee covered by this Agreement, and it shall remit such contributions to the Union together with union dues, and in the manner described in the Remittances to the Union article and in the Union’s remittance directives.

  • Creative Commons Attribution-Non-Commercial-NoDerivs License The Creative Commons Attribution Non-Commercial-NoDerivs License (CC-BY-NC-ND) permits use, distribution and reproduction in any medium, provided the original work is properly cited, is not used for commercial purposes and no modifications or adaptations are made. (see below) Use by commercial "for-profit" organizations Use of Wiley Open Access articles for commercial, promotional, or marketing purposes requires further explicit permission from Wiley and will be subject to a fee. Further details can be found on Wiley Online Library xxxx://xxxxxxx.xxxxx.xxx/WileyCDA/Section/id-410895.html Other Terms and Conditions:

  • Commercial Operation (i) On or before December 31, 2021, Interconnection Customer must demonstrate commercial operation of all generating units. Demonstrating commercial operation includes achieving Initial Operation in accordance with Section 1.4 of Appendix 2 to this ISA and making commercial sales or use of energy, as well as, if applicable, obtaining capacity qualification in accordance with the requirements of the Reliability Assurance Agreement Among Load Serving Entities in the PJM Region.

  • Synchronization, Commissioning and Commercial Operation 4.1.1 The Power Producer shall give at least thirty (30) days written notice to the SLDC and GUVNL, of the date on which it intends to synchronize the Power Project to the Grid System.

  • Design Development Phase INDICATE IN STATEMENT OF WORK “NOT APPLICABLE” IF SECTION IS NOT APPLICABLE

  • Design Development Phase Services 3.3.1 Based on the Owner’s approval of the Schematic Design Documents, and on the Owner’s authorization of any adjustments in the Project requirements and the budget for the Cost of the Work, the Architect shall prepare Design Development Documents for the Owner’s approval. The Design Development Documents shall illustrate and describe the development of the approved Schematic Design Documents and shall consist of drawings and other documents including plans, sections, elevations, typical construction details, and diagrammatic layouts of building systems to fix and describe the size and character of the Project as to architectural, structural, mechanical and electrical systems, and other appropriate elements. The Design Development Documents shall also include outline specifications that identify major materials and systems and establish, in general, their quality levels.

  • MAINTENANCE OF THE BUILDING /APARTMENT / PROJECT The Promoter shall be responsible to provide and maintain essential services in the Project till the taking over of the maintenance of the project by the Association upon the issuance of the completion certificate of the Project. The cost of such maintenance has been included in the Total Extras and Deposits as mentioned in clause 1.2.

  • Development Area 10.4. The Development Area shall encompass all Deposits to be produced.

Time is Money Join Law Insider Premium to draft better contracts faster.