CIVIL PENALTY, INJUNCTIVE RELIEF, AND COMPLIANCE ASSURANCE Sample Clauses

CIVIL PENALTY, INJUNCTIVE RELIEF, AND COMPLIANCE ASSURANCE. 111. In compromise and settlement of all of the violations alleged in the Compressor Station ACO and the Gas Plant ACO, and upon consideration of the seriousness of the alleged violations and DCP’s efforts to address the causes of excess emissions at the Facilities, the Parties agree that DCP shall: (1) pay a civil penalty of $950,000 in a cash payment to the State of New Mexico; (2) permanently cease operation of its Xxxxxx Gas Plant, with the exception of those operations identified in paragraph 112, and surrender or modify, as set forth in paragraph 116, its permits for the Xxxxxx Gas Plant; and (3) comply with additional requirements relating to operations at its gas plant facilities, as set forth below. 112. The requirement to cease operations of the Xxxxxx Gas Plant does not apply to those specific operations located at the Xxxxxx Gas Plant that are associated with the compressor station known as the “Xxxxxx Compressor Station,” and those liquids stabilization and loading/unloading facilities known as the “Xxxxxx Treater.” Civil Penalty
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to CIVIL PENALTY, INJUNCTIVE RELIEF, AND COMPLIANCE ASSURANCE

  • Civil Penalty ORLY shall issue two separate checks for a total amount of five hundred dollars ($500.00) as penalties pursuant to California Health & Safety Code § 25249.12 as follows: (a) one check made payable to the State of California’s Office of Environmental Health Hazard Assessment (OEHHA) in the amount of three hundred and seventy five dollars ($375.00), representing 75% of the total penalty; and (b) one check to Xxxx Xxxxxxx in the amount of one hundred and twenty five dollars ($125.00), representing 25% of the total penalty. Additionally, two separate 1099’s shall be issued for the above payments. The first 1099 shall be issued to OEHHA, PO Box 4010, Sacramento, CA 95184 (EIN: 00-0000000) in the amount of $375.00. The second 1099 shall be issued in the amount of $125.00 to Xxxx Xxxxxxx be addressed to Xxxx Xxxxxxx C/O Xxxxxx X. Xxxxxxxx, Law Corporation and shall be delivered to Xxxxxx X. Xxxxxxxx, Law Corporation, 0000 X. Xxxxxxxxx, #649, Manhattan Beach, CA 90266. At ORLY's request, Xxxxxxx'x counsel shall provide ORLY with a W-9 for Xxxxxxx prior to the Effective Date.

  • Litigation and Compliance (a) There are no actions, suits, claims or proceedings, whether in equity or at law or, any Governmental investigations pending or threatened:

  • Specific Performance and Injunctive Relief Notwithstanding the availability of legal remedies, Mortgagee will be entitled to obtain specific performance, mandatory or prohibitory injunctive relief, or other equitable relief requiring Mortgagor to cure or refrain from repeating any Default.

  • Specific Performance; Injunctive Relief The parties hereto acknowledge that Parent shall be irreparably harmed and that there shall be no adequate remedy at law for a violation of any of the covenants or agreements of the Stockholder set forth herein. Therefore, it is agreed that, in addition to any other remedies that may be available to Parent upon any such violation, Parent shall have the right to enforce such covenants and agreements by specific performance, injunctive relief or by any other means available to Parent at law or in equity.

  • CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.

  • CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.

  • Payment of Non-compliance Penalties j) Subject to Clause (i) above, the Service Provider shall pay the Non-compliance Penalty indicated in the Non-compliance Penalty Certificate within 10 (ten) Business Days of Transnet issuing a valid Tax Invoice to the Service Provider for the amount set out in that certificate. If Transnet does not issue a valid Tax Invoice to the Service Provider for Non-compliance Penalties accrued during any relevant period, those Non-compliance Penalties shall be carried forward to the next period.

  • Availability of Injunctive Relief In addition to the right under the Rules to petition the court for provisional relief, Executive agrees that any party may also petition the court for injunctive relief where either party alleges or claims a violation of this Agreement or the Confidentiality Agreement or any other agreement regarding trade secrets, confidential information, nonsolicitation or Labor Code §2870. In the event either party seeks injunctive relief, the prevailing party will be entitled to recover reasonable costs and attorneys fees.

  • Compliance with Federal and State Work Authorization and Immigration Laws The Contractor and all subcontractors, suppliers and consultants must comply with all federal and state work authorization and immigration laws, and must certify compliance using the form set forth in Section 7 (“Georgia Security and Immigration Compliance Act Affidavits”). The required certificates must be filed with the Owner and copied maintained by the Contractor as of the beginning date of this contract and each subcontract, supplier contract, or consultant contract, and upon final payment to the subcontractor or consultant. State officials, including officials of the Georgia Department of Audits and Accounts, officials of the Owner, retain the right to inspect and audit the Project Site and employment records of the Contractor, subcontractors and consultants without notice during normal working hours until Final Completion, and as otherwise specified by law and by Rules and Regulations of the Georgia Department of Audits and Accounts.

  • COMPLIANCE WITH NEW YORK STATE INFORMATION SECURITY BREACH AND NOTIFICATION ACT Contractor shall comply with the provisions of the New York State Information Security Breach and Notification Act (General Business Law Section 899-aa; State Technology Law Section 208).

Time is Money Join Law Insider Premium to draft better contracts faster.