REGULATORY FILINGS AND CAISO TARIFF COMPLIANCE 3.1 Filing
Safety Boots Each employee, after 3 months’ continuous service, will be reimbursed (on production of a receipt), the cost of one pair of safety boots (approved by the employer), in each year, to a maximum of $110.00. Wet Weather All protective clothing such as wet weather jackets, safety helmets, welding jackets, welding xxxxxxx, welding gauntlets, rubber boots, etc, (which remain the property of the Company), will be supplied on all occasions deemed necessary.
Safety Data Sheets If specified by City in the solicitation or otherwise required by this Contract, Contractor must send with each shipment one (1) copy of the Safety Data Sheet (SDS) for each item shipped. Failure to comply with this procedure will be cause for immediate termination of the Contract for violation of safety procedures.
MATERIAL SAFETY DATA SHEETS Contractor is required to ensure Material Safety Data Sheets (“MSDS”) are available, employees are trained in the use of MSDS, and MSDS are in a readily accessible place at the Site. This requirement applies to all materials with an associated MSDS per the federal “Hazard Communication” standard or employees’ Right-to-Know laws. Contractor is also required to ensure proper labeling and training on any substance brought onto the Site and that any person working with the material (or who is subject to possible exposure by use of the material or contact with the material), is informed of the possible and/or real hazards of the substance, and follows proper handling and protection procedures.
Facilities for Grievances The Employer shall supply the necessary facilities for the grievance meetings.
Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.
SAFETY REGULATIONS Equipment shall meet all State and Federal safety regulations.
Field Orders B. The documents listed in Paragraph 9.01.A are attached to this Agreement (except as expressly noted otherwise above).
LAWS AND ORDINANCES In the exercise of any privilege granted by this license, licensee shall comply with all applicable federal, state, local government, and municipal laws, statutes, ordinances, rules, regulations, codes, decrees, orders and other such requirements (collectively, laws) including without limitation Laws regarding wages and hours, health, safety, building codes, emergencies, and security. Licensee shall apply, pay for, and obtain all required licenses and permits, including without limitation licenses and permits for fire and life safety requirements.
Safety Rules 5.01 The safety rules of the State having jurisdiction shall be observed by the parties hereto. It is recognized that the Employer has the exclusive responsibility for providing a safe and healthful workplace. To assist the Employer in maintaining an effective and continuing safety program, a permanent Joint Safety Committee shall be established, consisting of two (2) members from the Union and two (2) members from the Employers, who shall meet at regular times to administer educational instructions, investigate serious accidents, and to draft appropriate safety rules. Such rules as adopted by this committee, shall become a part of this Agreement.
