Bandwidth Bursting Sample Clauses

Bandwidth Bursting. Bandwidth usage levels are determined by traffic samples taken every five minutes. The five-minute samples are collected for the month and then the top 5% are eliminated. The bandwidth charge is based on the next highest remaining sample. Expedient's flexible pricing allows virtually unlimited "bursting" for up to 36 hours per month (based on 8640 samples in a typical month) without additional fees. Incremental charges for usage above Client's base bandwidth commitment will only apply if Client's usage, as defined above, exceeds Client's contracted bandwidth in more than 5% of the monthly samples. Unless stated otherwise in this Agreement, additional fees will be assessed for excess incremental bandwidth consumption in an amount equal to Client's monthly per megabit rate for the service multiplied by the overage (in increments of one megabit).
AutoNDA by SimpleDocs
Bandwidth Bursting. Customer pays an additional Charge monthly per circuit for any measured usage level greater than Customer’s Bandwidth Commitment. Verizon will sample the PIP Port usage every five minutes during the monthly billing period and Customer’s measured usage level will be based on usage at the 95th percentile of samples with the highest five percent of usage discarded for billing purposes. Incremental usage will be rounded up to the next full Mbps or Gbps.

Related to Bandwidth Bursting

  • Bandwidth the amount of data (quantified as “Mbps” or “Gbps”) made available to Customer as specified in a Service Order.

  • Connectivity User is solely responsible for providing and maintaining all necessary electronic communications with Exchange, including, wiring, computer hardware, software, communication line access, and networking devices.

  • Internet Connectivity School must provide sufficient hardline internet connectivity and the required network configurations (provided in Exhibit A) for each Pixellot System to allow live broadcasts. PlayOn will provide the point-to-point wireless internet base station (“Point to Point”) when needed to deliver hardline internet connectivity to Pixellot Systems installed in outdoor venues; provided that PlayOn is able to select the make and model of the Point to Point system. In the event that School requests, or requires, a specific Point to Point system that is different from what is provided by PlayOn, then School must provide and install the Point to Point system at its own expense.

  • Internet Connection In order to ensure the proper functioning of the Production Monitor and the Consumption Monitor, if possible, you must provide the Solar System with continuous access to a functioning broadband internet connection with one (1) wired Ethernet port and standard electrical outlet, at your cost. If you are unable to provide the Solar System with an internet connection in accordance with the foregoing sentence, the Home must be located in an area with cellular service that is acceptable to us in our discretion.

  • Network Connectivity Farmington Area Public Schools makes no guarantee that their network will be up and running 100% of the time. In the rare case that the network is down, the District will not be responsible for lost or missing data. Attribution 4*

  • Electrical connections Equipment requiring electrical connections for operation shall either be hard wired to the Authorized User's provided connections or the Contractor shall be responsible for a male electrical union. All connections shall be made by the Contractor and accomplished in accordance with National Electrical Code requirements. Electrically operated equipment shall be available in the following volts and phases: 208 volt 1 or 3 phase, 60 HZ 220 volt 1 or 3 phase, 60 HZ 440 volt 1 or 3 phase, 60 HZ

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Speed The relative importance we attach is “high”.

  • System Logging The system must maintain an automated audit trail which can 20 identify the user or system process which initiates a request for PHI COUNTY discloses to 21 CONTRACTOR or CONTRACTOR creates, receives, maintains, or transmits on behalf of COUNTY, 22 or which alters such PHI. The audit trail must be date and time stamped, must log both successful and 23 failed accesses, must be read only, and must be restricted to authorized users. If such PHI is stored in a 24 database, database logging functionality must be enabled. Audit trail data must be archived for at least 3 25 years after occurrence.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins.

Time is Money Join Law Insider Premium to draft better contracts faster.