Apprentice Mentorship Sample Clauses

Apprentice Mentorship. 22.4.1 The employer will provide two (2) formal apprentice mentors in addition to all tradespersons (who will provide an informal mentoring/coaching role). Fabrication Apprentices (both traditional and fast track Boilermaker Welders) and Mechanical Apprentices (again both traditional and fast track Mechanical Fitters) will have one (1) nominated mentor per stream.
AutoNDA by SimpleDocs

Related to Apprentice Mentorship

  • Apprentice Wages (a) Apprentices’ rates of pay are set out in Appendix B which includes the description of the calculations.

  • APPRENTICES 6.36.1 The Contractor acknowledges and agrees that, if this Contract involves a dollar amount greater than or a number of working days greater than that specified in Labor Code Section 1777.5, this Contract is governed by the provisions of Labor Code Section 1777.5. It shall be the responsibility of the Contractor to ensure compliance with this Article and with Labor Code Section 1777.5 for all apprenticeable occupations.

  • Apprentice An apprentice is an em­ ployee who is in training to become a Jour­ xxxxxx Meat Cutter. Apprentices must be at least sixteen (16) years of age. Apprentices may be employed at a ratio of not exceeding three (3) for each seven (7) Journeymen employed by the Employer within the jurisdiction of the Local. A quar­ terly report covering the number of Appren­ tices employed in relationship to the number of Journeymen shall be furnished the Union. The Employer agrees to rotate all Appren­ tices in his markets so as to give them suffi­ cient, well-rounded experience to qualify them as Journeymen at the end of the three

  • Apprenticeship 7.01 At such time, the parties agree to a training program, it is agreed to contact the California Nevada JATC to establish such program.

  • Adult Apprentices People who are 21 years of age or over at the time of entering into an apprenticeship with the Employer will be paid as per the wage rates set out in the appropriate Appendix to this Agreement. Where special or unusual circumstances occur or apply and where the parties to this Agreement and the adult apprentice agree in writing, the adult apprentice may be paid at a lesser rate, provided that the lesser rate will not be less than the rate for a junior apprentice set out in the appropriate Appendix to this Agreement.

  • Apprenticeship Program 68. The parties agree to meet to discuss the development of mutually agreeable apprenticeship programs. The specific provisions of the apprenticeship programs shall be subject to agreement between the SFMTA, the Civil Service Commission (where appropriate), and the Union. Each apprenticeship program, however, shall contain at least the following terms:

  • Employer Grievance The Employer may institute a grievance by delivering the same in writing to the President of the Local Union and the President shall answer such grievance in writing within five working (5) days. If the answer is not acceptable to the Employer, the Employer may, within ten (10) working days from the day the President gives her answer, give ten (10) working days notice to the President of the Local Union of its intention to refer the dispute to arbitration.

  • Employee Workload ‌ The Employer shall ensure that an employee’s workload is not unsafe as a result of employee absence(s). Employees may refer safety related workload concerns to the Occupational Health and Safety Committee for investigation under Article 22.3 (Occupational Health and Safety Committee).

  • EMPLOYEES OF THE CONTRACTOR All work under this contract shall be performed in a professional and skillful manner. The County may require, in writing, that the Contractor, remove from this contract any employee the County deems incompetent, careless, or otherwise objectionable.

  • Progressive Discipline Both parties endorse the principle of progressive discipline as applied to professionals.

Time is Money Join Law Insider Premium to draft better contracts faster.