Inch definition

Inch means an intermittent motion imparted to the slide (on machines using part revolution clutches) by momentary operation of the "Inch" operating means. Operation of the "Inch" operating means engages the driving clutch so that a small portion of one stroke or indefinite stroking can occur, depending upon the length of time the "Inch" operating means is held operated. "Inch" is a function used by the die setter for setup of dies and tooling, but is not intended for use during production operations by the operator.
Inch operating means shall be designed to prevent exposure of the workers hands within the point of operation by:
Inch means an intermittent mo- tion imparted to the slide (on machines using part revolution clutches) by mo- mentary operation of the Inch oper- ating means. Operation of the Inch op- erating means engages the driving clutch so that a small portion of one stroke or indefinite stroking can occur, depending upon the length of time the Inch operating means is held operated. Inch is a function used by the die setter for setup of dies and tooling, but is not intended for use during production op- erations by the operator. Occupational Safety and Health Admin., Labor § 1910.211

Examples of Inch in a sentence

  • Permit Fees for Work-Over Rigs and Special Mobile Equipment Exceeding 650 but not 670 Pounds Per Inch Width of Tire.

  • Thickness = 1 Inch L = 100 LF L= Length of Edge Key 1-3309 Edge key by Ton 01/02//2012 SPECIAL NOTE FOR ASPHALT MILLING AND TEXTURING Begin paving operations within 48 hours of commencement of the milling operation.

  • Full-Depth Doweled.Include the cost of the end dowel bars in the contract unit price “ -Inch Concrete Pavement Repair– Full-Depth Doweled”.

  • Bidders are advised to scan their documents at 100 DPI (Dots per Inch) resolutions with Black and White, PDF \ Scan properly.

  • MEASUREMENT & PAYMENT SIDEWALK RAMPS – The Department will measure Sidewalk Ramps as Sidewalk - 4 Inch Concrete in accordance with Section 505.04.

  • Bidders are advised to scan their documents at 100 DPI (Dots per Inch) resolutions with Black and White, PDF Scan properly.

  • Pumps shall be tested on Contract Area using a 5/16 inch orifice in the Forester One Inch In-Line Gauge test kit.

  • Thickness = 1 Inch L = 100 LFL= Length of Edge Key 1-3309 Edge key by Ton 01/02//2012 SPECIAL NOTE FOR ASPHALT MILLING AND TEXTURING Begin paving operations within 48 hours of commencement of the milling operation.

  • Hangers for Pipe Sizes 1/2 Inch to 1-1/2 Inches: Malleable iron, adjustable swivel, split ring.

  • Thickness = 1 Inch L = 100 LF L= Length of Edge Key 1-3309 Edge key by Ton 01/02//2012 SPECIAL NOTE FOR ASPHALT MILLING AND TEXTURING Begin paving operations within two weeks of commencement of the milling operation.

Related to Inch

  • Diameter means the diameter of the stem of a tree measured outside the bark at a specified point of measurement.

  • Width means, in relation to a lot,

  • Cubic Foot means the volume of gas which occupies one cubic foot when such gas is at a temperature of 60 degrees Fahrenheit, and at a pressure of 14.73 pounds per square inch absolute.

  • height means the vertical distance between grade and the highest point of the building or structure;

  • voltage means the root-mean-square value of electrical potential between two conductors.

  • Psig means pounds per square inch gauge.

  • Density means the permitted number of dwelling units per

  • Pipe or “Piping” means a hollow cylinder or tubular conduit that is constructed of non-earthen materials.

  • Engine degreaser means a cleaning product designed to remove grease, grime, oil and other contaminants from the external surfaces of engines and other mechanical parts.

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • Backpressure means a pressure (caused by a pump, elevated tank or piping, boiler, or other means) on the consumer's side of the service connection that is greater than the pressure provided by the public water system and which may cause backflow.

  • Pressure means the total load or force per unit area acting on a surface.

  • Pitch means a Grass Pitch or Football Turf Pitch.

  • Cubic foot of gas means the amount of gas required to fill a cubic foot of space when the gas is at an absolute pressure of fourteen and seventy-three hundredths (14.73) pounds per square inch at a temperature of sixty (60) degrees Fahrenheit.

  • Taximeter means any device for calculating the fare to be charged in respect of any journey in a hackney carriage or private hire vehicle by reference to the distance travelled or time elapsed since the start of the journey, or a combination of both; and

  • Diameter at breast height (dbh) means the diameter of a tree at 4 1/2 feet above the ground measured from the uphill side.

  • Connector means a flanged, screwed, welded, or other joined fitting used to connect two pipelines or a pipeline and a piece of process equipment.

  • Hydraulic lift tank means a tank holding hydraulic fluid for a closed-loop mechanical system that uses compressed air or hydraulic fluid to operate lifts, elevators, and other similar devices.

  • medium voltage means the set of nominal voltage levels that lie above low voltage and below high voltage in the range of 1 kV to 44 kV;

  • Uppermost aquifer means the geologic formation nearest the natural ground surface that is an aquifer, as well as lower aquifers that are hydraulically interconnected with this aquifer within the facility's property boundary.

  • Runway means a defined rectangular area on a land aerodrome prepared for the landing and take-off of aircraft;

  • flat means a separate and self-contained premises constructed or adapted for use for residential purposes and forming part of a building from some other part of which it is divided horizontally.

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • Sewage sludge weight means the weight of sewage sludge, in dry U.S. tons, including admixtures such as liming materials or bulking agents. Monitoring frequencies for sewage sludge parameters are based on the reported sludge weight generated in a calendar year (use the most recent calendar year data when the NPDES permit is up for renewal).

  • Sewage sludge fee weight means the weight of sewage sludge, in dry U.S. tons, excluding admixtures such as liming materials or bulking agents. Annual sewage sludge fees, as per section 3745.11(Y) of the Ohio Revised Code, are based on the reported sludge fee weight for the most recent calendar year.

  • Cubic Metre means the volume of gas which occupies one cubic metre when such gas is at a temperature of 15 degrees Celsius, and at a pressure of 101.325 kilopascals absolute;