Examples of Amplifier in a sentence
Rather, we hope our enumeration and organization will help formalize and ad- vance the understanding of self-adaptive system design as a whole.
Controls include: Wired Remote Control, IR Receiver, Simple Remote Control, Central Remote Controller, Wireless Remote Control, Network Converters, Group Remote Controller, Touch Panel Controller, External Switch Controller, Signal Amplifier, Fujitsu External Drain Pump, Remote Sensing Units, USB Network Interface, BAC Net Gateway and any other Fujitsu Airstage Control or Accessory Components.
Sample Calculation The field strength is calculated by adding the Antenna Factor and Cable Factor, and subtracting the Amplifier Gain (if any) from the measured reading.
UNIT – IVAnalysis and Design of Small Signal Low Frequency BJT Amplifiers: Transistor Hybrid model, Determination of h-parameters from transistor characteristics, Typical values of h- parameters in CE, CB and CC configurations, Transistor amplifying action, Analysis of CE, CC, CB Amplifiers and CE Amplifier with emitter resistance, low frequency response of BJT Amplifiers, effect of coupling and bypass capacitors on CE Amplifier.
The basic equation with a sample calculation is as follows: FS = RA + AF + CF - AGWhere FS = Field Strength in dBμV/mRA = Receiver Amplitude (including preamplifier) in dBμV CF = Cable Attenuation Factor in dBAF = Antenna Factor in dB AG = Amplifier Gain in dB In the following table(s), the reading shown on the data table reflects the preamplifier gain.
UNIT VI, TRANSISTORS: PNP and NPN junction transistor, transistor as an amplifier, single stage CE Amplifier, frequency response of CE amplifier, concepts of feedback amplifier.
The OSA is connected to a limiting Amplifier which providing post-amplification quantization, and optical signal detection.
Reflector Attack Using a DNS Server 4.1.2 Amplifier Attacks Like a reflector attack, an amplifier attack involves sending requests with a spoofed source address to an intermediate host.
Refer to the Amplifier Unit's display or Sensor Head's indicators, and adjust the Sensor Head position so that the upper and lower limits of the height (H) to be measured fall within the measuring range.
CH1 Calculating Unit CH2 Section 4 Measuring ThicknessThe calculation result is displayed on (i.e., output to) the CH2 Amplifier Unit.