Link Source Type Hour Distribution Sample Clauses

Link Source Type Hour Distribution. The national default Link Source Type Hour Distribution was obtained from a national scale MOVES run for the 2020 calendar year. Using the vehicle miles traveled (VMT) information from the ‘movesActivityOutput’ table within the output database, the Link Source Type Hour Distributions were transformed into Link Source Type Hour Distributions for intersection, arterial, and freeway scenarios. To ensure conservative results, the national default Link Source Type Hour Distributions were adjusted in two steps to reflect a higher proportion of vehicles that have higher CO emissions rates. These two adjustments are detailed below. First, gasoline vehicle types typically have higher CO emission rates compared to diesel vehicle types within MOVES. The Source Type Hour Fractions of heavy-duty trucks for the all road types were adjusted to yield higher CO emission rates. As a worst-case assumption, the Source Type Hour Fractions of short-haul and long-haul trucks were modeled as totaling 20% for all road types. 12 See xxxx://xxx.xxx.xxx/lib/46000/46500/46598/DOT-VNTSC-FHWA-12-05.pdf and xxxx://xxx.xxx.xxx/ttnchie1/conference/ei19/session6/xxxx.pdf Typically, most heavy-duty trucks will utilize diesel fuel. However, gasoline usage among heavy duty trucks produce significantly higher CO emission rates. In order to yield higher CO emission rates, and as an added worst-case assumption, all short and long-haul trucks were modeled as gasoline powered. It is also more likely that Single Unit Short-Haul and Single-Unit Long-Haul Trucks utilize gasoline than Combination Short-Haul Trucks (Gasoline Combination Long-Haul Trucks cannot be modeled in MOVES). As a further worst-case assumption, given that gasoline usage among Combination Short-Haul Trucks is extremely low and gasoline Combination Long- Haul Trucks are not modeled with MOVES, their Source Type Hour Fractions were set to zero for the all scenarios.
Sample 1
AutoNDA by SimpleDocs

Related to Link Source Type Hour Distribution

  • Single Source Selection Services for tasks in circumstances which meet the requirements of paragraph 3.10 of the Consultant Guidelines for Single Source Selection, may, with the Association's prior agreement, be procured in accordance with the provisions of paragraphs 3.9 through 3.13 of the Consultant Guidelines.

  • Unbundled Sub-Loop Distribution Intrabuilding Network Cable (USLD-INC) is the distribution facility owned or controlled by BellSouth inside a building or between buildings on the same property that is not separated by a public street or road. USLD-INC includes the facility from the cross connect device in the building equipment room up to and including the point of demarcation at the End User’s premises.

  • Unbundled Network Terminating Wire (UNTW) 2.8.3.1 UNTW is unshielded twisted copper wiring that is used to extend circuits from an intra-building network cable terminal or from a building entrance terminal to an individual End User’s point of demarcation. It is the final portion of the Loop that in multi-subscriber configurations represents the point at which the network branches out to serve individual subscribers.

  • Distribution Services The Distributor shall sell and repurchase Shares as set forth below, subject to the registration requirements of the 1933 Act and the rules and regulations thereunder, and the laws governing the sale of securities in the various states ("Blue Sky Laws"):

  • Distribution of UDP and TCP queries DNS probes will send UDP or TCP “DNS test” approximating the distribution of these queries.

  • Unbundled Channelization (Multiplexing) 5.7.1 To the extent NewPhone is purchasing DS1 or DS3 or STS-1 Dedicated Transport pursuant to this Agreement, Unbundled Channelization (UC) provides the optional multiplexing capability that will allow a DS1 (1.544 Mbps) or DS3 (44.736 Mbps) or STS-1 (51.84 Mbps) Network Elements to be multiplexed or channelized at a BellSouth central office. Channelization can be accomplished through the use of a multiplexer or a digital cross-connect system at the discretion of BellSouth. Once UC has been installed, NewPhone may request channel activation on a channelized facility and BellSouth shall connect the requested facilities via COCIs. The COCI must be compatible with the lower capacity facility and ordered with the lower capacity facility. This service is available as defined in NECA 4.

  • Directory Listing and Directory Distribution 41 5. Voice Information Service Traffic 43 6. Intercept and Referral Announcements 44 7. Originating Line Number Screening (OLNS) 44 8. Operations Support Systems (OSS) Services 44 9. Poles, Ducts, Conduits and Xxxxxx-xx-Xxx 00 00. Telephone Numbers 51 11. Routing for Operator Services and Directory Assistance Traffic 51 12. Unauthorized Carrier Change Charges 52 13. Good Faith Performance 52 INTERCONNECTION ATTACHMENT. 53 1. General 53 2. Points of Interconnection and Trunk Types 53 3. Alternative Interconnection Arrangements 57 4. Initiating Interconnection 58 5. Transmission and Routing of Telephone Exchange Service Traffic 59

  • Distribution Protocol (1) At a time wholly within the discretion of Class Counsel, but on notice to the Settling Defendants, Class Counsel will bring motions seeking orders from the Courts approving the Distribution Protocol. The motions can be brought before the Effective Date, but the orders approving the Distribution Protocol shall be conditional on the Effective Date occurring.

  • Unbundled Network Element Combinations 4.1 For purposes of this Section, references to “Currently Combined” Network Elements shall mean that the particular Network Elements requested by NewPhone are in fact already combined by BellSouth in the BellSouth network. References to “

  • Provider Network The Panel of health service Providers with which the Contractor contracts for the provision of covered services to Members and Out-of-network Providers administering services to Members.

Time is Money Join Law Insider Premium to draft better contracts faster.