Fuel Starvation Sample Clauses

Fuel Starvation. The best results for simulating fuel starvation have been obtained with constant gas supply and with a current density of 200 mA/cm2 at the low setting (400 mA/cm2 at high setting) at constant gas flows according to a stoichiometry of 1.5 for hydrogen and 3 for air in the recovery interval. The starvation interval is performed by increasing the current load to 333 mA/cm2 and 666 mA/cm2 respectively, resulting in a hydrogen stoichiometry of 0.9. The conditions for this AST protocol are shown in Table 9 & Table 10. Table 9 Overview of the constant gas conditions before and during execution of the Fuel Starvation AST protocol. Input Anode Cathode Anode stoichiometry 0.9 for 10 seconds (fuel starvation) then 1.5 for 3 min (recovery) Gas supply Hydrogen Air Backpressure 0.4 bar (1.4 bar total pressure) Ambient (no backpressure) Table 10 Overview of variable operating conditions before and during execution of the Fuel Starvation AST protocol. Variables Low setting High setting Relative humidity, cathode & anode 40% 80% Cell temperature 65°C 85°C Current Density 200 mA/cm2 400 mA/cm2
AutoNDA by SimpleDocs

Related to Fuel Starvation

  • FABRICATION Making up data or results and recording or reporting them.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins.

  • Fuel 28.1 The Vehicle must be returned with the amount of fuel equal to that at the time of the commencement of the rental. If the Vehicle is returned with less fuel, the difference will be charged to You at a rate of $5.00 including GST per litre (which includes a service component).

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Dewatering 4.7.1 Where a part of a site is affected by surface water following a period of rain, thus rendering some areas unsafe for productive work, consistent with the Employer’s obligations under the OH&S Act, all non- trades employees shall assist in ‘dewatering’ their own work site or area if it is so affected. Such work to be paid at single time rates. Productive work will continue in areas not so affected.

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Building Commissioning Services The Owner may provide as a part of its testing services the Building Commissioning services involving the project’s HVAC and exhaust systems, temperature control systems, fire detection and alarm systems, emergency power and lighting system, fire suppression system, security locks and security locking control systems, food service equipment (if applicable), and laundry equipment (if applicable). In the event the Using Agency’s Program specifies additional commissioning services, the Owner shall procure such services as well. The Owner, through its Executive Administrator, may engage an independent Commissioning Authority. It is the intent of this Article that the Commissioning Authority enforce the requirements mentioned herein and certify that the systems and equipment listed all function properly prior to the initiation of each final inspection.

  • Interconnection 2.1.10 Startup Testing and Commissioning

  • SS7 Network Interconnection 9.7.1 SS7 Network Interconnection is the interconnection of Global Connection local signaling transfer point switches or Global Connection local or tandem switching systems with BellSouth signaling transfer point switches. This interconnection provides connectivity that enables the exchange of SS7 messages among BellSouth switching systems and databases, Global Connection local or tandem switching systems, and other third-party switching systems directly connected to the XxxxXxxxx XX0 network.

  • Outdoor Lighting 3.8.1 Lighting shall be directed to driveways, parking areas, loading area, building entrances and walkways and shall be arranged so as to divert the light away from streets, adjacent lots and buildings.

Time is Money Join Law Insider Premium to draft better contracts faster.