Triple Test definition

Triple Test means a sum equal to the lessor of (i) 10% of the original principal proceeds of the bonds of any particular issue, (ii) the highest combined principal and interest requirements for any succeeding fiscal year on such bonds, or (iii) 125% of the average amount of principal installments and interest becoming due in any fiscal year on such bonds.
Sample 1Sample 2

Examples of Triple Test in a sentence

  • Triple Test plus Rapid Cognitive Screening Test: a combination of clinical signs and a tool for cognitive assessment in older adults.

  • To start a cervical test, highlight Cervical Spine Glasses from the list of available tests and click Single Test or Triple Test, in the lower right corner.

  • Mid-Trimester Triple Test Levels In Early And Late Onset Sever Pre-eclampsia.

  • Benn, "Utilization of Amniocentesis by Women Screening Positive for Down Syndrome on the Second-Trimester Triple Test," Community Genetics, 3 (2000), 24-30.Heffley, D., and T.

  • Because of this delay, men present with the disease at a later stage than women:Stage I - ~40% Stage II - ~20%Stage III/IV - Over 40%When symptoms are present, doctors generally use the Triple Test (TT) method to determine stage and treatment plan.

  • Children’s Appendicitis Triple Test: White cell count (>10), Neutrophil percentage (>75%), C Reactive Protein (>7).

  • Fifty patients underwent Triple Test Score (physical examination, mammography and fine needle aspiration cytology) and were categorized into benign, suspicious and malignant.

  • The combined results of two factors among three components were used to determine whether the Triple Test was benign or malignant8.

  • The Triple Test Cross (TTC) design proposed by Kearsey and Jinks (1968), which is a modification of the “North Carolina III” design, has been widely used because it allows an accurate detection of the presence of epistasis, regardless of the allele frequency, inbreeding level and occurrence of linkage disequilibrium in the population.

  • In recent decades, there are a numerous articles about successful development of salinity tolerance in plants by classical breeding, including Landrace assessment and screening (Roy and Sengupta, 2014; Sadat Noori, 2005; Sadat Noori and McNeilly, 1999), Transgressive Segregation (Shahbaz and Ashraf, 2013; Sadat Noori and Harati, 2005), Triple Test Cross (Sadat Noori and Sokhansanj, 2004) and even artificial neural network (Sadat Noori et al., 2011a), although these methods are full of difficulties.

Related to Triple Test

  • Performance Test means all operational checks and tests required to determine the performance parameters including inter-alia capacity, efficiency and operating characteristics of the Stores as specified in the Contract.

  • EPP test Means one EPP command sent to a particular “IP address” for one of the EPP servers. Query and transform commands, with the exception of “create”, shall be about existing objects in the Registry System. The response shall include appropriate data from the Registry System. The possible results to an EPP test are: a number in milliseconds corresponding to the “EPP command RTT” or undefined/unanswered.

  • Asset Test means, for an Asset Review, each Test, as defined in the Asset Representations Review Agreement, in Schedule A to the Asset Representations Review Agreement to be performed by the Asset Representations Reviewer on the related Asset Review Receivables.

  • Incurrence Test means the incurrence test set out in Clause 12.1 (Incurrence Test).

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • Performance Tests means the tests to be conducted on the equipment at site for checking the performance parameters of the equipment as defined in Technical Specification.

  • Commissioning test means tests applied to the Generating Facility, after completion of the construction of the Generating Facility, in order to verify that the Generating Facility may be released for Operation.

  • Acceptance Test is a test of the Features executed by the Customer to prepare the acceptance.

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • Fit test means the use of a protocol to qualitatively or quantitatively evaluate the fit of a respirator on an individual.

  • Maintenance Test means the maintenance test set out in Clause 12.1 (Maintenance Test).

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Start-Up Testing means the completion of applicable required factory and start-up tests as set forth in Exhibit C.

  • Acceptance Testing mean the tests, reviews and other activities that are performed by or on behalf of Agency to determine whether the Deliverables meet the Acceptance Criteria or otherwise satisfy the Agency, as determined by the Agency in its sole discretion.

  • Class C Par Value Test means the test which will be satisfied as of any Measurement Date if, on such Measurement Date, the Class C Par Value Ratio is at least equal to the percentage specified in the definition of "Coverage Test".

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • Drug use test means a scientifically substantiated method to test for the presence of illegal or performance-enhancing drugs or the metabolites thereof in a person’s urine.

  • Operational Acceptance Tests means the tests specified in the Technical Requirements and Agreed Project Plan to be carried out to ascertain whether the System, or a specified Sub system, is able to attain the functional and performance requirements specified in the Technical Requirements and Agreed Project Plan, in accordance with the provisions of GCC Clause 27.2 (Operational Acceptance Test).

  • Screening Test means a drug or alcohol test which uses a method of analysis allowed by the Minnesota Drug and Alcohol Testing in the Workplace Act to be used for such purposes.

  • Performance and Guarantee Test means all operational checks and tests required to determine and demonstrate capacity, efficiency and operating characteristics as specified in the Contract Documents.

  • Penetration Testing means security testing in which assessors mimic real-world attacks to identify methods for circumventing the security features of an application, system, or network. (NIST SP 800-115)

  • Coverage Test means each of the Class A/B Par Value Test, the Class A/B Interest Coverage Test, the Class C Par Value Test, the Class C Interest Coverage Test, the Class D Par Value Test, the Class D Interest Coverage Test, the Class E Par Value Test and the Class E Interest Coverage Test.

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • Class D Par Value Test means the test which will be satisfied as of any Measurement Date if, on such Measurement Date, the Class D Par Value Ratio is at least equal to the percentage specified in the definition of "Coverage Test".

  • Cannabis testing facility means an entity registered by

  • Acceptance Tests means those tests performed during the Performance Period which are intended to determine compliance of Equipment and Software with the specifications and all other Attachments incorporated herein by reference and to determine the reliability of the Equipment.