Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Compensation and Payment Terms A. Subject to the satisfactory performance of the services required of Contractor pursuant to this Agreement, and to the terms and conditions set forth in this Agreement, and following Contractor’s submission of an appropriate claim, and such other documentation that the County may require, County shall pay Contractor according to the terms set forth in Exhibit C, Terms of Payment. Contractor agrees to accept the foregoing payments as full and complete payment for all services provided pursuant to this Agreement, irrespective of whether the cost of such services and related administrative expenses exceed such payments.
Rates and Payments Room and board fees are approved by the Board of Trustees during the spring semester for the following academic year; however, the University reserves the right to make adjustments as deemed necessary and appropriate in the sole discretion of the Vice President for Student Affairs or designee, at any time during the term of this agreement in accordance with Section 11.
Rates and Payment You agree to pay the residence fees which are outlined in Appendix IV and Residence Meal Plan fees (if applicable) which are outlined in Appendix IV. You may either pay the entire amount due or pay the residence fees and Residence Meal Plan fees in instalments, in the amounts and on the dates outlined in Appendix IV. If you choose to, or are required to, change your accommodation you will be required to pay the fees stipulated for the new accommodation, including the Residence Meal Plan, if applicable. • Failure to pay the first instalment of residence fees by or on the date it is due will lead to forfeiture of your accommodation assignment. Charges for residence fees and residence meal plan fees will continue until you complete the contract termination and check-out process in section 1.14. See Section 4.0 of this Contract for Residence Meal Plan information. Please note that the following terms apply to all fees and payments required by Student Housing and Hospitality Services (i.e. residence fees, Residence Meal Plan, activities/programs, assessments, et cetera): • Post-dated cheques will not be accepted. • A $35 service charge will be levied on all cheques returned by your financial institution for any reason. • You will pay all fees that may be imposed by the University from time to time in respect of failed electronic financial transactions, including, without limitation, electronic funds transfers and Interac transactions where, after initial processing, the transaction is cancelled or voided due to insufficient funds. • Late payments may not be accepted. If a late payment is accepted, it will be subject to a late payment fees as follows: » first late payment - $25 » second late payment - $35 » third late payment - $50 » fourth and any subsequent late payments - $75
Determination of One-Month LIBOR Pursuant to the terms of the Global Agency Agreement, the Global Agent shall calculate the Class Coupons for the applicable Classes of Notes (including MAC Notes on which the Exchange Administrator has directed the Global Agent to make payments) for each Accrual Period (after the first Accrual Period) on the applicable LIBOR Adjustment Date. “One-Month LIBOR” will be determined by using the “Interest Settlement Rate” for U.S. dollar deposits with a maturity of one month set by ICE Benchmark Administration Limited (“ICE”) as of 11:00 a.m. (London time) on the LIBOR Adjustment Date (the “ICE Method”). ICE’s Interest Settlement Rates are currently displayed on Bloomberg L.P.’s page “BBAM.” That page, or any other page that may replace page BBAM on that service or any other service that ICE nominates as the information vendor to display the ICE’s Interest Settlement Rates for deposits in U.S. dollars, is a “Designated Page.” ICE’s Interest Settlement Rates currently are rounded to five decimal places. If ICE’s Interest Settlement Rate does not appear on the Designated Page as of 11:00 a.m. (London time) on a LIBOR Adjustment Date, or if the Designated Page is not then available, One-Month LIBOR for that date will be the most recently published Interest Settlement Rate. If ICE no longer sets an Interest Settlement Rate, Freddie Mac will designate an alternative index that has performed, or that Freddie Mac (or its agent) expects to perform, in a manner substantially similar to ICE’s Interest Settlement Rate.
MEASUREMENT AND PAYMENT Temporary traffic control work, including, but not limited to installation and removal of portable signs, cones, drums, skinny drums, flaggers, AFAD’s, changeable message boards, truck mounted attenuators, flashing arrow boards, and pilot vehicles will be paid at the contract lump sum price for
Compensation and Payment 3.1 Contractor’s fees shall be calculated at the rates set forth in the attached Exhibit
