°C definition

°C means degrees Celsius;
Sample 1Sample 2Sample 3
°C means DEGC Enterprises (U.S.), Inc., a Florida corporation and subsidiary of Chronic Care Solutions.
Sample 1Sample 2Sample 3
°C means degree(s) Celsius.
Sample 1Sample 2

Examples of °C in a sentence

  • Type: A (against organic gases and va- pours with a boiling point of > 65 °C , colour code: Brown).‌Environmental exposure controlsKeep away from drains, surface and ground water.

  • This entry does not apply to substances that are gases at temperature of 20 °C and pressure of 101,3 kPa, or gener- ate a vapour pressure of more than 300 kPa at temperature of 50 °C, with the exception of formaldehyde (CAS No 50- 00-0, EC No 200-001-8).10.

  • If warm mix asphalt (WMA) technology is utilized and production temperatures do not exceed 275 °F (135 °C), the high and low virgin asphalt binder grades shall each be reduced by one grade when RAP/RAS ABR exceeds 25 percent (i.e. 26 percent RAP/RAS ABR would require a virgin asphalt binder grade of PG 64-22 to be reduced to a PG 58-28).

  • Materials that will not burn in air when exposed to a temperature of 820 °C (1,500 °F) for a period of 5 minutes.(e.g. Carbon tetrachloride)REACT 0 Normally stable, even under fire exposure conditions, and is not reactive with water (e.g. helium,N2) SPEC.

  • If warm mix asphalt (WMA) technology is utilized and production temperatures do not exceed 275 °F (135 °C), the high and low virgin asphalt binder grades shall each be reduced by one grade when FRAP/RAS ABR exceeds 25 percent (i.e. 26 percent ABR would require a virgin asphalt binder grade of PG 64-22 to be reduced to a PG 58-28).

  • The specified temperature for the Elastic Recovery test for all polymer modified emulsions shall be 50.0 ± 1.0 °F (10.0 ± 0.5 °C).

  • The distillation for all polymer modified emulsions shall be performed according to AASHTO T 59, except the temperature shall be 374 ± 9 °F (190 ± 5 °C) to be held for a period of 15 minutes and measured using an ASTM 16F (16C) thermometer.

  • TestResultViscosity, Saybolt Furol, at 77 °F (25 °C), SFS75 max.Sieve test, retained on No. 20 (850 µm) sieve, %0.10 max.Distillation to 500 °F (260 °C) residue, %38 min.Oil distillate by volume, %4 max.

  • TestHFE-90HFE-150HFE-300Viscosity, Saybolt Furol, at 122 °F (50 °C), (AASHTO T 59), SFS 1/ 50 min.

  • Store in a dry place.‌Incompatible substances or mixturesObserve hints for combined storage.Consideration of other advice• Ventilation requirementsUse local and general ventilation.• Specific designs for storage rooms or vesselsRecommended storage temperature: 15 – 25 °C.


More Definitions of °C

°C means degrees Centigrade and 0 °C = 273.15 K
Sample 1Sample 2
°C means degree Celsius (centigrade).
Sample 1Sample 2
°C means degree celsius. “μm” means micrometre. “Al” means aluminium. “Au” means gold.
Sample 1
°C means degrees Celsius (centigrade).
Sample 1
°C means degrees Celsius. "cfm" means cubic feet per minute.
Sample 1
°C means units of temperature measurement in degrees Celsius. “Act” means the District Cooling Act (Cap. 84A).
Sample 1Sample 2

Related to °C

  • Altitude means the vertical distance of a level, a point or an object considered as a point, measured from mean sea level (MSL);

  • Psig means pounds per square inch gauge.

  • Diameter means the diameter of the stem of a tree measured outside the bark at a specified point of measurement.

  • Tare Weight means the weight of an empty shipping container, excluding all materials used for wrapping, cushioning, banding, waterproofing, packaging, blocking and bracing articles within the exterior container.

  • Backpressure means a pressure (caused by a pump, elevated tank or piping, boiler, or other means) on the consumer's side of the service connection that is greater than the pressure provided by the public water system and which may cause backflow.

  • Runway means a defined rectangular area on a land aerodrome prepared for the landing and take-off of aircraft;

  • Opaque means impenetrable to sight.

  • Cubic Foot means a volume of Gas occupying a space of one cubic foot at a temperature of 60°F and at the applicable Base Pressure.

  • Cubic foot of gas means the amount of gas required to fill a cubic foot of space when the gas is at an absolute pressure of fourteen and seventy-three hundredths (14.73) pounds per square inch at a temperature of sixty (60) degrees Fahrenheit.

  • Lightweight means the displacement of a ship in metric tons without cargo, fuel, lubricating oil, ballast water, fresh water and feed water in tanks, consumable stores, and passengers and crew and their effects.

  • Pressure means the total load or force per unit area acting on a surface.

  • POTS means plain old telephone service. "Power Spectral Density (PSD) Masks" are graphical templates that define the limits on signal power densities across a range of frequencies to permit divergent technologies to coexist in close proximity within the same Binder Groups.

  • Solids means the nonvolatile portion of the coating that after drying makes up the dry film.

  • Density means the permitted number of dwelling units per

  • HDPE means high density polyethylene;

  • Psia means pounds per square inch absolute.

  • Flashpoint means the minimum temperature at which a liquid gives off a vapor in sufficient concentration to ignite when tested as follows:

  • Coefficient means a number that represents the quantified relationship of each variable to the assessed value of a property when derived through a mass appraisal process

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • EMF means the Environmental Management Framework, dated November 16, 2005, outlining the procedures for the environmental screening, management, consultation and disclosure related to the selection of the road sections under the Project.

  • Valve means a device used to control the flow of water in the irrigation system.

  • Cold Weather Alert means the notice that PJM provides to PJM Members, Transmission Owners, resource owners and operators, customers, and regulators to prepare personnel and facilities for expected extreme cold weather conditions.

  • Deadweight (DW) means the difference in metric tons between the displacement of a ship in water of a specify gravity of 1.025 at the load waterline corresponding to the assigned summer freeboard and the lightweight of the ship.

  • GATS means the General Agreement on Trade in Services, contained in Annex 1B to the WTO Agreement;

  • Nitrogen oxides means nitric oxide and nitrogen dioxide, expressed as nitrogen dioxide (NO2);

  • Positive pressure respirator means a respirator in which the pressure inside the respiratory inlet covering exceeds the ambient air pressure outside the respirator.