THERMAL WALL INSULATION Sample Clauses

THERMAL WALL INSULATION. Furnish and install R-11 (or as required by the energy compliance calculation) unfaced fiberglass batt insulation from floor to roof in walls between conditioned and unconditioned spaces or from floor to ceiling if xxxxx are installed horizontally on top of the acoustic ceiling. Furnish and install R-11 at all furred exterior concrete walls. Insulate all tenant demising walls to 10'-0" A.F.F. a minimum run of 60' or 20' beyond office area, whichever is greater, with R-11 fiberglass insulation.
AutoNDA by SimpleDocs

Related to THERMAL WALL INSULATION

  • Floor Loading Floor loading capacity shall be within building design capacity. Tenant may exceed floor loading capacity with Landlord’s consent, at Landlord’s sole discretion and must, at Tenant’s sole cost and expense, reinforce the floor as required for such excess loading.

  • Floor Load Tenant shall not place a load upon any floor of the Premises that exceeds 50 pounds per square foot “live load”. Landlord reserves the right to reasonably designate the position of all Equipment which Tenant wishes to place within the Premises, and to place limitations on the weight thereof.

  • Waste Borrower shall not commit or suffer any waste of the Property or make any change in the use of the Property which will in any way materially increase the risk of fire or other hazard arising out of the operation of the Property, or take any action that might invalidate or give cause for cancellation of any Policy, or do or permit to be done thereon anything that may in any way impair the value of the Property or the security of this Security Instrument. Borrower will not, without the prior written consent of Lender, permit any drilling or exploration for or extraction, removal, or production of any minerals from the surface or the subsurface of the Land, regardless of the depth thereof or the method of mining or extraction thereof.

  • Electrical During the Term of this Lease, there shall be available to the Leased Premises electrical facilities comparable to those supplied in other comparable office buildings in the vicinity of the Building to provide sufficient power for normal lighting and office machines of similar low electrical consumption, and one personal computer for each desk station, but not for any additional computers or extraordinary data processing equipment, special lighting and any other item of electrical equipment which requires a voltage other than one hundred ten (110) volts single phase and is not typically found in an office, as determined by Landlord in its sole, but reasonable discretion; and provided, however, that if the installation of such electrical equipment requires additional air conditioning capacity above that normally provided to tenants of the Building or above standard usage of existing capacity as determined by Landlord in its sole, but reasonable discretion, then the additional air conditioning installation and/or operating costs attributable thereto shall be paid by Tenant. Tenant agrees not to use any apparatus or device in, upon or about the Leased Premises which may in any way increase the amount of such electricity usually furnished or supplied to the Leased Premises, and Tenant further agrees not to connect any apparatus or device to the wires, conduits or pipes or other means by which such electricity is supplied, for the purpose of using additional or unusual amounts of electricity, without the prior written consent of Landlord. At all times, Tenant’s use of electric current shall never exceed Tenant’s share of the capacity of the feeders to the Building or the risers or wiring installation. Tenant shall not install or use or permit the installation or use in the Leased Premises of any computer or electronic data processing or ancillary equipment or any other electrical apparatus designed to operate on electrical current in excess of 110 volts and 5 amps per machine, without the prior written consent of Landlord, which consent shall not be unreasonably withheld, conditioned or delayed. If Tenant shall require electrical current in excess of that usually furnished or supplied for use of the Leased Premises as general office space, Tenant shall first procure the written consent of Landlord (which consent shall not be unreasonably withheld, conditioned or delayed) to the use thereof and Landlord or Tenant may (i) cause a meter to be installed in or for the Leased Premises, or (ii) if Tenant elects not to install said meter, Landlord may reasonably estimate such excess electrical current. The cost of any meters (including, without limitation, the cost of any installation) or surveys to estimate such excess electrical current shall be paid by Tenant. Landlord’s approval of any space plan, floor plan, construction plans, specifications, or other drawings or materials regarding the construction of the Tenant Improvements or any alterations shall not be deemed or construed as consent by Landlord under this paragraph to Tenant’s use of such excess electrical current as provided above. Tenant agrees to pay to Landlord, promptly upon demand therefor, all costs of such excess electrical current consumed as calculated by said meters (at the rates charged for such services to the Building by the municipality or the local public utility) or the excess amount specified in said estimate, as the case may be, plus any additional expense incurred in keeping account of the electrical current so consumed, which additional expense Landlord shall advise Tenant within a reasonable time after request by Tenant.

  • Asbestos Mortgagor shall not install nor permit to be installed in the Mortgaged Property asbestos or any asbestos-containing material (collectively, "ACM") except in compliance with any and all applicable present and future Environmental Laws respecting ACM. With respect to any ACM (including friable or non-friable asbestos or asbestos-containing materials regulated under any Environmental Law) discovered to be present in the Mortgaged Property at any time during the operation of this Mortgage, Mortgagor shall comply in all material respects with any and all applicable present and future Environmental Laws, all at Mortgagor's sole cost and expense Upon the occurrence and during the continuation of an Event of Default, Mortgagee may, but shall not be obligated to, in addition to any other remedies set forth herein, take, in substantial compliance with any applicable present and future Environmental Laws, whatever steps it deems reasonably necessary or appropriate to comply with any and all applicable present and future Environmental Laws. Any costs or expenses reasonably incurred by Mortgagee for such purpose shall be due within ten (10) days after demand and payable by Mortgagor and shall bear interest at the Default Rate. Mortgagor shall provide to Mortgagee and its agents and employees reasonable access to the Mortgaged Property and hereby specifically grants to Mortgagee a license to remove or encapsulate such ACM in substantial compliance with any applicable present and future Environmental Law if Mortgagor fails to do so and removal or encapsulation is required under any applicable present and future Environmental Law; provided, however, that nothing contained herein shall obligate Mortgagee to exercise any rights under such license. Mortgagor shall indemnify and hold Mortgagee harmless from and against all loss, cost, damage and expense (including, without limitation, reasonable attorneys' and consultants' fees) that Mortgagee may sustain as a result of the presence of any ACM and any removal or encapsulation thereof or compliance with any and all applicable present and future Environmental Laws other than such loss, cost, damage or expense, if any, to the extent it is caused solely by the gross negligence or willful misconduct of Mortgagee or its agents, contractors and subcontractors in performing any act or exercising its remedies under this Mortgage.

  • Spares/bunkers, etc The Sellers shall deliver the Vessel to the Buyers with everything belonging to her on board and on shore. All spare parts and spare equipment including spare tail-end shaft(s) and/or spare propeller(s)/propeller blade(s), if any, belonging to the Vessel at the time of inspection used or unused, whether on board or not shall become the Buyers' property, but spares on order are to be excluded. Forwarding charges, if any, shall be for the Buyers' account. The Sellers are not required to replace spare parts including spare tail-end shaft(s) and spare propeller(s)/propeller blade(s) which are taken out of spare and used as replacement prior to delivery, but the replaced items shall be the property of the Buyers. The radio installation and navigational equipment shall be included in the sale without extra payment if they are the property of the Sellers. Unused stores and provisions shall be included in the sale and be taken over by the Buyers without extra payment. The Sellers have the right to take ashore crockery, plates, cutlery, linen and other articles bearing the Sellers' flag or name, provided they replace same with similar unmarked items. Library, forms, etc., exclusively for use in the Sellers' vessel(s), shall be excluded without compensation. Captain's, Officers' and Crew's personal belongings including the slop chest are to be excluded from the sale, as well as the following additional items (including items on hire): Please see Clause 19 The Buyers bunkers are the Charterers property and are to be excluded from the sale. The shall take over the remaining bunkers and unused lubricating oils in storage tanks and sealed drums shall remain the property of the sellers. Vessel’s new managers will pay sellers for these lubricating oils at net contract price as and when they are broached and pay the current net market price (excluding barging expenses) at the port and date of delivery of the Vessel. Payment under this Clause shall be made at the same time and place and in the same currency as the Purchase Price.

  • Boiler and Machinery Insurance Broad form boiler and machinery insurance (without exclusion for explosion) covering all boilers or other pressure vessels, machinery, and equipment located in, on or about the Property and insurance against loss of occupancy or use arising from any breakdown in such amounts as are generally required by institutional lenders for properties comparable to the Property;

  • Lighting Landlord will furnish both Building Standard and non-Building Standard lamps, bulbs, ballasts and starters that are part of the Leasehold Improvements for purchase by Tenant at Landlord's cost, plus Landlord's standard administration fee. Landlord will install non-Building Standard items at Landlord's scheduled rate for this service.

  • GLASS The Tenant shall maintain the glass part of the demised premises, promptly replacing any breakage and fully saving the Landlord harmless from any loss, cost or damage resulting from such breakage or the replacement thereof.

  • Electrical Service Subject to the limitation of this Paragraph 4, furnish electrical service to the Premises, including providing and installing all Building standard replacement lighting tubes. If Tenant uses more electrical power than Landlord in good faith considers reasonable or normal for office use, Tenant will pay Landlord on a monthly basis the cost of such excess power consumed by Tenant. Consumption will be determined, at Landlord’s election, either (a) by a survey performed by a reputable consultant selected by Landlord, or (b) through separate meters or submeters installed, maintained and read by Landlord at Tenant’s cost. For purposes of this Paragraph 4 only, “month” and “monthly” shall mean any billing period used by the utility or other power provider supplying electricity. All installations of electrical futures, appliances and equipment within the Premises shall be subject to Landlord’s prior approval, and if they affect the temperature or humidity otherwise maintained, Landlord may, at Tenant’s sole cost and expense (to be paid within (30) days after delivery of written demand supported by invoices or other reasonably satisfactory evidence), install supplemental air conditioning units. Tenant’s use of electricity shall never exceed Tenant’s share of the capacity of existing feeders to the Building or of the risers, wiring installations and transformers serving the floor(s) containing the Premises. Landlord shall provide up to 3.5 xxxxx per usable square foot (demand) of riser and floor panel electrical capacity averaged over the floor being serviced. EXHIBIT C Tenant shall be allocated an approximate 2.0 xxxxx per usable square foot for power and 1.5 xxxxx per usable square foot for lighting. Any risers or wiring necessary to meet Tenant’s excess electrical requirements will be installed by Landlord on Tenant’s request, at Tenant’s sole cost and expense (to be paid in advance), but only if in Landlord’s reasonable good faith belief they are necessary and will not cause damage to the Building or a dangerous condition, entail excessive or unreasonable alterations, repairs or expense, or disturb other occupants.

Time is Money Join Law Insider Premium to draft better contracts faster.