PHASE CONDITIONS Sample Clauses

PHASE CONDITIONS. 7.1 Other than Clauses 1-17 (inclusive), 20, 26-34 (inclusive) 36-55 (inclusive) and 57 and 58 and the related Schedules, the obligations contained in this Agreement in relation to each Phase are conditional upon the satisfaction of the Phase Conditions in respect of the relevant Phase on or before the determination of this Agreement.
Sample 1Sample 2
AutoNDA by SimpleDocs
PHASE CONDITIONS. 37.3.1 Without prejudice to any other right or ability to terminate this Agreement, if a Phase Unconditional Date has not occurred on or before the relevant Phase Condition Longstop Date and/or Phase Condition Drop Dead Date (subject to Clause 37.3.3) then either the Council or the Partner may determine this Agreement in relation only to the Phase for which the Phase Unconditional Date has not occurred at any time after the relevant Phase Condition Longstop Date and/or Phase Condition Drop Dead Date by serving written notice to that effect on the other PROVIDED THAT a party may only terminate as aforesaid where there are no outstanding material breaches of its obligations in relation to all outstanding Phase Conditions relating to that Phase.
Sample 1Sample 2

Related to PHASE CONDITIONS

  • Release Conditions As used in this Agreement, "Release Conditions" shall mean the following:

  • PROJECT CONDITIONS A. The Grantee agrees to the following Project Conditions:

  • Site Conditions A. Existing Site Conditions: Information with respect to the site of the Work given in drawings or specifications has been obtained by County's representatives and is believed to be reasonably correct, but the County does not warrant either the completeness or accuracy of such information, and it is the responsibility of the Contractor to verify all such information.

  • License Conditions Your exercise of the Licensed Rights is expressly made subject to the following conditions.

  • Space Conditions All pipes passing through floors, walls, and ceilings shall be installed with sufficient space between them to permit installation of pipe insulation and floor, wall, and ceiling plates without cutting of insulation or plates. Roughed-in dimensions shall be prepared by the Contractor to accomplish this requirement. The Contractor shall locate all equipment that must be serviced, operated, or maintained in fully accessible positions. This provision includes but is not limited to valves, traps, cleanouts, motors, controllers, switchgear, drain points, filter, access doors, and fire dampers. If spaces, dimensions, or other design conditions do not permit compliance with the present article, the Contractor shall file a request in writing with the Design Professional for additional instructions, furnishing a copy to the Owner.

  • Contract Conditions This section contains conditions which shall be complied with during the performance of this contract. The conditions come in two parts, general conditions and special contract requirements.

  • Safe Conditions Whenever an employee reports a condition which the employee feels represents a violation of safety or health rules and regulations or which is an unreasonable hazard to persons or property, such conditions shall be promptly investigated. The appropriate administrator shall reply to the concern, in writing, if the employee's concern is communicated in writing.

  • BASIC CONDITIONS The State shall have no obligation to disburse money for the Project under this Grant Agreement until the Grantee has satisfied the following conditions:

  • Subsurface Conditions Unless the Contract Documents stipulate specific quantities and units of rock or unsuitable soils, the Contractor shall assume material below the surface of the Earth to be earth and other material that can be removed by power shovel or similar equipment. Should conditions encountered below the surface of the ground be at variance to the number of unit requirements as indicated by drawings or specifications, and absent an agreed-upon unit price established prior to the bid by Addendum, or after contract execution by Change Order, the Contract Sum and/or time shall be adjusted as provided in the Contract Documents for changes in the work.

  • Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.

Time is Money Join Law Insider Premium to draft better contracts faster.